SOURCE: 2001 SATURN SL1 BELT
You'll need a 14mm socket wrench.
Locate the belt tensioner pulley. It's the one closest to the alternator and the only one that comes in contact with the back surface of the belt.
Fit the socket on to the bolt on the pulley.
Try to turn it clockwise.
This should swing the pulley down and loosen the belt,
Slide the belt off one of the other pulleys.
When it's clear, release the tensioner, remove the belt.
Same deal in reverse to replace the belt.
Here's a diagram
Hope this helps
Mike
SOURCE: serpentine belt 2002 Saturn Vue V6
The diagram to install the belt is under the hood near the engine emissions sticker, if not there near the belt.
SOURCE: Replace serpentine belt on a 1995 Saturn sl1. 1.9 engine
Yes! It is a whole lot easier and faster to take off the passenger tire. Remove plastic cover with speed pins. It is a lot easier to get to the belt tensioner to release belt tension also.Just put a 14mm wrench or 9/16" wrench on the tensioner at the 4:00 o'clock position and push down the belt will be easy to remove and reverse this to install the new one GOOG LUCK *****badgto1NJ
SOURCE: 2000 saturn lw2 3.0 reset service light
turn the key to the run position,pop the hood and in the fuse block right near the battery youll see a fuse labeled oil -r push it down and hold it 10 seconds and then release and check to see if the light in the dash is flashing, if it is turn the kehy off and your done, if not do it again,sometimes does not work the first time,
299 views
Usually answered in minutes!
×