Question about 2000 Dodge Caravan

1 Answer

No heat on passanger side of 2010 Chrysler Sebring

Heat only on drivers side, and cold air only on passanger side.

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 1,559 Answers

Sounds like you have a blend door that either the actuator has gone bad or the door is stuck. There is a chance that the dash will need to be removed to access the heater box.

Posted on Jan 20, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

roniecon
  • 6826 Answers

SOURCE: I have heat on the passenger side of my truck but

You have a blend door actuator motor gone bad.

Posted on Nov 26, 2009

lindsay836
  • 677 Answers

SOURCE: heat blowing out drivers, but wont get HOT. cold

Heat IS blowing out on drivers side, BUT it wont get hot ?
As long as you have heat, but not on passenger side, I would say your diverter is door is not operating, may be vacuum , or electrical, check under dash make sure no vacuum lines are leaking.

Posted on Feb 04, 2010

Testimonial: "ty!"

  • 22 Answers

SOURCE: Heater in 2003 Dodge Ram 1500 blow cold air out of

Not sure about your dodge, but on hondas there is a lever under the driver side vent to allow fresh(outside air) when its cold out, it will be cold, even with the heat on inside, so check to see if your has that lever somewhere on that side...hope that helps

Posted on Jan 02, 2011

twoduckster
  • 370 Answers

SOURCE: Passenger side heat doesn't work in my 2007 Dodge

I really can't be sure off hand, but what you wrote looks like the control valves are sticking(these flaps allow air to go different directions at the vents). its located at the heater core(towards the left side of the heater core) under the plastic just under the dash. you can manually move them, encase they are stuck, they do stick sometimes. while checking the vent doors, make sure your vacuum lines are connected. also check to make sure your vent hoses are tight. I hope this helps

Posted on Jan 11, 2011

vetteman3002
  • 2299 Answers

SOURCE: Heater in 2003 Dodge Ram

If this is dual climate control, which I am sure that it is. Then the actuator for the driver side vents on the heater core is not working. It could be a bad actuator, or a bad controller. If it is a bad actuator then the actuator has to be replaced. It is located down by the passengers feet in the duct work. If it is the controller it is going to be more expensive. The controller is where you select where you want the air to blow (defrost, vent, or floor.)

Posted on Jan 25, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 sebring heat on drivers side cold air on passenger side?


blend door actuator not working

1 - Blend door actuator 2 - Mode door actuator 3 - HVAC wiring harness


26340343-zk4yuwqxbgfnkewmrnymectq-4-0.gif

26340343-zk4yuwqxbgfnkewmrnymectq-4-1.jpg

Nov 04, 2016 | Cars & Trucks

1 Answer

Heat is cold when it comes out of the driver side but not passanger side


check temp. blend door actuator its what controls the temp doors to change from hot to cold usually pass. side door breaks on jeep grand cherokee's causing pass. side to be cool,have seen some on drivers side break but not as many

Feb 25, 2013 | Chrysler Sebring Cars & Trucks

1 Answer

Air blend door jeep liberty 2010


My blend air door is stuck on my 2010 liberty. I have removed the actuator panel on the drivers side and the middle door that controls the air flow to the dash is completely seized. There are 4 blend air doors on this liberty, 2 control the heat/ac and 2 control the air flow.
there is no access to them from the drivers side and the passanger side looks like I have to cut into the air box to get to them.

Jan 03, 2012 | 2010 Jeep Liberty

1 Answer

My heat wont' work on the passanger side of my 2001 town and county mini van..anyone know why it just blows out cold air. but the drivers and the back has heat


you need to take it to a shop. there is a water control valve on the passenger side that may not be working. also they will also check the heater discharge sensor. good luck sry couldn't be more help

Oct 16, 2010 | 2001 Chrysler Town & Country

1 Answer

Cold air coming out on drivers side heat coming


check to see if the vent duct has came loose

Jun 22, 2010 | 2005 Chevrolet Avalanche

2 Answers

Chrysler Sebring


Have you checked the antifreeze level? If it is low you will not get heat, or you may get heat at higher speeds.

Jan 03, 2009 | 2001 Chrysler Sebring

Not finding what you are looking for?
2000 Dodge Caravan Logo

596 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...