Question about 2006 Hyundai Tiburon

Open Question

Where is iat wires on 2006 hyundai tiburon - 2006 Hyundai Tiburon

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
maklean
  • 1665 Answers

SOURCE: Finding something under the hood

The IAT sensor measures the temperature of the intake nmanifold. The ECM uses this sensor reading to set injection timing and adjust the air-fuel ratio. If the fuel mileage and power output of you engine seem low, some owners have found improvement in EGT, fuel economy, and power after cleaning carbon from the IAT sensor in at the rear of the intage manifold.936b43d.gif

Posted on Jun 15, 2008

Ad

SOURCE: change brake light switch

The switch is located under the drivers side dash behind the brake peddle arm.

Posted on Mar 23, 2009

  • 22 Answers

SOURCE: can't get the brakes to bleed to a 2006 hyundai

The tiburon's brakes are simple, there's no special technique to bleeding them. Are you sure you're bleeding them correctly?

If you are bleeding them correctly, then it's possible that you have a brake leek, causing air to get into the system.

Posted on Feb 11, 2010

  • 10 Answers

SOURCE: 2004 Tiburon: where is the 04 hyundai tiburon 2nd fuse box?...

Hi There,

You will find the second fuse box on the right hand side of the steering wheel (australian - left hand side if in america) located underneath the power "mirrors" button. Follow the side power "mirrors" button down until you reach a false wall, unfasten this. another word for this is the "fascia"

Hope this helps

Cheers Buckaroo,
Chris

Posted on Jul 18, 2010

  • 22 Answers

SOURCE: my 2006 hyundai tiburon won't start with a key,

I take it you still have power in the car, the starter solenoid needs to receive power on the signal terminal in order for it to work, power needs to get from your ignition switch to your starter, there is a clutch switch near the pivot of your clutch pedal that controls the signal to a relay. sounds like there is a problem between there, chances are it would be the relay, try swapping it with another one to see what happens. If that doesn't work you should be able to jump your clutch switch.

Posted on Dec 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No reverse in my 2006 Hyundai Tiburon hatchback 5 speed what could be problem


"Car won't go in reverse" - New Tiburon Forum : Hyundai Tiburon ...

www.newtiburon.com/forums/.../189049-car-won-t-go-reverse.html

Aug 8, 2010 - 23 posts - ‎16 authors
Okay guys I just sold my 03 tiburon GT 6 speed to a 16 year old. I just got a ... Join Date: Sep 2006. Location: ... "It stalls and just drift forward, no reverse lights" Now did he break somethng or is he putting it in 6th..... Any Ideas. ... To view links or images in signatures your post count must be 5 or greater. Location of reverse light switch? - New Tiburon Forum ...
8 posts
Jul 23, 2014
So who's reverse lights don't work? - New Tiburon ...
25 posts
Apr 11, 2009
More results from www.newtiburon.com
Missing: hatchback

2003 Hyundai Tiburon Manual Transmission Complaints

www.aboutautomobile.com/.../Hyundai/Tiburon/Manual+Transmission
My 2003 hyundai tiburon clutch and flywheel broke on 3 separate occasions since ...into reverse, I had a hard time finding it, it would not let me put it into reverse and I ....2006; Description of the Complaint: I have 2003 v6 tiburon, clutch failed at ... bought 2004 5 speed tiburon (she bought it before my problems started) and ...

Transmission Won't Shift/CEL Due to Failed Speed Sensors ...

repairpal.com > Problems > Hyundai > Sonata

Jan 03, 2016 | Hyundai Cars & Trucks

1 Answer

What brake pads where used on Hyundai Tiburon 06 SE?


OEM were these
http://www.carid.com/2006-hyundai-tiburon-brakes/powerstop-1-click-oe-replacement-brake-kit-31487698.html

Oct 31, 2014 | 2006 Hyundai Tiburon

1 Answer

How to replace ignition switch on a hyundai tiburon


Removal & Installation

Specific to:
Hyundai Entourage 2007-2008
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Disconnect the negative (-) battery terminal.
  3. Remove the crash pad lower panel (A).

    0996b43f80e41e86.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the crash pad lower panel (A)
  4. Remove the 2 screws (A) and the trip switch connector.
  5. Remove the crash fascia panel (B).

    0996b43f80e41e87.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the crash fascia panel (B)
  6. Remove the screw with the ignition in the ON position (IG ON) and disconnect the 6P connector.
  7. Remove the ignition switch (A).
  8. Installation is the reverse of removal procedure.

