Question about 2012 Ford Grand C-Max

Open Question

Red info light flashes when car is locked and alarmed

When the car is locked and alarmed the red info light between the fuel and temperature guages flashes. Is this normal?

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

A red light on the dash comes on and starts flashing quickly when I lock the vehicle using the remote key. Is it normal?


Well a flashing red light usually means the alarm system has been activated. Flashing quickly could mean it is faulty and the alarm is not set.

Dec 19, 2015 | 2001 Mitsubishi Pajero Pininfarina

1 Answer

Is there a low fuel light for my 1998 lumina?


The 98 lumina LTZ has No light on dash for low fuel, there is not an indicator for low fuel except for the guage. Don't wait for a light to flash, or you will run out of fuel:)

Sep 11, 2014 | 1998 Chevrolet Lumina

1 Answer

Alarm on my peugeot 406 hdi stopped working red light not flashing


Try battery in fob, might be low. U can try to disconnect car battery for 30 mins to see if it will reset unit.

Apr 05, 2013 | Cars & Trucks

2 Answers

What does small red light on dash at base of windshield on 2011 hyundai sonata mean?


Does the red light have a mark like the door s open r brake light or abs what r u can u post a pic of the red light I can help

Jan 27, 2013 | 2011 Hyundai Sonata 2.4

1 Answer

I bought a 1996 Subaru Impreza L 4dr 5speed AWD that runs and starts fine but when I was installing fog lights i noticed that there appears to be an alarm hooked up (it says "code alarm elite DM...


Battery Constant 12v+ Positive Wire (+): Black/Yellow
Battery Constant 12v+ Positive Wire Location: Ignition Switch Harness

Starter Positive Wire (+): Blue/Red
Starter Positive Wire Location: Ignition Switch Harness

Ignition Positive Wire (+): Red
Ignition Positive Wire Location: Ignition Switch Harness

Accessory Positive Wire (+): Red/Yellow
Accessory Positive Wire Location: Ignition Switch Harness

Parking Light Positive Wire (+): Red
Parking Light Positive Wire Location: Low In Drivers Kick Panel

Power Door Lock Negative Wire (-): Add Actuator. This vehicle uses a central door locking system. When connecting a keyless entry, you will need to add a door lock actuator and some units will also require (2) extra relays.
Power Door Lock Negative Wire Location: To Drivers Door Only

Power Door Unlock Negative Wire (-): Add Actuator. This vehicle uses a central door locking system. When connecting a keyless entry, you will need to add a door lock actuator and some units will also require (2) extra relays.
Power Door Unlock Negative Wire Location: To Drivers Door Only

Door Trigger Negative Wire (-): Red/White
Door Trigger Negative Wire Location: In Black Plug, Above Hood Release

Domelight Supervision Wire: Use Door Trigger, Requires Relay
Domelight Supervision Wire Location: N/A

Horn Negative Wire (-): Red/Green
Horn Negative Wire Location: At Steering Column Harness

Tachometer Wire Negative Wire (-): Black/Blue
Tachometer Wire Negative Wire Location: At ECM, Under Drivers Side Dash

Brake Light Positive Wire (+): White/Black
Brake Light Positive Wire Location: At Switch Above Brake Pedal

CODE ALARM SYSTEM

Used on:
Impreza 1996-2001
Legacy 1995-1999
Forester 1998-2000

codealarmremote2.jpgBattery GP-23A

Lock: Left button will lock all doors. Double chirp indicates locked.
Unlock: Right button will unlock driver's door only. Hold unlock button app 6 seconds, it will unlock all doors including rear gate. Single chirp indicated unlock.
If the car chirps or lights flash 4x the alarm was triggered.
Panic. Press both buttons to activate emergency honk and flashing lights.
Valet mode: With optional alarm onlyPress the red alarm button on the left of the steering wheel. The light will quickly double flash. To re-set back to normal mode, press the red alarm light button again

Battery failed and lights flashing?
Parking lights will flash when the vehicle's battery is disconnected and reconnected.
To stop lights from flashing, either:
Press remote transmitter "UNLOCK" button once OR turn the ignition switch to the "ON" position and press programming button for one second (see below).
The vehicle interior (courtesy) light and door open warning light (DOOR AJAR indicator) will then illuminate for 60 seconds when the ignition is turned off, or until the doors are locked with the remote transmitter. Yes, the dashboard instrument panel lights will flash when the parking lights flash.

Programming or Overriding the Alarm when you have lost the remote
Open driver's door.
Turn ignition key to 'On'
Press and *hold programming button* in (see diagram, button under dashboard)
After 15 seconds the the door locks will cycle 3 times. Do not release Programming button.
Press lock (left) button the remotes to be programmed. The door locks will cycle one time. Exit programming mode by releasing Programming button under dashboard and turning key to off.


codealarmremote1.jpgCode Alarm Programming Button is under dashboard on the kick panel by the driver's left knee, left of the steering column. If you can't find it, it might still be tucked up in the wiring harness higher up in that same general area. The botton is recessed in a plastic ring (see diagram).
This button must be pressed while programming remotes or if the battery was disconnected and the lights are flashing.

Jan 05, 2011 | Subaru Impreza Cars & Trucks

2 Answers

What would make my 2004 Hyundai Sonata run hot when i stop at red lights drive throughtsect but cools back down when i start driving again


my 2003 just stopped running as i made a left turn everything works on it lights alarm ect it just wont start now it trys but wonk and one can help please and thank you

Jun 30, 2010 | Hyundai Motor 2003 Sonata

1 Answer

My brother has leant me his 1993 Ford fairmont EB11. A red light is flashing intermiitanly it looks like a fan in some kind of cylinder. Could someone tell me what it is?


  • Full instrumentation pack (four ancillary guages plus tachometer) - with volt meter & oil pressure guage.
  • Speedometer, odometer, tripmeter, fuel guage & water temperature guage standard in addition to the above.
  • WARNING LIGHTS: High beam, rear window demist on, turn signal / hazard light, alternator fail, lights on, park-brake on, washer fluid low, radiator coolant low, cruise control indicator and low oil pressure.
  • AUDIBLE WARNING CHIMES: low fuel, lights on, low alternator charge, low oil pressure, high coolant temperature and brake failure.
  • Trip Computer standard featuring fuel consumption figures, distance to empty, average speed & time display.
I found this site, no mention of the fan in a cylinder, but I'll let you figure it out. Hope this helps.
http://www.trueblueford.com/ed_pages/EDfalcon_fairmont.html

May 31, 2010 | 1983 Ford Fairmont

2 Answers

Alarm red light stays on after you shut the car off 1998chrysler


I would turn the key on without starting the car then press and hold the black button till the alarm light flashes.Then turn key off take out of car and try the fob again.

Mar 29, 2009 | 1998 Chrysler Cirrus

Not finding what you are looking for?
2012 Ford Grand C-Max Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...