Question about Cars & Trucks

Open Question

2002 ds90 idles won't rev - Cars & Trucks

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 sebring sudddenly will not rev over 1500 rpm


start car, try to rev (try to cause error)... allow to idle for 30 secs
shut off car, with car stopped, turn key, on-off-on-off-leave on. codes will be displayed in odometer readout.

if code P0340 it is the cam sensor, very easy fix, one bolt.

Apr 16, 2012 | 2002 Chrysler Sebring

1 Answer

My ford exporer won't rev pass 2000 it will idles


check fuel filter- replace more than likely- if does not fix- look at catalytic converter- may be melted

May 30, 2011 | 2003 Ford Explorer

1 Answer

Multiple misfires. cylinder 3,6 appear first idles fine. won't rev past 3200 rpms. plugs fine. wires fine. changed 1 coil 3 and 6.


Try shaking the ICM connector see if it effects engine operation if it does inspect for looseness and poor terminal contact,these have a know connection problem especially 1,3,6 connections these are known as (COP) coil on plug

May 08, 2011 | 2002 Hyundai Santa Fe

1 Answer

2002 dodge durango revs up to about 2000-3000 rpms at idle. For no reason. Not pushing on the gas pedal. At idle, truck just revs up.


your Accelerator cable may be too tight and might need slacking off abit

However it could be timing screw is also incorrectly set.

Jun 22, 2010 | 2002 Dodge Durango

1 Answer

2002 Buick Rendzvous Won,t idle under 1000 rpm


This could be the TPS, or Throttle Position Sensor. Generally when there is an idle problem, this is the first thing to look at. Hope this helps

Sep 05, 2009 | 2002 Buick Rendezvous

1 Answer

2002 explorer suddenly won`t pull and won`t go over 2400 revs also making a different engine noise as if sucking too much or too little air. Have checked the fuel filter is OK. Idles OK as well.


Sounds as if your catalytic converters are plugged up. It's not a cheap repair, if you do it right. You have to replace the 'H' pipe, which contains the converters. That pipe may set you back 5 or 6 hundred bucks!
An emergency fix (though not legal) is to remove the existing pipe and with a long steel rod, bust out the guts of the converters. You have to shake out the contents after you bust them up so it's necessary to have the pipe off the car.
If you want to test and make sure that this is the problem, you can disconect the pipes from the exhaust pipes coming down from the engine without removing them from the car. Start the engine and try to rev it up, without the converters connected. If it revs like a 'racecar', you have probably found your problem. Good luck! Dave

Jun 29, 2009 | 2002 Ford Explorer

1 Answer

2002 doge neon r/t revs itself when i start it


The most common source of that problem is a sticking idle control motor. As a first step, purchase a new gasket and/or O-ring for the idle control motor. Remove the motor and clean it out using aerosol carburetor cleaner. If the idle control motor was sticking, that should cure it. It the fix only lasts temporarily, you need to replace the idle control motor. This is a common problem with vehicles with over 80,000 miles on them.
Charlie

Jun 18, 2009 | 2002 Dodge Neon

1 Answer

How do you increase the idle revs on a 2002 lancer


Idle is computer controlled and no way to increase it. May want to make sure the throttle body is clean. Use carb cleaner and a soft tooth brush to remove carbon buildup.

Mar 06, 2009 | 2002 Mitsubishi Lancer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...