Question about Cars & Trucks

Open Question

How to change water pump on mazda etude 1.6 2003

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
elias_sgr
  • 163 Answers

SOURCE: Mazda etude alternator genarting excessive heat

1st off you would give everything a good visual examination. Look for loose alternator belt. Also look for wires that could have become disconnected or cut that leads to the alternator.

Then you would hook up a volt meter to the battery cables and check the voltage.
After this you would start the engine and recheck the voltage. The voltage on a charged battery should read around 12.5 volts. While the engine is running turn on a few accesories and speed up the idle a little the voltage should read around 14.5 volts.

If the voltage does not increase suspect either a faulty alternator or regulator.

Posted on Sep 09, 2008

Ad
  • 1 Answer

SOURCE: Mazda Etude 160ie timing

I have a problem with the mazda etude 160ise, the crank shaft sensor was damages and replaced it ad now the car cant tart. Note that the timing was afected in that the two sealings were replaced. Could one please provide information as to how I can get in timing and get it going again.

Posted on Nov 27, 2010

astrawoid
  • 294 Answers

SOURCE: my mazda etude is having

Remove that plug and turn engine over. Does water shoot out of the spark plug hole? Head gasket leak, cylinder-to-coolant channel side. Do you see any water vapor or actual water out of your exhaust when you first start it?

Posted on Nov 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi my Mazda etude 1999 model is overheating oil the water is boiling in side the cooler once you switch off the engine but inside the deshboard the heat gaurd its normal so I don't know what wrong


Sounds like you may have a blown head gasket. If there is oil in the coolant, and musty brown look and smells bad that's the culprit. I would do a rad flush and oil change and see what happens next...

Dec 21, 2016 | Mazda Cars & Trucks

1 Answer

Mazda Etude 180 ise produces a screeching sound and overheats, over a short distance. What can it possibly be, water pump or radiator, belts ,,,,, ? So depressing.


belt squeal
check tensioinand condition the drive belt to the water pump
or if the timing belt drives the water pump thats a bigger job

suspect a blown head gasket
if it boils out of the radiator

oil in coolant
coolant or water bubbles on dip stick

flush the radiator
refill with new coolant
replace
any old or leaking hoses
the thermostat
make sure the engine cooling fans turn and spin fast enough to cool

26283902-hqlp0u1nbg0jlwxya0exdpqt-2-0.jpg

Sep 16, 2016 | Mazda Cars & Trucks

1 Answer

My Mazda etude is showing overheating though fans are working, what maybe the problem?


there are a few things that come to mind. the water pump is bad, the radiator is clogged or leaking, you dont have enought coolant, the thermostat is bad. go through each of these .

Feb 01, 2015 | Mazda Cars & Trucks

1 Answer

Mazda etude clutch problem


sounds like a throw out bearing to me but it could just be a spring popping

Jan 29, 2014 | Mazda Cars & Trucks

2 Answers

Does Mazda etude 2001 model have a fuel filter if so Where is it located?


2000 and newer Mazda Etude and does not have a fuel filter.

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day

Dec 19, 2011 | Cars & Trucks

1 Answer

My mazda etude is having water in one of the spark plugs


Remove that plug and turn engine over. Does water shoot out of the spark plug hole? Head gasket leak, cylinder-to-coolant channel side. Do you see any water vapor or actual water out of your exhaust when you first start it?

Nov 28, 2010 | 1997 Mazda Protege

1 Answer

My 160i etude 1997 misfires and even mazda agents


it is not carburated injectors are most likley leaking

Dec 15, 2009 | Mazda MAZDA3 Cars & Trucks

2 Answers

Mazda Etude 160ie timing


I have a problem with the mazda etude 160ise, the crank shaft sensor was damages and replaced it ad now the car cant tart. Note that the timing was afected in that the two sealings were replaced. Could one please provide information as to how I can get in timing and get it going again.

Jan 02, 2009 | 2004 Mazda 3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...