Question about Ford Cars & Trucks

1 Answer

There no sparks at plug ,is there anything to do with computer box but electrical componets is working

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 12,223 Answers

See the chart for troubleshooting guide fix it. God bless you
However you must RUN the scanner/computer for better diagnostic and fix it.
there no sparks at plug ,is there anything to do w - 35f21a90-0b7c-492d-b9f9-7fe9905ff0f9.gifbbb3d0ff-2255-43a9-9890-81348d034a89.jpg

Posted on Nov 20, 2013

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes mis firing on opel astra estate 160i 1997 models


It could be anything from a bad spark plug wire, bad coil, bad valve, bad fuel injector, vacuum leak, or other electrical or mechanical issue. Have you done anything to attempt to fix the issue such as performing a tune up, checking the compression on the misfiring cylinder, or swapping spark plugs or spark plug wires between cylinders to see what the misfire follows?

Apr 04, 2017 | Opel Cars & Trucks

Tip

How To Change The Spark Plugs On A 2002-2005 Kia Sedona 3.5 Liter


You'll need to remove the oil cap and the 6 bolts holding on the engine cover. The front 3 spark plugs are pretty easy to replace. You'll need to unplug the spark plug wire from the coil and disconnect the electrical connector. Unbolt the 2 10mm bolts holding the coil to the valve cover. Twist the coil and boot back and forth and pull it out of the cylinder head. The spark plug is down in the head, you'll need at least a 6 inch extension with a 5/8" spark plug socket, a telescopic magnet will help get the spark plug out of the head. The back 3 spark plugs involve removing the upper intake and throttle body, unbolt the bracket to the throttle body, and the bracket bolted to the upper intake manifold. on the back side of the engine. Remove the tubing from the throttle body to the air cleaner box. Unbolt anything else bolted to the upper intake. Unplug electrical connectors to the throttle body and any other electrical connectors on the upper intake and remove the upper intake bolts. And move the upper intake out of the way, there are only spark plug wires on the back 3 plugs. Twist and turn each boot to aid in removing the boot from the plug. I would get a new upper intake gasket and consider replacing the wires at this time also. There are actually only 3 spark plug wires, so for what is involved to get to them, I would replace them. I have found alot of the wires will arc to the upper intake manifold.

on May 02, 2010 | Kia Sedona Cars & Trucks

1 Answer

I HAVE A 95 BLAZER WITH NO SPARK , CHANGED ALL COMPONETS I COULD FIND , STILL NO SPARK , NOW WHAT DO I DO


Could be the ignition module. It is located on distributor under rotor . Unscrew distributor cap and flip out of the way, leaving spark plug wires attached. Pull rotor off and remove electrical wires on both ends of ignition module. unbolt ignition module and remove. Make sure you put the grease on the metal bottom side of ignition module to disipate the heat that is generated, before you install new ignition module, if you want it to last.Good Luck.

Jan 03, 2011 | 1995 Chevrolet Blazer

1 Answer

What could be the problem in a 1993 Saturn SL1 car that does not start. It sounds like electrical. When the ignition switch is swung, the engine sounds like it is out of fuel but its not. The relays and...


Well it is 17 years old, many things could be bad. There is a hook up under the dash to connect an analyzer, that would be a place to start. There are two coils, under the coils is an ignition module, that could be bad.

Dec 05, 2010 | 1993 Saturn SL1

1 Answer

Won`t star


Hello Sir:

There are 2 Problems that can prevent your car from starting:

#1) Make Sure your getting Fuel

#2) And Check to see if you are getting Spark to your Spark Plugs,By pulling off 1-Spark Plug wire and take plug out also, Put spark plug back in the Wire. Have someone crank the engine over,and see if theres Spark at the Spark Plug.

#3) If your car is'nt even cranking over,then the problem is in either your Ignition switch,starter relay,starter,or it can be as simple as a relay or Fuse, check in your fuse box inside,to make sure ALL fuses are good.

#4) Then under your hood you should see a plastic Cover Fuse and Relay Block as well, Check these also,Mainly if its labeled Crank,or starter. Also check your Starter relay. they are a Larger componet in the box under your hood.

#5) to check this relay you'll need a OHM meter to check for resistance. also check the EMC Fuses or Relays.

#6) if no fuel check fuel pump fuse and replace fuel filter 1st.

#7) If no Spark make check your Coils.I'm sure if you follow these tests you'll locate your problem.

PLEASE let me know how my Solution helped you by Voting for the Quality of my Solution./

Thanks for using FixYa From: d-Hubbs

Sep 19, 2010 | 2004 Chevrolet Venture Passanger

1 Answer

Bmw 330ci 2002 not starting


fuel pump, first thing to look at. it's electric, disconnect a fuel line, crank, no fuel coming out, replace the breakable bosch electric fuel pump.
2nd thing, spark, remove spark plug, ground it to the chassis, crank, if you don't see or feel a spark, it could be a number of things, coil pack, or computer that generates the spark.
Crank Sensor, 3rd thing. just replace it.
After that......could be anything, bad head, bad computer, all things you'll want the dealer to check out. the above 3 things....you can do

May 13, 2010 | 2000 BMW 3 Series

1 Answer

Resistor vs non-resistor spark plugs


resistor spark plugs make zero diff in the way the engine runs, they supress radio noise only, this electrical noise can interfere with the cars radio and other electronics.

Aug 29, 2009 | 2002 Ford Mustang

1 Answer

Rain sometimes causes electrical problems


Find the source of the leak and fix that. Once water gets into the fuse box it will short circuit the componets such as fuses and cause all kinds of problems.

May 28, 2009 | 1999 Ford Expedition

2 Answers

No spark, just put in a new coil, distrbutor isnt dirty or wet, sombody told to check out the littl box's on the fender well, what are these to box's and what is there purpose? Mike 77 cj-5 304 3spd I...


I had the same problem with my 85 cj7 this week, I relpaced the ignition control module, plugs, wires, cap, rotor and the the coil; still had no fire to plugs. the problem turned out to be my distributor, replaced it today and she fired right up. Most likely it was the pick up module in the distributor that went bad.

Nov 30, 2008 | 1983 Jeep CJ7

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...