Question about 2003 Toyota Celica

Open Question

How do I change the light bulb in the gear shift lever on a 2005 sienna van

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


SOURCE: tail light

Hi Melony63k,
Open the rear door and look at the back corner of the body where you see under the carpet some eight mm nuts...take those out and the cluster will come can then replace the bulbs....
Regards Johngee10

Posted on Sep 03, 2008

  • 1 Answer

SOURCE: gear Shift Light

Is the power Steering fluid for a 96 Corolla the same fluid for the transmission?

Posted on Jan 16, 2009

  • 3854 Answers

SOURCE: How to replace light bulbs in the dash board of a

Get a Toyota shop manual before you attack the dash. There are a number of screws and clips that are not obvious, and there is a good chance you will get frustrated and break something if you just go at it.
On the Sienna, Your going to remove a good portion of the dash just to change light bulbs on the instrument cluster.

Get a shop manual, and the job will go smoothly. I would have not figured it out half the things is do without the instructions to what i am working on.

I know the dashboard HAS to come off. This may not help but I'm sure if you check the dealer they can give you an estimate of time/labor vs part cost.

Knowing the cost will make you invest in a shop manual, or you can go to Auto Zone or Parts Source for a print out, there free and you can get the parts from there too.
Good luck.

Posted on May 04, 2009

  • 146 Answers

SOURCE: My A/T shift lever light is out in the console?

Remove upper console cover, remove console box carpet, remove parking brake hole cover assembly, then remove console to access light under shift assembly. Here is a picture, thanks.

Posted on Jan 27, 2010

Testimonial: "Thank you very much. That is exactly what I needed!!!! Excellent help!"

  • 1 Answer

SOURCE: how do I replace the dome light bulb in my sienna

It's easy - the plastic covers will pop off if you gently use a screw driver to pry the three points of contact on each cover. There are 2 posts in the middle going into the outside edge, and one clip at the end. The covers come off and you can easily replace the bulbs - forget about opening the garage door oopener and removing the screws - that won't work (I tried!).

Posted on Feb 13, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Backed out of driveway, van would not come out of reverse. pushed to side of road. dash light stays on "R" and van will not start at all

Sounds like a possible shift linkage problem. Follow linkage back from your transmission, look for bent levers, broken or bound up pivoting connections. The neutral start switch prevents starting of engine when transmission is not in neutral or park.

Aug 02, 2015 | 2004 Toyota Sienna

1 Answer

Battery fully charged, engine won't start or even turn over, gear locked in park, brake pedal is depressed.

This may help:
There are multiple issues here.Won't crank? Go direct to starter.

Possible recall:

Nov 10, 2014 | 2004 Toyota Sienna

1 Answer

Gear shift stuck in park 2004 sienna

check stop lamps is working. if its not working check stop fuse on fuse box located under the dashboard.

Oct 07, 2014 | 2004 Toyota Sienna

1 Answer

Why is my van stuck in neutral and how do I fix it?

Could have possibly broken the shifter cable, or one of the ends might have come off, either of the shifter or the transmission.

Jul 26, 2014 | 2004 Toyota Sienna

1 Answer

2005 dodge grand caravan dashboard reads reverse but gear is in park will not start, took positive and negative term off. Took out the fuses for the ingition switch and battery. Pulled on the gear under...

Maybe something wrong with neutral switch? Usually it is on or close to transaxle shift lever, follow the shift cable to shift lever, the switch has multiple wire connector.
It may be possible to start vehicle by jumping the load side of starter relay, key on. There are safety issues trying this, the vehicle will crank in any gear. Make sure tranny is out of gear, parking brake is set, block the wheels, whatever it takes to be safe, safety is your responsibility.
If the problem isn't that neutral switch, then I don't know? Any applicable trouble codes?

Jul 09, 2017 | 2001 Dodge Caravan

1 Answer

Replaced a tail light and now vehicle not registering brakes are being pressed.

some times on these the brain tells there was a fault now you have changed the bulb the brain still thinks the fault is still there you can disconect the battery for 10 mins then put the battery back on and hopfully the brain should have reset hope this helps

Feb 16, 2012 | 2005 Toyota Sienna

2 Answers

No light in gear shifting pad

If it's a flood shift under the pad where it reads P-R-N-D-2-1 will be a small light bulb under that, your will have to remove the shell to get to it, not very hard job to do.

Jun 30, 2010 | 1998 Toyota Corolla

1 Answer

Right side brake light was not working, so i took it out to change the light bulb if the bulb was bad but the bulb still works. I placed it back in and now none of the rear brake lights work and the...

Check your brake light fuse, also make sure you installed the bulb in the right way, if not in the right way will blow a fuse and will also not let you shift gear's due to blown fuse.

Jun 11, 2010 | 2004 Toyota Sienna

1 Answer

ABS light, gear won't change

Sounds like he may have blown the brake light fuse while messing with the bulb. Make sure the correct bulb is installed. It should be a double filament bulb not a single.The wrong bulb will blow the fuse.
The shift lock solenoid uses the brake light switch to unlock.
The ABS code will be for the brake light system and will clear itself when the power is restored to the brake light switch.

Apr 05, 2009 | 2008 Toyota Sienna

Not finding what you are looking for?
2003 Toyota Celica Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides