Question about 2001 Volkswagen Beetle

Open Question

Vw beetle convertible rear seats headrest raised

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 102 Answers

SOURCE: how do i change my rear indicator bulb in my 04 beetle?

open rear hatch and look strait down on inside boot well. the plastic trim has access holes that pop out on either side just behind the lights. pop out the access cover on the side with burnt bulb, then reach inside that hole and you will fins a large plastic "wingnut", unscrew it<careful not to drop it or you'll have to take the whole boot apart to retrieve it> after removing wingnut carefully pop out lens from outside , replace bulb and reinstall after testing

Posted on Mar 23, 2009

Ad
  • 11 Answers

SOURCE: Need help removing speaker from rear of vw beetle

What i do is lean back seat forward, lift gentley on the back bottom and move toward a diagnal upward motion. make sure you hear it release from the top locks or support.

Posted on May 16, 2009

BeninVa
  • 389 Answers

SOURCE: 2001 VW Beetle. The driver's front seat adjuster

I'm assuming you have manual adjustment seats. There is a spring underneath the seat that locks the end of the lever into corresponding notches in the seat frame rail. That spring has either fallen off or broken.

Posted on Jan 22, 2010

  • 1 Answer

SOURCE: Rear window is leaking on convertible VW Beetle

i had the same problem with my garage-kept 03 bug. I went to a place that specializes in auto tops and glass and they sealed mine for $250.

Posted on Apr 01, 2010

  • 632 Answers

SOURCE: where is the fuse box vw beetle 2003

f493289.jpg
As you see in the first illustration. you can use your key to pry open the cover. It may or it may not contain the fuse locator card.

Posted on May 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to remove the rear headrests on a 2015 BMW 428i convertible?


Rear Headrest removal on Convertible - Bimmerforums

www.bimmerforums.com/.../showthread.php?...Rear-Headrest-removal...
Sep 6, 2008 - So I've searched and I've tried to yank the rear headrests out like what I'm reading and I ... Bimmerforums - The Ultimate BMW Forum - Powered by vBulletin... 3 series & 4 Series (E21, E30, E36, E46, E9x, F30, F32, F33, F44).

convertible - possible to remove rear headrests? (car seat issue ...

www.bimmerfest.com > ... > E90/E91/E92/E93 (2006 - 2013)

Mar 10, 2012 - 25 posts - ‎14 authors
Unfortunately the rear headrests or head restraint gets in the way and ... So as a temporary measure, I'm wondering if it's possible to actually remove the car's rear head restraints? ... HR&G Full Review: 2014 F33 428i M-Sport Convertible (my side .....2001-2015 performanceIX, Inc. All Rights Reserved . 335i convert booster seat - suggestions?
6 posts
Mar 17, 2008
Removing Rear Seats From E36 Convertible, Help!
17 posts
Feb 10, 2006
More results from www.bimmerfest.com

How To Remove Back Headrest BMW E36 - YouTube



Jan 16, 2016 | BMW Cars & Trucks

1 Answer

How do you get to back window regulator of vw beetle?


Remove the rear seat, then the cover for the sides can be removed via screws. This is not an easy job.

Jul 05, 2014 | 2003 Volkswagen New Beetle Convertible

1 Answer

2002 VW Golf Headreast Removal


Same proceedure as front headrests but tilt the back of the seats forward about halfway. Push the little clip in on top of the seat, by the chrome rail, pull the headrest up and slide out of the hole. Push the back of the seat back, lift up the bottom seat and tilt forward. Lay the back seats down. Done.

