Question about Saab Cars & Trucks

Open Question

Wiring diagram power window system

Drivers window went down but will not go back up even with another motor and mechanism. Clicking can be heard from the motor when the switch is activated.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: wiring for power window switch

ebay is your best bet

Posted on May 26, 2008

Ad
  • 975 Answers

SOURCE: 2005 Chevy Cavalier Electric Window Wiring Diagram

Tom,
See this alot. Sorry,It appears that is a symptom of a bad motor. If it moves an inch or so,then nothing,after a few minutes another inch or so,it's motor time!

Posted on Apr 08, 2009

pippall
  • 1486 Answers

SOURCE: drivers side power window won't go up

Just replace the switch has they can be the fault in most cases.

Posted on Aug 09, 2009

  • 16 Answers

SOURCE: power window switch is not working and i would

I found the answer here; it tells you exactly which wires to jump in order to get the driver's side window to raise:

http://cardealerforums.com/alt-autos-gm/t47387-1996-lumina-power-window-switch.html#post150470

Posted on Nov 20, 2009

Testimonial: "thank you"

airjer995
  • 5332 Answers

SOURCE: Looking for wiring diagram for

You'll need to pull the door panel and check for power and ground at the 2 wire connector located near the window motor (there should be a dark blue wire and a brown wire). With a test light there should be power on one of the two wires at any time. If there is power on both wires with the switch in the up position than the switch is bad. If the only wire powered up in the up position is the dark blue wire than try tapping the motor while holding the switch in the up position. If it starts to work than the motor is bad.

On a side note check for power with all the connectors plugged in. You can also jump the connections at the motor. Supply a ground to the brown wire and supply power to the dark blue wire and the window should go up.

Posted on Sep 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Drivers side power window went down and wouldn't roll back up


I had this happen in an old Acura coupe of mine. Motor was slowly going out in the regulator. Pretty cheap fix if you know your way around cars.

http://www.discountbodyparts.com/catalog/feeds/Suzuki/Grand_Vitara/Replacement/Window_Regulator/2000/S462914.html?dbpcid=gglpla

Aug 15, 2016 | 2000 Suzuki Grand Vitara

1 Answer

Where is the power window relay located on a 1964 Pontiac GTo with AC.


I believe those older cars used circuit breakers, not relays, for the power window systems. By using a test light, you don't know if battery voltage is present at the window switch. Maybe the voltage is reduced, somehow.
I would first check the switch's power with a voltmeter. If the motor is getting battery voltage, I would say the motor. If the voltage is low,
you had better find a wiring diagram, Dave, to trace it out.

Oct 25, 2014 | 1967 Pontiac GTO

1 Answer

1999 toyota camry all power windows work except driver window?


Go to a local repair shop & have them print you
the wiring diagram you need

Feb 16, 2013 | 1999 Toyota Camry

1 Answer

2003 ford f-150 crew cab power window went down but will not come up i hear a clicking noise in fuse panel


Window fuse's and relay's may be up under driver or passenger side dash or behind glove box, under the hood and even under the seats, and finally on the ends of the dash. All passenger power windows and locks are controlled thru and get power from the master control switch on the drivers door.

Drivers door window gets used the most so it could be the motor, window switch, relay or fuse.
Could also be a broken wire in the rubber boot going from the door to the body. You will have to eliminate each till you find the culprit. Check that all switches return to neutral when released.
The motor and the relay are the most likely to cause this problem. Try swapping the relay with a working window relay. If it still doesn't work, remove the door panel and remove the window motor.
Turn the motor shaft in both directions by hand several turns. Then plug the motor in and see if the switch will now run the motor. Sometimes that's all it takes to get it working again. I have had to do this with brand new motors. If voltage is not present at the motor connector, either a bad switch or a broken wire exists. Make sure to check for voltage coming to that windows switch. Actually, GM use's a circuit breaker type relay for each window and one fuse for all the circuit breakers.

Try this....
Open the door, turn the key to the ON position without starting the engine and everything that makes noise is off. Lean down placing your ears close to the bottom center of the door or at the speaker grill. Press the window switch UP and DOWN. Listen for the window motor. If heard the drive is damaged. If not heard, turn key off and locate and replace the relay with one of the other window relays. Check window again. If it works now, get a new relay. More often than not, removing the motor and turning it by hand will get it working good as new. I have had to do that with Brand New motors! So try it.
If all has failed, with the door panel still off, check for voltage at the motor connector when pushing the window switch. No voltage means its the switch, especially if its a auto down or up switch.

Aug 29, 2011 | 2003 Ford F150 Regular Cab

1 Answer

95 riviera drivers window wont go down


Could be a couple of things: the first two apply ONLY to POWER WINDOWS:
1-window switch went bad (not common but it happens)
2-window motor only works one direction (even more rare, but still has happened)
3-window regulator defective(power windows-maybe broken cable or mechanism; manual crank window regulator-broken mechanism.

If you have power windows:
Do you hear the motor running or binding when trying to roll window down? bad regulator
No noise? switch or motor

You need to remove your door panel to see and access the interior operating components. When you get that far you'll most likely see something obviously broken.

Then you'll need to examine the regulator and see if it has a broken cable or other binding parts.

Not a big deal to replace the window motor or regulator, but requires a little patience and manual dexterity.

Hope this helps.

Mar 18, 2010 | 1995 Buick Riviera

1 Answer

Need electrical diagram for power windows motor . my power window drivers side went down but will not go up? I switch thr switch and it is not the switc. I think it is the motor.HELP!!!!!!!!!!!!!!!


ck for power in the up and down positions at motor... one wire will lite up and the other wire will down... if no power up try looking at the wires in the door jam there covered by a rubber boot... if power to motor in both directions then its the motor

Jul 31, 2009 | 1991 Ford F150

3 Answers

Ford Taurus Window won't go up


If you are hearing the clicking from the power window relay the only things left would be a break in a wire or a failed window lift motor. If this window only goes down but not up I would inspect the wiring at the door jamb for a damaged wire. If this fails to go either way I would remove the panel, insert test light into the lift motor leads (X2)and actuate the switch, if I get power then I would replace the lift motor. If you get no power in one direction - test switch.

Jun 06, 2009 | 1999 Ford Taurus

1 Answer

Drivers side front window not working


After taking away the door panel and the door loudspeaker I found that the wires leading to the lift motor had somehow got caught in the gadget that dampens the force to save the hinges breaking when you open the door. This mechanism is bolted on to the door with two bolts and to the door frame with a pin. It has a spring steel tang attached to a stopper inside the door. The wires had somehow got caught between the stopping plate and the door frame. Motor was burned out and replaced. All OK now.

May 14, 2009 | 1997 Isuzu Rodeo

2 Answers

Power window on 2001 chevy silvrado


Sounds like your gears are striped out inside the motor. I had the same problem on a car of mine. I just went to a parts store and bought the gear and took the motor apart and fixed it myself. It cost 18 dollars with tax.

Good Luck.

Feb 02, 2009 | 2001 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

rgbypoet

Level 2 Expert

166 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...