Question about 1994 Ford Crown Victoria

1 Answer

What are the signs

My car is cranking but noy starting

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 65 Answers

Ignition problems

Posted on Nov 21, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Santa fe 2001- diagnos, P0190 fuel rail sensor malfunction. Car cranking only as if no gas coming in. At first we suspected the glowplug, we replaced new one but still noy working.


You have a fuel pressure or sensor problem.
1 The fuel pump is not working
2 The fuel filter is blocked
3 The pressure sensor has a electrical problem or failed

Feb 08, 2015 | Cars & Trucks

2 Answers

96 nissan max, 5spd, hard starting. crank over, bu wont start, replace cam, crank.pos, ref sensors, fuel pump, inhibter relay, i seem to have no spark to plug , remove plugs and there al wet with gas,


Hello! First check fuse # 59 (7.5A)..If it is good the failure is a typical fault on your vehicle and is more than likely the cause...A defective ECCS relay (aka..EGI)...It is the ECM Module control...It is located in box 2 on the left side of the engine next to the battery....a common failure...The cost is under $20..see photo below...If the relay does not solve the problem...There is a Technical Service bulletin that addresses the issue...
EC97-018b NTB98-008b September 16, 1999
1995-99 MAXIMA EGI HARNESS WIRE BREAKAGE...Guru...saailer


1_14_2012_5_15_48_am.jpgSTANDARD MOTOR PRODUCTS Part # RY363

Jan 10, 2012 | 1995 Nissan Maxima

1 Answer

2000 olds drove to work fine this morning this afternoon it would not CRANK, just a load starter/solenoid click. changed starter this afternoon, still same load click, checked battery volts 12.6 , cleaned...


This might noy be of much help, buy I would try a remote starter switch hooked up to the starter,with the ignition switch in the run position..then push the remote start switch.
This would give you an idea if the ignition switch is a part of the problem

Oct 11, 2010 | 2000 Oldsmobile Intrigue

1 Answer

I have a 1993 chevy s-10 blazer it's been siting for 5 years and the two bottom pully are noy moving what can i do


The bottom pulley is typically the crank pulley. If you are starting the engine and that is not turning the starter is not engaging. If it is not the crank pulley it is probably the Power Steering or the alternator. Try tightening the belts to see if that helps. If not, you may soak them in penetrating oil to get them moving again, but it's a long shot!!!

Oct 03, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

2000 COUGAR WILL NOY RUN, NEW PLUGS AND WIRES NEW CAM AND CRANK SENSORS IT IS IN TIME, GETTING FIRE, FUEL PRESSURE GOOD,EXHAUST NOT PLUGGED, CHECK ENGINE IS ON BUT IT READS 'NO CODES' BLACK SMOKES COMES...


your ac compressor might be locked up remove belt and trun over and if it starts, then great, do not drive it tho with out belt on, i had this same problem,

Sep 25, 2009 | 2000 Mercury Cougar

2 Answers

Car wont start but i have spark and gas? I put new plugs cap and rotor in and still just cranks. Where do i need to look next.


Look at the valves and see if they move when trying to start. The top end may noy be moving and therefore no t-belt any more.

Jul 10, 2009 | 1994 Toyota Corolla

1 Answer

Civic won't start


my honda civic wont turn over and when i tried to crossover starter all it did was spin but would noy engage

May 15, 2009 | 1998 Honda Civic

1 Answer

Want crank


you have a defective fuel pump relay

Feb 03, 2009 | 1997 Plymouth Neon

2 Answers

1996 subaru legacy gtb


I have the same problem. It was the camshaft sensor. After replacing the problem was solved. A malfunctioned crank sensor can give the same problem

Aug 09, 2008 | 1996 Subaru Legacy

Not finding what you are looking for?
1994 Ford Crown Victoria Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...