Question about 2005 Chevrolet Cobalt

Open Question

Standard labor rate to replace oil pan

What is standard labor rate to replace oil pan on 2005 chevy cobalt?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

BelgianAlien
  • 50 Answers

SOURCE: my 2005 chevy cobalt factory radio is locked

There are only 2 things you can try to fix this yourself: turn off the engine and open the driver side door (to turn the radio off). Wait 5 minutes, start your car.
If that does not solve it, turn off your engine, disconnect the car battery, wait about 5 minutes. Reconnect the battery (negative pole first - black connector) and try your radio again.

If neither one of these two fix your problem, I am afraid only a GM service center or dealership can fix the problem. The Cobalt is notorious for all kinds of electrical issues.

Thanks for using the fixya forums!

Posted on Mar 28, 2009

  • 134 Answers

SOURCE: My oil pan is cracked and I want to know if I have to remove the engine to change this.

If you can see and get to all of the bolts which hold the oil pan to the bottom of the engine and if it appears obvious that the oil pan can be removed without being blocked by anything else, then you don't have to remove the engine. Come to think of it, I don't think that I have ever seen a car where you had to remove the engine in order to remove the oil pan.

Posted on Apr 20, 2009

blueextc3221
  • 15935 Answers

SOURCE: how much will it cost for a mechanic to change oil pan gasket on my 1998 chevy blazer 4wd big v6 engine?

Gasket = $35 (permatex rubber)
Labor - my manual says 3 hours.
You'll have to be responsible for figuring out the labor price per hour depending on where you are located.
In MI, a garage is about $50/hr, and dealership = $85/hr
CA might be $95/$150/hr.

Parts are minimal on the job - its all labor.
Figure in about $20 for shop supplies... gasket remover, sealant, rags, etc.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Posted on Jun 02, 2009

  • 543 Answers

SOURCE: power steering on chevy cobalt

i dont think you can just get the chip,its the complete power steering control module (
computer) typical problem withall ions and cobalts

Posted on Oct 08, 2009

texastbone
  • 63 Answers

SOURCE: 2005 chevy cobalt, car wont start ... check

disconecting the battery should reset the pcm. but you will need to find out what caused the problems.

Posted on Jan 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 chevy cobalt. I apparrntly hit something in the road and got a hole in my oil pan. My car slowed down so i pulled over and shut it mdown. Id thers iny major problems i should be concerned...


If u still have oil in the oil filter, the motor should be fine.While u have the pan off u should spin the motor to make shur there is nothing louse

May 28, 2012 | 2006 Chevrolet Cobalt LTZ

1 Answer

Will the oil pan from a 2.2 l chevy motor fit on a 2.0 l chevy motor?


There are probably lots of used oil pans in the salvage yards. The problem is that the salvage operators will only sell them with a used engine. That is why you are being told that there are none available.

To answer your question:
The part number for a 2002 Cavalier 2.2L OHV oil pan is 88890999.
The part number for a 2006 Chevrolet Cobalt SS 2.0L oil pan is 55558816.
So, the simple answer is NO, they are NOT interchangeable.

The good news is that you can order a NEW oil pan from gmpartsdirect.com for about 40% off of dealer MSRP. Click the link below to go there.
http://www.gmpartsdirect.com/results.cfm?partnumber=55558816

May 08, 2012 | 2006 Chevrolet Cobalt SS

2 Answers

Can a good back yard mechanic replace the transmission oil pan on a 2008 Chevy Cobalt?


Yes it shouldn't be a problem but change the filter as well...........Hope this helps.

Sep 27, 2010 | 2008 Chevrolet Cobalt

1 Answer

How do you take off the oil pan on a 2007 chevy cobalt? I have removed all the bolts that secure the oil pan, but it will not come off.


There is a gasket between the engine and the oil pan. It is probably stuck. You will have to pry it loose with a screwdriver. It may damage the gasket so you might have to get a new one. Make sure you scrape off the old gasket before installing the new one.

May 27, 2010 | 2007 Chevrolet Cobalt Coupe

1 Answer

I need step by step instruction on removing and replacing oil pan on 2005 chevrolet cobalt 2.2L. What tools I will need.


Most any shop will do this in about half an hour! Why waste your time? Plus it is a very messy job working on your back with oil forever dripping.

Mar 27, 2010 | 2005 Chevrolet Cobalt

1 Answer

My oil pan is cracked and I want to know if I have to remove the engine to change this.


If you can see and get to all of the bolts which hold the oil pan to the bottom of the engine and if it appears obvious that the oil pan can be removed without being blocked by anything else, then you don't have to remove the engine. Come to think of it, I don't think that I have ever seen a car where you had to remove the engine in order to remove the oil pan.

Apr 20, 2009 | 2005 Chevrolet Cobalt

3 Answers

How to change automatic transmission fluid in 2005 cobalt?


hankfan18436
Rank: Wiz chevrolet.gifChevrolet Expert
Rating: 84%, 28 votes
There should be a drain screw on the bottom of the pan, drain the pan it is recommended that you change the filter also, you have to unbolt the pan and lower it to change the filter. bolt the pan back up and fill the transmission back up. i hope that helps you out.
To add the transmission fluid you pull your oil cap remove the cover as if you were going to change the oil filter on the same side as the oil filter or the drivers side their is a cap that has a gear on it look down past the hoses and you will see the black cap you will need a long neck funnel and only use the dex III you will need to find out how much fluid the transmission hold hopes this helps you.

Nov 16, 2008 | 2005 Chevrolet Cobalt

Not finding what you are looking for?
2005 Chevrolet Cobalt Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...