    0996b43f80e41e88.jpg
    enlarge_icon.gifenlarge_tooltip.gif
    Fig. Remove the ignition switch (A)
Specific to:
Hyundai Accent 2006-2008
Hyundai Azera 2006-2008
Hyundai Elantra 2006-2008
Hyundai Sonata 2006-2008
Hyundai Tiburon 2006-2008
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    The negative battery terminalThe crash pad lower panelThe ignition switch after loosening the screw with IG ON and disconnecting the 6P connector
  3. Installation is the reverse of the removal procedure.hope this helps it is off autozone website

Aug 02, 2014 | 2006 Hyundai Tiburon

1 Answer

How do you install fog lights on a 2006 hyundai tiburon?


Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop & owner manuals, service bulletins, campaigns, illustrations and procedures, etc

Aug 28, 2011 | 2006 Hyundai Tiburon

1 Answer

Can't get the brakes to bleed to a 2006 hyundai tiburon


The tiburon's brakes are simple, there's no special technique to bleeding them. Are you sure you're bleeding them correctly?

If you are bleeding them correctly, then it's possible that you have a brake leek, causing air to get into the system.

Apr 03, 2009 | 2006 Hyundai Tiburon

2 Answers

Where is the IAT?


Usually on inatke plenum (throttle body) and is part of M.A.P. sensor. If not there, check area of firewall on passenger side.

Jan 25, 2009 | 2003 Hyundai Tiburon

1 Answer

Finding something under the hood


The IAT sensor measures the temperature of the intake nmanifold. The ECM uses this sensor reading to set injection timing and adjust the air-fuel ratio. If the fuel mileage and power output of you engine seem low, some owners have found improvement in EGT, fuel economy, and power after cleaning carbon from the IAT sensor in at the rear of the intage manifold.936b43d.gif

Jun 15, 2008 | 2001 Hyundai Tiburon

Not finding what you are looking for?

Open Questions:

0 Answers

Shifting problems My car is a 2006 Hyundai Tiburon, Automatic, 2.0L 4 Cylinder I've had the car two years I don't know what's related and what isn't so here is the story. Bought car, (cruise control did not work) but everything else seemed fine, engine light came on code read Vehicle Speed Sensor so I bought an input and an out transmission speed sensor and had them installed, Motor blew 2 heads had motor replaced with an almost new motor. Cruise control now works, three days later car would not come out of park shifter moved but car stayed in park felt like shifting cable let loose, I called a backyard mechanic friend and he moved the shifter hard and it went into drive said probably buddy who changed motor forgot to unhook cable and stretched it (made sense to me) it did this everytime car was put into park had to yank on the shifter to get it to shift so I started parking her in neutral and it never messed up, after 3 weeks my new shift cable came in so I went to show my mechanic what car was doing it wouldn't do it worked fine, told him I'd call him next time it messed up this is a year and a half later hasn't messed up like that again! I had already bought the cable so I decided to have it installed anyways even though problem seemed fixed went to a shop they told me nothing is wrong with my cable..... Approx 6 months ago put car into drive and started driving the car reved out (I call it) motor got really loud and RPM gage went to 4K and car jerked really bad and made a really loud snap noise so I pulled over and roughley shift car into park and back into drive and drove this fixed the issue for that drive anyways.... my car one day over heated to red line in a 5 minute drive in the winter my mechanic said must be an air lock so he drained my fluid and replaced ect, next day car wouldn't start, blew starter, replaced that, next day driving car and in a 5 minute drive it overheated to red line took car to shop he said gage is reading wrong car is barely even warm so I decided to take the car home and worry about this issue pay day well the next day car wouldn't start, blew alternator, at this time my mechanic looked over car more closley turns out I had a bad ground so he put on new alternator and new ground, this was a month ago and no more issues with overheating or not starting. However I still have this issue (copy and paste) "put car into drive and started driving the car reved out (I call it) motor got really loud and RPM gage went to 4K and car jerked really bad and made a really loud snap noise so I pulled over and roughley shift car into park and back into drive and drove this fixed the issue for that drive anyways...." After having ground put on and shifting issue still there I took my car directly to Hyundai they ran all their computer tests and transmission tests and took car for a test drive car worked fine and only code that came up was Vehicle Speed Sensor. So here is where I stand first question how many speed sensors does my car have is a transmission input/output speed sensor different then a vehicle speed sensor? I looked on parts sites and only speed sensors I find are ABS speed sensor and Vehicle Speed Transmisson Sensor, so maybe sensors I bought are no good but they were bought new or maybe the connector for the sensors are bad? I don't know any suggestions would be greatly appreciated.

Jan 12, 2016 | 2006 Hyundai Tiburon

See all 2006 Hyundai Tiburon Questions

2006 Hyundai Tiburon Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...