Question about 2008 Bentley Continental GTC

Open Question

Fuse diagram Which is the fuse for the tyre pressure monitor

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My bmw noise coming from engine fells like iv got a flat tyre and juddering but tyres checked no flat tyres noise coming from engine

If it is a knocking type of noise. Like a thud or such. And it does it more when you hit a bump or other pavement flaw, it may be your motor mount that broke or came loose.
Read an service manual or find somebody with some mechanical knowledge to check your motor mount assembly. The tire pressure monitor sometimes comes on for reasons that have nothing to do with the tires. Resetting the monitor will stop that . Just check your tire pressure.

Oct 19, 2017 | BMW Cars & Trucks

1 Answer

Im looking for a tyre pressure sensor for my renault laguna 2033 plate but not sure what im looking for or how to fit one thank you

1. The tyre has to be removed to fit the tyre valve/ sensor unit to the wheel. . Tyre dealers will do this for you when you supply the sensor.

2. Any renault dealer parts department can sell you a new sensor.

3. The new sensor has to be programmed to the car's tyre pressure monitoring system (TPMS).

3. Here is a list of information about the Renault Laguna tyre pressure sensors to assist you. The 2nd link below shows a picture of the tyre valve/sensor unit that fits to your wheel.

Renault Laguna Megane Tyre Pressure Sensor World Car Parts Store

Jan 07, 2016 | Renault Cars & Trucks

1 Answer

How do u reset tyre pressure senor on vw cc 2.0 desiel year 1213 check tyres an the pressure ok


May 10, 2014 | Volkswagen Passat Cars & Trucks

1 Answer

Service tyre preasure sensors

The tire pressure monitors are made in the valve stems. You will have to replace the valve stems then have the codes cleared at the shop. Most tire stores have the tool to reset the tire pressure monitors. It can be a little costly.

Jan 04, 2014 | 2005 Jeep Grand Cherokee Laredo

1 Answer

Flashing light with ? in the middle.service light on at all times. two front wheels flashing

The indication of the two front wheels flashing is most likely the tyre pressure monitoring system try adding the proper amount of air pressure in the tyres, also never change your tyres around this can also cause the problem or the sensors might have just become faulty.

Apr 22, 2010 | 2000 Renault 181

1 Answer

When I start my 2002 laguna privilege it says tyre pressure sensor not functioning i have tried taking the fuse out it was ok for 5 mins and then started doing it again and only has 3 wheels showing on the...

The problem is with the tire pressure monitoring system as this one is that they are not lifetime built I believe that the battery installed on the sensor has died and must be replaced with a new sensor and therefore a procedure that needs to be carried out when replacing the sensor, certain calibration and so on, Also you can't just swap tyres around because each tyre is programmed to a certain position which if done well just give a wrong indication of the tire pressure on your dashboard.

Apr 03, 2010 | 2003 Renault 181

1 Answer

2003 X5 - TyreIndicatior Inactive shows on VDU.

Just double check the tyre pressure as per specification and reset the the Tyre Pressure Monitor system. Also make sure no Tyre punture on it.

Mar 05, 2010 | 2004 BMW 5 Series

1 Answer

I have just changed my tyres on my 2007 BMW 320d and I do not know how to cancel the run flat tyre warning now showing on the dash board. My car is spanish without 'I' control which is the only method...

Hi make sure your tyre pressure is correct then switch Ignition ON, scroll the the switch you mentioned untill the symbol of Tyre pressure monitor displayed at intrument cluster. press and release then Press again and hold for atlest 5 sec. the side button of switch untll the box beside the Tyre pressure monitor got tick sign. Ignition off and verify the system operation.

Jan 14, 2010 | BMW 318 Cars & Trucks

1 Answer

2008 beetle dash light on with a aexclamation mark

hi from uk this light is the tyre pressure monitoring system it is telling you that one or more tyres pressures are under inflation so! if you have not checked them weekly ? for your own safety you should may i suggest you check and inflate to correct pressure of all tyres inc spare ! obviously if one tyre is very low ? keep an eye on it? in case it has a slow leak/puncture ? ps the horse shoe is a low pressure tyre symbol ? best wishes from uk and merry xmas !

Dec 25, 2009 | 2008 Volkswagen Beetle

1 Answer

Tyre pressures for renault laguna

32 psi in the front and 30 psi in the back. if the tyre preasure monitoring is acting up even with the preasures ok. take the car to a renault garage to have them re initialised

Jul 26, 2008 | 2001 Renault Sportwagon

Not finding what you are looking for?
2008 Bentley Continental GTC Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bentley Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

78267 Answers


Level 3 Expert

917 Answers

Are you a Bentley Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides