Question about Lincoln Town Car

Open Question

Lincoln town car p1000 code - Town Car Lincoln Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
old marine
  • 2005 Answers

SOURCE: need routing diagram for 2000 lincoln town car serpentine belt

There's a diagram at this link.

Posted on May 11, 2009

Ad
Mr BrokRench
  • 1623 Answers

SOURCE: heat wont work 2001 lincoln town car cartia

Hello Callahan5922....this sounds like a stuck blower motor resistor. I assume the blower won't function in the a/c mode either? If you have a digital multimeter you can check this. I believe it's fuse #2....if the digital indicator goes up or down when you increase or decrease the fan speed thats good. Locate the blower motor resistor....you wil find it located on the fire wall behind the right valve cover hiding behind the heater hose, it's about the size of a cigarette pack. With the engine off, and key in on position, turn the A/C on High, and rap a tap tap tap on the resistor. You might be suprised when the blower motor takes off a runnin,
I hope this is the answer you need and i was able to help solve this for you. Good luck...

Posted on May 13, 2009

  • 5 Answers

SOURCE: 1997 lincoln town car 4.6 with a p0430 fault code

I will make an assumption here, we know what the root word means. This code was extracted from the computer by? What this is telling you one of 2 things: The Bank 2 oxygen sensor down stream of the catalytic converter (there are 2 converters, one for each bank of cylinders on the 4.6ltr engine) is bad and/or that the Bank 2 catalytic converter is no longer doing the job it was designed to do. Simply, Catalysts wear out. They are good for approx 100,000 miles (as required by Federal Law). Again, I assume that the reason the intake manifold was replaced was because it had a crack in one, or more, of the runners? (part that feeds the head of a manifold). It may have taken a while to find this as being the cause of why the car running incorrectly, maybe rough. This means, that during the time the car was being driven with the problem, the amount of unburned, or not within spec exhaust gases, coming off the side of the engine affected by the intake issue was higher than normal. This out of balance level of exhaust gases were being dumped into the converter on that side of the engine, thus causing the converter to have to run hotter, work harder, or even at the time the gas was being processed through, causing deposits to be formed in the converter, thus shortening it's life span. The Bank 1 side of the engine, apparently, did not have the issue and it's catalytic converter's life was not affected. I hope this makes sense to you.

Posted on Aug 19, 2009

  • 1 Answer

SOURCE: 2003 lincoln town car code p0705 & p1702 changed tr sensor only when car starts

03 Town Car transmission whines & taps on very hot days only, changed fluid filter, trans cooler & radiator. Runs great on cool on days under 90 degress.

Posted on Aug 31, 2009

co7196
  • 3433 Answers

SOURCE: 2002 Lincoln Town Car AC Blower Motor Relay Location

Relays are normally located under the hood in a protective plastic box. Good Luck Ned

Posted on Oct 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What do codes P0411, P1000


P1000 code means the codes were cleared or the battery was disconnected
Powertrain Control Module (PCM) Reset Description All OBDII scan tools support the powertrain control module (PCM) reset.
The PCM Reset allows the scan tool to command the PCM to clear all emission-related diagnostic information. When resetting the PCM, a DTC P1000 will be stored in the PCM until all the OBD II system monitors or components have been tested to satisfy a drive cycle, without any other faults occurring. For more information about a drive cycle, refer to Drive Cycles .
The following events occur when a PCM reset is performed:
  • Clears the number of Diagnostic Trouble Codes (DTCs).
  • Clears the DTCs.
  • Clears the freeze frame data.
  • Clears diagnostic monitoring test results.
  • Resets status of the OBD II system monitors.
  • Sets DTC P1000.

P0411 Secondary Air Injection System Incorrect Flow Detected

neither of these could cause a no start or no crank problem . Is the battery good an do you have good connections on the battery ? Do the headlamps show bright when on ?

Oct 14, 2015 | 1997 Lincoln Continental

2 Answers

My car won't start and is showing a p1000 code . What does this mean?


P1000 is a manufacturer specific fault code:

Ford P1000: OBDII Monitor Testing Not Complete.
Jaguar P1000: Engine control module (ECM) - internal error.
Kia P1000: System diagnosis incomplete.
Land Rover P1000: Engine control module (ECM) memory erased - no codes stored.
Mazda P1000: OBDII Drive Cycle Malfunction.

So depending on the manufacturer of your car would depend on the meaning of a P1000 code!

Jan 21, 2015 | Cars & Trucks

1 Answer

How to remedy dtc code P1000


A dtc p1000 isn't a fault code, it basically. means you have to continue to drive you car until all engine monitors finish their test and no faults are happening. When you either disconnect your battery or had someone run a scanner test on it and clear any fault codes, it clears the memory of the p.c.m and monitors that watch certain systems on the car, o2 sensors, misfire, evap system, cat efficiency and others to make sure everything is ok.it has to go through 3 drive cycles and not see any fault for the p1000 code to go away..How long dies a drive cycle take? All cars are different, you have to drive above 70 mph for a certain amount of time, have to do no brake slow to stops a few times, maintain 35 for an amount of time and so on....at the dealership each tech has a sheet copied out of shop manual showing what we have to do to complete a drive cycle.sometimes you get it first shot, sometimes it takes a few trips.just 1 wrong and monitors will not pass..just be patient and continue to drive.Take it out on the highway and drive 10-20 miles and see what happens....happy drivi

Jun 15, 2014 | 1995 Lincoln Town Car

1 Answer

I took my ford freestar to the machanic in town and he replaced all four of my o2 sensors but my check engine light is still on and now it shows that i have a p0054 and a p1000 code now i have to take


code P054 heated oxygen sensor bank 1 sensor 2 heater resistance. code P1000 obd2 moniter testing not complete.get this code when battery power disconnected to the PCM.to fix problem take vechicle to shop they can use a scanner to erase codes reset the PCM.

Feb 18, 2013 | 2004 Ford Freestar

1 Answer

P1000 code after replacing oxygen senser bank 2 on 2006 lincoln navigator


P1000 FORD - On Board Diagnostic System Readiness Test Not Completed (OBD2 Drive Cycle) Google this "Ford OBD2 drive cycle" to read the procedure

Nov 11, 2012 | 2006 Lincoln Navigator

2 Answers

P1000 problem loss of power after 10 minutes


P1000 is not really a fault code, if there are no there are no other codes stored then perform the following:

Disconnect the positive terminal on the battery, hold the terminal to the chassis for 2 - 3 seconds, this defuses the ecu and drains stored data thus clearing P1000.

Now wait 10 minutes.

Then reconnect battery.

Start car *without touching gas pedal*

Leave car idling for a good 5 - 10 minutes then jump in and go on a minimum 12 mile drive, you will need to perform a few normal driving conditions, fast, slow, stop, pull away etc so just a normal day to day trip to the town would suffice.

Hopefully this will sort it, if not report back

Regards

Lloyd


Aug 20, 2010 | 2002 Jaguar X-Type

1 Answer

2002 lincoln ls engine lights?


p1000 dont worry about. That comes up as a subfactor of pulling codes. Definitely no need to sell. Secondary air injection I believe is an electric motor that gives fresh oxygen into exhaust manifold to waste out any leftover fumes. I believe california emmissions only. Need to look at fuses. Sometimes water got in those air motors and temporarily made them short. Might replace a fuse and rock on! Even if it needs the whole unit the car is still worth it. Thanks.

Apr 06, 2009 | 2002 Lincoln LS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...