Question about 1999 GMC Sierra

1 Answer

I drained all my transmission fluid accidentaly

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Do you know where about it came from the drain plug? it will take around 4-4.5L of dexron/mercon oil

Posted on Dec 16, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda 1999 B3000 what specifically needs to be replaced when transmission fluid get into the radiator?


The radiator must have an internal leak between the coolant and the reservoir for cooling the transmission fluid. Replace the radiator, drain and flush the engine and heater core, and drain and replace the transmission filter. You will need to remove the lower transmission pan, let it drain out (about 6 quarts), then replace the filter that is there, just underneath the pan. If you see any evidence of coolant in the transmission fluid, put it back together, run the vehicle for a bit-till the engine has warmed up, a short drive should do-then shut it off and drain the transmission fluid again.

When the transmission is drained this way, not all the transmission fluid will be drained-about half will still be in there, mostly in the torque converter. So if the fluid is contaminated, you need to drain and refill at least twice.

Aug 24, 2014 | Cars & Trucks

1 Answer

I accidentaly drained all of my transmission fluid


3/to five litres or till it seeps out of transmit ion plug where filling

Nov 21, 2013 | 1999 GMC Sierra

1 Answer

Where is transmission filter located in 2001 mitsubishi diamante located and how do i change it?


transmission filter in the bottom of transmission bolted to valve body.you need a large drain pan.place drain plug under transmission oil pan.remove transmission oil pan drain plug.let all transmission fluid drain out then screw back drain plug in oil pan.then you need to remove transmission oil pan then remove filter and replace pan gasket also.make sure you have right amount transmission fluid on hand.buy extra because if you short of fluid you cant drive car if fluid level too low.make sure you get the right amount fluid.torque pan bolts to 96 inch pounds.

Nov 10, 2011 | 2001 Mitsubishi Diamante

2 Answers

How to Change transmission fluid on 2001 celica


Hi there, hope these few steps help:
  • Raise the car with a jack and support the vehicle with jack stands sufficiently rated to safely support the weight of the vehicle.
  • Place a large drip pan under the transmission.
  • Remove the transmission fluid drain bolt with a wrench. The drain bolt is located at the bottom of the transmission facing the pan. The pan is the large flat plate that covers the very bottom of the transmission.
  • Drain the transmission fluid into the drip pan.
  • Reinstall the transmission fluid drain bolt with the same wrench used to remove the bolt.
  • Lower the vehicle to the ground after removing the jack stands.
  • Open the hood and remove the transmission dipstick from the filler tube by pulling the dipstick. The end of the dipstick will be curved into a circle to allow a finger to slide into the circle to withdraw the dipstick.
  • Place a funnel into the dipstick tube and fill the transmission with new fluid by pouring the fluid into the dipstick tube.
  • Remove the funnel and check the fluid level with the dipstick until the fluid reaches the "Full" mark on the tip of the dipstick.
  • Start and allow the engine to run for a few minutes.
  • Move the transmission gear selector through all of the gears while depressing the brake pedal.
  • Turn the engine off and check the fluid level on the dipstick. Add transmission fluid if necessary.
Best of luck.

Jan 11, 2011 | 2001 Toyota Celica

1 Answer

Is the Transmission sealed, can not change the filter and fluid? Where is the radiator, is it also sealed, can water only be put in the overflow?


The transmission is not sealed in the v8 I looked up. It's bolted together. prev.gif next.gif Fluid Pan Removal & Installation To Remove:
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section
  2. Raise and support the vehicle
  3. Place a drain pan under the transmission fluid pan
  4. Remove or disconnect the following:
    • Drain plug and drain the fluid
    • Shifter cable bracket NOTE: The transmission fluid pan gasket is reusable, clean and inspect for damage; if not damaged, the gasket should be reused.
    • Fluid pan and gasket
    • Transmission fluid filter
    • Clean and inspect the transmission fluid pan and magnet
    • Converter housing access plug
    • Converter drain plug
To Install:
NOTE: A new converter drain plug must be used to prevent leakage.
  1. Install or connect the following:
    • Install the converter drain plug. Torque to 89 in-lbs (10 Nm)
    • Install the converter housing access plug
  2. Lubricate the seals and install the transmission fluid filter. Torque the bolts to 89 in-lbs (10 Nm)
  3. Install the oil pan magnet in the transmission fluid pan NOTE: The transmission fluid pan gasket is reusable, clean and inspect for damage; if not damaged, the gasket should be reused.
  4. Install the transmission fluid pan and gasket and loosely install the screws.
  5. Using a crisscross sequence, torque the screws to 8 ft-lbs (11 Nm)
  6. Install the shifter cable bracket. Torque bolts to 18 ft-lbs (25 Nm)
  7. Install the drain plug. Torque to 19 ft-lbs (26 Nm) NOTE: It will be necessary to hold the drain plug (larger plug) with a wrench when removing the fluid level indicator plug.
    NOTE: Use 3/16 inch Allen key to remove the fluid level indicator plug. Remove the fluid level indicator plug.
  8. Verify the transmission fluid level
prev.gif next.gif

Jul 21, 2010 | 2001 Lincoln LS

1 Answer

I drained out the wrond fluid


The transmission is bolted to the engine and if you drained fluid from a single drain plug, you probably drained the engine oil out, especially if it was black.

The transmission fluid, if Dexron II or equivalent, is red in color.

Check the fluid level of your engine to see if you drained the engine oil by mistake.

Usually, transmissions have several everal bolts that hold the drain pan and filter on.

Good luck, to you.

Jul 04, 2010 | 1988 Mitsubishi Mighty Max

1 Answer

How to drain transmission fluid in 1993 saturn sl2?


About the only way to drain transmission fluid is to take off the oil pan on the bottom of the tranny. There is no drain plug on transmissions.

Good luck

Oct 06, 2009 | 1993 Saturn SL2

1 Answer

How to change transmission fluid????


Transmission Fluid Replacement Replace transmission fluid as follows:
  1. Operate engine until reaching operating temperature.
  2. Turn OFF engine.
  3. Remove the drain plug.
  4. Drain the transmission fluid into a suitable container.
  5. Install drain plug.
    • Torque to: 22-29 lb-ft. (29-39 Nm)
  6. Refill fluid to specified level.
Fluid Type Specifications 4 Speed Automatic Transmission - Nissan Matic "D"
5 Speed Automatic Transmission - Nissan Matic "K"
NOTE: Using Automatic Transmission fluid other than Genuine Nissan ATF will cause deterioration in driveability and automatic transmission durability, and may damage the automatic transmission, which is not covered by the NISSAN new vehicle limited warranty

Jun 20, 2009 | 2004 Nissan Altima

2 Answers

2003 Dodge Stratus


no drain plug, no car or truck has had a drain plug for decades, reason? they want the filter changed with the fluid, so they make you pull the trans pan to drain the fluid, one very messy job.

Feb 12, 2009 | 2003 Dodge Stratus

Not finding what you are looking for?
1999 GMC Sierra Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...