Jan 26, 2010 | 2002 Volkswagen Golf

1 Answer

Driver's seat that won't lock


seat is held in with 4 bolts. at least 1 electriocal connecter ( 2 if heated). take off headrest, pull the seat and see what's broke/stuck. shouldn't take too long

Dec 08, 2009 | 2003 Volkswagen Beetle TDI

1 Answer

How do you remove rear seat from 2004 vw beetle?


the bottom cushion lifts up from the back and pull it forward then unclip the two hinges from the front then the back seat has has two to four bolts on the bottom then lift up the back cushion

Nov 15, 2009 | 2003 Volkswagen New Beetle Convertible

1 Answer

2009 Toyota RAV4 rear seat headrests


do the rear seats have a recline functin ,slide seat forward , should be handle below the seat, try lowering seat and then slowly raise , this may give a better sitting angle

Jun 02, 2017 | 2009 Toyota RAV4

1 Answer

Same problem with 99


Try running a hose on the driver's door window to see if the drain hoeles in the driver's door are plugged. Also check the drain holes in the rear window and trunk lid drains. If one of the drain holes is plugged the water will seek the next easiest way to drain (which might be to the iside of your VW Beetle.

Jun 04, 2009 | 2003 Volkswagen New Beetle Convertible

1 Answer

How to remove the rear seat headrests on vw touareg so can fold the rear seats


there is a small button by the metal shaft that goes into the seat. push that in while lifting headrest up and it will come out

Jan 11, 2009 | 2005 Volkswagen Touareg

2 Answers

2003 volkswagen beetle covertible quarter panel removal


I do not recommend this job unless you are a seasoned mechanic, VW dealership charges $1000 for a reason. They almost earn it on this one. but heres how it's done or how I did it any way. the complete job took me 4 hours and I been at this for 30 years. But a lot of this time was figuring out how it came apart. First, drop the top, pull up on seat bottom and remove it, remove center panel, remove 3 allen bolts at bottom on seat back and remove. headrests, they just pull off, raise top just enough to make hinged panels flip up. remove nut at top rear corner of side panel. you can see the back side of the nut and bolt it is on from the panels that flip up. Remove Nylon push lock rivet where seat belt goes through panel on rear, top, corner. Pull out on panel to release it, there is 5 or 6 nylon locks that just pull out of holes in the body. It will sound like your breaking it when the locks pop loose, or mine did. then lift to gain access to remove seat belt bolts and unplug flip panel motors. remove cable end from its clip. Pull seat belts through panel. Set panel a side. remove torx head bolt around oval panel that speaker is mounted on. unplug speaker and regulator and pull wire harness thru hole. remove 2 allen and 5 hex bolts at top where window would come out if it worked. pull up on plate and move rubber window seal to the side to remove plate. remove 2 nuts at bottom of regulator and one about half way up towards front, lift regulator and window up through top to gain access to 3 nuts that hold window to regulator, from the top lift window out first then regulator. Reverse to assemble it.

Aug 12, 2008 | 2003 Volkswagen New Beetle Convertible

1 Answer

Window track


I do not recommend this job unless you are a seasoned mechanic, VW dealership charges $1000 for a reason. They almost earn it on this one. but heres how it's done or how I did it any way. the complete job took me 4 hours and I been at this for 30 years. But a lot of this time was figuring out how it came apart. First, drop the top, pull up on seat bottom and remove it, remove center panel, remove 3 allen bolts at bottom on seat back and remove. headrests, they just pull off, raise top just enough to make hinged panels flip up. remove nut at top rear corner of side panel. you can see the back side of the nut and bolt it is on from the panels that flip up. Remove Nylon push lock rivet where seat belt goes through panel on rear, top, corner. Pull out on panel to release it, there is 5 or 6 nylon locks that just pull out of holes in the body. It will sound like your breaking it when the locks pop loose, or mine did. then lift to gain access to remove seat belt bolts and unplug flip panel motors. remove cable end from its clip. Pull seat belts through panel. Set panel a side. remove torx head bolt around oval panel that speaker is mounted on. unplug speaker and regulator and pull wire harness thru hole. remove 2 allen and 5 hex bolts at top where window would come out if it worked. pull up on plate and move rubber window seal to the side to remove plate. remove 2 nuts at bottom of regulator and one about half way up towards front, lift regulator and window up through top to gain access to 3 nuts that hold window to regulator, from the top lift window out first then regulator. Reverse to assemble it.

Aug 05, 2008 | 2003 Volkswagen New Beetle Convertible

Not finding what you are looking for?
2001 Volkswagen Beetle Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76691 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...