Question about 1992 Ford Econoline

Open Question

1992 Ford Econline E 150 Van 5.8 Coolant temperature sensor

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2427 Answers

SOURCE: 1993 Ford Van Econoline 150

Try changing the throttle body position sensor, or the ideling screw. , Service the fuel injection system (injectors and filter) have the gas tank washed as there could be rust paricles in it. and if that fails you will need to have an engine job done. Chances are the pistons are worn out or the rings are bad.

Other possible causes are the torque converter or the transmission itself, However if it coccurs with the ac, it means that it happens when extra stress is on the engine. This is caused by eighter the fuel system or the engine itself.

Posted on Jul 30, 2008

  • 169 Answers

SOURCE: sensor locations

air intake look at snorkel it could be part of mass air flow check intake for eng coolant

Posted on Aug 29, 2009

ZJLimited
  • 17970 Answers

SOURCE: where is the temperature sensor for a ford e-150

1994 Ford Truck E150 1/2 ton Van 5.8L MFI 8cyl Temperature Switch is located: Front seating area, center, under engine cover, front driver side of intake manifold, mounted in engine block.

The ECT sensor (Engine Coolant Temperature Sensor) is located either in the heater supply tube at the rear of the engine, or in the lower intake manifold. The ECT sensor is a thermistor (changes resistance as temperature changes). The sensor detects the temperature of engine coolant and provides a corresponding signal to the PCM. From this signal, the PCM will modify the air/fuel ratio (mixture), idle speed, spark advance, EGR and canister purge control. When the engine coolant is cold, the ECT sensor signal causes the PCM to provide enrichment to the air/fuel ratio for good cold drive-away; as engine coolant warms up, the voltage will drop.

c1fb19f.gif

Engine component locations-1994 5.8L engines

I hope help you with this, good luck (remember rated this help).

Posted on Sep 02, 2009

  • 1 Answer

SOURCE: i cant find the IAT sensor on my 98 ford explorer XLT v 6 SOHC

I have a 99 ford explorer 4x4, v-6 with a 4.0 engine I can not locate the IAT sensor. It is not located on the hose connected to the air filter. Where else could this sensor be?

Posted on Apr 07, 2010

Sandpiper99
  • 71 Answers

SOURCE: need to located the temperature sensor on 2002

The coolant temperature is measured from the cylinder head temperature sensor CHT and is located on the drivers side cylinder head in the rear. It is connected to the harness by connector C107 and has gray/red and yellow/light green wires going to pins 39 and 55 of the processor.

Posted on Apr 07, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Coolant temperature sensor location on 97 ford expedition


I believe they are located in the intake manifold somewhere. Make sure the one that tells the computer the coolant temp is ACTUALLY giving out the correct temperature. I had a bad one one time in a 1993 Ford F-150, 5.8L....... no check engine light came on but hard to start. The bad sensor was telling the computer it was 32 degrees F when it was almost 80 degrees outside.!!
Garbage in=Garbage out.

Here is a video link from Youtube. There are 2 sensors, 1 for the guage and the other tells the on-board computer how hot/cold the coolant is. The one for the guage has 1-wire and the other one has 2 wires.
Hope this helps, ask more if you need to. What kind of problem are you having? No heat inside? Guage needle not getting into the normal area?


1997 Ford Expedition 5 4L V8 Triton Engine Coolant Temperature ECT Sensor...

Oct 20, 2015 | Ford Cars & Trucks

1 Answer

Can I deactivate my speed control switch on a 1993 e-350 ford econline van by myself? and how


Remove the fuse---the 93's are the ones that Ford had recalls on because they were catching on fire. If your Van hasn't been in for the recall, you can still have it done---takes about 5 minutes to change the switch---Hope this helps.

Jul 06, 2011 | Ford E-350 Cars & Trucks

1 Answer

My 86 ford econline van died and won't start, replaced fuel pump, coil, plugs, ignition modular, fuel relay, fuel pump won't kick on


checkout the crank sensor give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your Van wish you the best of luck Michigan Man.

Mar 08, 2010 | 1986 Ford Econoline

2 Answers

1992 Ford Taurus with a 3.8l V6 the cooling fan


The Taurus has Two temp sensors. One for the dash, which is isolated, then one for the PCM, it also controls when the fan relay should actuate. Its a 2 wire sensor, just above the thermostat. If you remove the harness from that sensor, and the cooling fan comes on, at any temp, (should take 5- 10 seconds) then thats your fault.

Sep 16, 2009 | 1992 Ford Taurus

2 Answers

Where is the temperature sensor for a ford e-150 van 1994 on a 300ci v-8 engine. Thanks rick


1994 Ford Truck E150 1/2 ton Van 5.8L MFI 8cyl Temperature Switch is located: Front seating area, center, under engine cover, front driver side of intake manifold, mounted in engine block.

The ECT sensor (Engine Coolant Temperature Sensor) is located either in the heater supply tube at the rear of the engine, or in the lower intake manifold. The ECT sensor is a thermistor (changes resistance as temperature changes). The sensor detects the temperature of engine coolant and provides a corresponding signal to the PCM. From this signal, the PCM will modify the air/fuel ratio (mixture), idle speed, spark advance, EGR and canister purge control. When the engine coolant is cold, the ECT sensor signal causes the PCM to provide enrichment to the air/fuel ratio for good cold drive-away; as engine coolant warms up, the voltage will drop.

c1fb19f.gif

Engine component locations-1994 5.8L engines

I hope help you with this, good luck (remember rated this help).

Sep 02, 2009 | 2002 Ford E-Series

2 Answers

1992 plymouth grand voyager


yes, the engine gets hot and has a shut off to protect it from overheating to badly. Repair the fan and see if the problem is corrected. If not please let me know. Thanks

May 28, 2009 | 1992 Plymouth Grand Voyager

1 Answer

Where is the engine coolant sensor located on a 2000 ford f150 V8 4.6 L?


please rate as fixya if this helps

SECTION 303-14: Electronic Engine Controls 2000 F-150 Workshop Manual
REMOVAL AND INSTALLATION Engine Coolant Temperature (ECT) Sensor — 4.6L and 5.4L Removal and Installation
  1. Remove the engine coolant temperature (ECT) sensor.
    1. Disconnect the electrical connector.
    1. Remove the ECT sensor.
ae8a8e7.gif The ECT sensor:
  • sends the PCM a signal indicating engine temperature.
  • resistance decreases as coolant temperature increases.
The ECT measures the temperature of the engine coolant. The sensor is threaded into an engine coolant passage.

Mar 19, 2009 | 2000 Ford F150 Flareside SuperCab

1 Answer

REPLACE FUEL PUMP REGULATOR


What engine? It is attached to the fuel rail.

Mar 14, 2009 | 1997 Ford Econoline

Not finding what you are looking for?
1992 Ford Econoline Logo

Related Topics:

254 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...