Question about 1999 Dodge Dakota

Open Question

920 921 999 960 for dodge dakota 2002

No bus

Posted by Anonymous on


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 702 Answers

SOURCE: odo'no bus after mileage flashes four times 99 dodge dakota

Clean your negative battery cable end and battery post. The "no bus" usually is caused from a bad ground.

Posted on Dec 21, 2008

  • 1 Answer

SOURCE: 2001 dodge dakota crank no start

Just had that problem w/ my 01 Dekota, it was the resistor that used to be mounted on the firewall and easy to get to but that is now mounted low on the back of the engine jammed into a bey tight position. I couldn't get to it myself, so ended up taking it to neighborhood garage. Cost me about $150

Posted on Apr 16, 2009

  • 112 Answers

SOURCE: 2002 Dodge Dakota 4WD Sport, 6 cylinder. Gear

look at the shifter linkage, and as far as the heat check your heater core

Posted on Dec 05, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2002 dodge ram 1500 starts right up every time, but dies in 2-3 seconds. Shows code p1686 (no skim bus message received) but I do not hav a chipped key. Please help!!

Have you changed the ignition switch or PCM recently? The PCM is expecting to receive a signal through the PCI bus that a valid key has been inserted into the ignition switch and read by the SKIM (sentry key immobilizer module) attached to the ignition switch. You need to have the PCM programmed (by the dealer or someone who has a DRB Scan Tool - factory type scan tool), to let it know that you do not have the SKIS (system) installed in your Dakota.

Dec 03, 2017 | Dodge Cars & Trucks

1 Answer

03 Dakota no bus no start 3.9 disconnected all sensors still no bus?

There have been several proposed fixes for this, but nothing works for every case. You can check that the ground wires are properly grounded (pins 31 and 32 on connector #1, black wires with tan tracer). Or you may need to replace the PCM. See the link from YouTube.
1998 Dodge Durango No Start or No Bus or Randomly Stalls

Apr 04, 2017 | 2003 Dodge Dakota

1 Answer

2002 dodge dakota slt 4x4 4.7 ltr key on eng off all lights come on on the ipc then go off after 15 sec start to come on one by one then odo blinks 4x goes to no bus. Vehicle starts and runs fine no ecm...

with no bus, that is power to or from the pcm. try wiggling the 3 plugs at the pcm with the key on. if you see lights change, or hear the bing, that would most likely be the pcm.

Jan 16, 2014 | 2000 Dodge Durango

1 Answer

No bus

have you reset the cpu to adjust it to the new sensors. Did you use genuine sensors as the cpu will not always recognise aftermarket units and reads them as faulty

Jul 04, 2013 | Dodge Dakota Cars & Trucks

2 Answers

Ecm no bus?

sounds like you have a bad Body Control Module. Its the small computer that controls all the ground signals.

Dec 03, 2012 | 2002 Dodge Dakota Club Cab

1 Answer

2002 dakota wont start

hav e ign. switch checked a lot of these problems come from these switches on all cars and trucks after they are a few years old, simple but usually fixes.

May 13, 2012 | 2000 Dodge Dakota Quad Cab

1 Answer

Dakota - 2001, started, died and won't start. all dash indicators light as normal except odometer says "No Bus."

Hi, if odometer say no bus you are loosing your bus signal some were ,with out a bus signal the car not going to run the bus signal runs to every module on your truck. This could be as easy as a blow en fuse to a wire shorted out or a bad module . Depends on your know how around cars . If your not sure you should take to local shop or dealer. If i can help you further just re post.
Thanks dodge tec

Jan 02, 2011 | 2001 Dodge Dakota

2 Answers

Odo'no bus after mileage flashes four times 99 dodge dakota

Clean your negative battery cable end and battery post. The "no bus" usually is caused from a bad ground.

Dec 21, 2008 | 1999 Dodge Dakota

Not finding what you are looking for?
1999 Dodge Dakota Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides