Question about Cars & Trucks

Open Question

Peugeot 307 fault codes

307 1.4 16v wont start fault code p1622

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1779 Answers

SOURCE: fault code

P0320 Ignition/Distributor engine speed input circuit
countrycurt0

Posted on Sep 05, 2008

Ad
  • 1 Answer

SOURCE: peugeot 307 heater blower fault

Hi
i just had the same fault, but being in the trade it is normally only 1 of 2 problems.
the heater resitor packing up or the wiring loom.
both can be bought through peugeot.
try the heater resistor first (£40). to find it undo 7 star screws to remove glove box then look in behind centre conlsole near back of radio diconnect the black plug with a red and black cable. twist back of fan motor clockwise and remove fan(it's a bit of a tight squeeze to remove),then put your hand inside the hole you just made till you feel the flat resistor turn this anti-clockwise and disconnect green plug then reassemble as removed,

if this does not fix it then it is the loom, to remove this it is best to follow the wires from the back of fan motor up to where i think if i remember lead to 2 other plugs 1 green and 1 black on the way to another green plug up behind the drivers foot well, then thread the new loom back the same way.

on the 405 i think the resistor is in behind the fan motor accessed throgh the driver side footwell again you need to first take out the fan motor normally twisted anti-clockwise. it is un common for 405 to burn out heat resistors it is normally down to a wire fault.

hope this helps

Posted on Jan 18, 2009

  • 93 Answers

SOURCE: peugeot 307 1.6 petrol central locking problem

leave ign off with key out 3mins disconnet battery 5 mins reconnett and press lock/ unlock repeatedly until locks cycle through to re sync try this any probs come back to me

Posted on Feb 23, 2009

  • 6982 Answers

SOURCE: i want to change my battery,on my peugeot 307 2ltr

There is an item called a "setting saver" or something like that. It's a small power supply that plugs into the cigarette lighter, that keeps radio and computer active while changing battery. (I imagine you could make one by attaching a cigarette lighter power adapter to a good battery and plugging it in there.Don't use one with a transformer, just straight 12v!

Posted on Apr 18, 2009

  • 205 Answers

SOURCE: "when do i change the cam belt on a peugeot 307 sw diesel"

usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.

Posted on Sep 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 peugeot 307 diesel fault code I509141 can you tell me what it is please.


Sorry but that is not an ODB fault code. If it is 1509 then that is Idle Control System problem

Jun 11, 2017 | Peugeot Cars & Trucks

1 Answer

Hi my peugeot 307 is showing red light fLASHES ON THE CENTRAL loking button on dash and the car is not start


does the engine turn over, if not it could be a fault with the immobilizer, you will really need to get a code scanner to see what the code is, even a cheap one would do just to read the code stored, also can you check your key still has its chip in the key housing as if this is lost ie fell out the engine will not start as it needs this to un do the immobilizer..

May 23, 2017 | Peugeot Cars & Trucks

1 Answer

P01676 the vehicle can't start


The code is listed as Wiring, alternator, battery discharged, multifunction control module for a 307/407 (see link below:)
PEUGEOT 307 407 807 FaultCodes 0601

There is very little information for your particular model. Though I would suspect it is the same fault.
Check all cables to and from the alternator for burning or damage/corrosion. Make sure they are clean and tight.

If the car still doesn't start, try disconnecting the cables from the rear of the alternator and then try starting it.

However, it may relate to a poor signal to/from the injectors.

Try cleaning the electrical connectors on the injectors and make sure any earth wires aren't corroded and are securely tightened.

You can try disconnecting your battery at the positive terminal for 30 minutes (but remember you will probably lose your radio code..).

Mar 09, 2016 | 2008 Peugeot 308 1.4

1 Answer

How to fix Nissan Navara fault code p1622 injector adjustment value


PDF]check intermittent incident - Control System

controlsystem.pl/manual/NAVARA_D40_OVERVIEW_MANUAL.pdf
Fuel Injection Timing Control System .......... .......... 20 ... Fuel Pump Learning Value Clearing .......... ........... 24. Injector Adjustment Value Registration . ... Diagnostic Trouble Code (DTC) . ...... DTC P1622 INJECTOR ADJUSTMENT VALUE .... 271.

Nov 07, 2015 | Nissan Cars & Trucks

1 Answer

How do I fix fault code 1622 Nissan Navara


P1622 - Engine-Codes.com

www.engine-codes.com/p1622.html
Possible Causes and Repair Information for P1622 code. Learn what does P1622means? P1622 Immobilizer ID Does Not Match.

Fault code p1622 nissan navara d40 - Fixya

www.fixya.com/cars/t17579043-fault_code_p1622_nissan_navara_d40
Apr 8, 2013 - This fault code comes up on scan guage. Would any one know what it ... dealer only to reset factory immobiliser ... The best, and in fact the only

Nov 07, 2015 | Nissan Cars & Trucks

1 Answer

Peugeot 307 fault codes


code p2144 refers to exhaust gas recirculation (EGR) vent control--circuit low===causes wiring short to ground--EGR vent control.
Check the condition of the wiring and if ok then replace the vent control

May 11, 2014 | 2005 Peugeot 307 1.4

1 Answer

U0500 error code


Invalid data received from various possible modules. You need someone with a GOOD scan tool to help diagnose.

Mar 07, 2014 | Cars & Trucks

1 Answer

307 fuel fault blocked filter and pollution fault on dash HELP


Try disconnecting your battery , this should reboot it and remove the code .

Jul 26, 2009 | 1987 Peugeot Liberte

2 Answers

"when do i change the cam belt on a peugeot 307 sw diesel"


usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.

Apr 15, 2009 | 2005 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...