Question about 1995 Nissan Altima

1 Answer

The electric motor wich opens the door is making some clicks while opening and keeps clicking continuously when it reach the end. What can be the problem and how do i fix this?

After the electric motor has kept clicking for about 15 seconds at the end, the door can only be closed manually. After that I have to put off the power of the sliding door for a few seconds and put it on again to activate the electric motor of the sliding system

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Nissan Master
  • 12,223 Answers

You must lube and see if there are some parts loose or broken. However you must test the motor for to see if is defective. go to www.aa1car.com get the topic and fix it.
God bless you

Posted on Nov 20, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

alicantecoli
  • 22095 Answers

SOURCE: recently sunroof clicks, hesitates, and has wind noise

try oiling the runners

Posted on Nov 13, 2008

  • 1 Answer

SOURCE: sliding door won't close. 2004 nissa quest

Mine was doing the same thing. I took it in and watched them fix it and first they steam cleaned the area under the floor where the rollers are. Then they took a spray and lubricated the rollers and the track where the rollers are. then they cleaned the brass connectors on the side of the door where the safety pins touch. I could have saved ALOT of money doing this myself. I hope this helps!

Posted on May 12, 2009

  • 2 Answers

SOURCE: program garage door opener on 2005 nissan murano

All the info should be in the manual

Posted on Jun 24, 2009

  • 1 Answer

SOURCE: drivers side door won't open

I have a 2003 nissan altima and the door has woked fine all night and now the door will not open from the inside. It is just a broken spring?

Posted on Dec 30, 2009

  • 86 Answers

SOURCE: Nissan Murano (05) Power Locks Sticking

The door lock actuator in that door is weak. Need to replace it.

Posted on Feb 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my drivers window is inop after replacement of master switch


The wires (inside the door) from the master switch to the fuse-box must be broken -- no electric-power is reaching the motor that lowers/raises the window. Take the whole door apart, and use a continuity-testing multi-meter to verify that the motor is receiving power, and that the switch is opening/closing properly.

Jun 13, 2014 | 2007 Saab 9-3 2.0T

2 Answers

Electric sliding door on a 2004 T/C


When it is doing this does the door feel loose? It could possibly be off track or the track could be stripped out. Keep me posted.

Thanks - Tech101

Jun 25, 2008 | 2004 Chrysler Town & Country

1 Answer

When opening or closing drivers door, the window opens 5" instead of usual 1/2" and does not auto close. Also after operating window switch, onetouch or holding, the window lowers or raises and then stops...


what car

electric windows.
can fail for 3reasons
power does not reach the motor.
motor is bad
the guides are seized.

some times, the motor seems good but is weak, bad internal
commutator. (2/3s power)?

use a voltmeter see if 12v reaches motor on demand (push switch)
if that is ok, we have it down to 2 problems in 5min flat.
you could then disconnect the motor, and see if the windown
can be operated by hand, if not , its jammed
if you can , then the motor is bad or weak.

you are now IMPOWERED.

Oct 16, 2013 | Cars & Trucks

1 Answer

2004 Mazda RX-8 turn car off and remove keys. flashing interior lights, clicking noise from driver rear door. Remove battery cable to make it stop. Help!


The problem is an electrical failure in your circuitry. From Fuse to lights, to the door switches is a complete circuit. It is possible the lock switch is stuck or faulty making the motor keep running. There may be a relay that is sticking open for that door motor. Between the switch and motor if you do have the relay. I would try disconnecting the lock switch on that door first, then if it still occurs try disconnecting lock or window the one on the drivers side. If the problem still occurs, then your looking at a problem in the electrical such as shorted wire somewhere.

Jan 27, 2011 | 2004 Mazda RX-8

2 Answers

Heater&air conditioning vents wont reach position make a clicking noise have no heat or air how do i fix? 2003 ford explorer


The clicking noise you hear is a stripped out plastic gear from the blend air door motor almost every car maker now uses little electric motors to control heater door panels,put it in the position for it to make noise go under your dash find where it is usually externally mounted remove it and replace it cost about 30 dollars at the dealer.depending on which of the 3 motors its is usually not hard to do.

Apr 17, 2010 | 2003 Ford Explorer

1 Answer

I can not open my back seats. The trunk release will not work and the key will not open the trunk


this is only a suggestion but some cars have a safety feature wich to keeps people from snooping around your car that has access to your keys. make sure by reading your owners manual that there is not a button like in your glove box or center console box you may have mistakenly hit. I do not know about mercedes but for instance toyota provides you with what is called a vallet key wich is a third key wich will only allow you to open the door and you start the car not allowing glove box or trunk entry like a said this is only a suggestion it very well could be a broken cable or an electrical malfunction. good luck

Mar 18, 2010 | 1999 Mercedes-Benz CLK

3 Answers

Pontiac vibe 2003 - ticking noise coming from passenger air bag area - only when ignition on. What is it and how do I fix it?


IS THERE ANY PROBLEM WITH YOUR A/C CONTROLS? -DOES AIR BLOW OUT WHERE ITS SUPPOSED TO AND DOES TEMP CONTROL WORK? - IF A DOOR IS STUCK OR MOTOR COUPLING FOR DOOR IS BAD IT WILL TICK OR POP TRYING TO MOVE

Sep 26, 2009 | 2003 Pontiac Vibe

2 Answers

Pontiac vibe is making a clicking noise behind the


sounds like a blend door motor making noise to me.

Sep 05, 2009 | 2004 Pontiac Vibe

1 Answer

I have a 99 montana passenger side sliding door dont work. Hit either button all it does is clicks and motor seems to be fine.. I went to junk yard bought complete new motor and everything that comes...


I would check the overhead buttons there are two one opens the door, and the other beside it that shows the van crossed out, disables the electric sliding door feature. try playing with that, Also remember, that vehicle must be in PARK for the electric sliding door to open. Make sure the power lock on that door is working, and check the child safety lock when you have it open by the doors catch. Hope that Helps You.

Aug 02, 2009 | 1999 Pontiac Montana

2 Answers

Starter clicks but does not turn over


typically, this is indicative of a worn out starter. inside the starter there is a coil that pushes the drive gear into the flywheel (this is what makes the click) and then there is a motor that turns the drive gear. The armature bushings of the motor are likely worn, and having difficulty making continuity. (sometimes lightly tapping the back end of the starter with a hammer will get it to work). ultimately, the starter has to be replaced. best of luck

May 14, 2009 | 2001 Mazda MPV

Not finding what you are looking for?
1995 Nissan Altima Logo

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...