Question about Cars & Trucks
Caution lights won't go off, power locks and signal lights no longer work. after we pulled a fuse/relay (Omron 5010-6732 12VDC)out. please help
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Car Alarm
sounds like the drivers side key switch has failed remove the interior door panel and there will be a switch attached to the back of the key lock cylinder or around there it should be two or three wires also check the door jamb wire harness where the door closes for any broken or damaged wires, use a vot meter and see if you get power or ground to the opposite side of the switch when you use the key to lock and unlock the door if nothing changes and there is power or ground! at this switch i would replace it, i don't think there is one but if the car has a passenger side key hole try to unlock the car from that side and see if you get the same problem -jeff
Posted on Aug 31, 2008
If the alarm is a "factory" alarm, cycle the key in the ignition from off to on (where the dash indicators light up), 5 times. This is the reset proceedure for the "factory" alarm.
Posted on Nov 04, 2008
the jetta has a faulty alarm system from the factory i have been working on one in my shop. the alarm moddule is inside the dash behind the light switch and has a 10 pin connector and a 6 pin connector. this can be bypassed if you disconnect both connectors and jump the two large wire on the 6 pin connectors, these wires operate your starter. the car will start and run but your alarm will no longer be active. the door locks and everthing else will still work. the only issue i am having is the factory radio isn't working because it is controlled by the alarm. but worse case scenario i can use an aftermarket radio if need be.
Posted on Feb 28, 2009
I found it today.
It's way up under the dash to the right (looking from below) of the steering column. Mine was hidden by a bundle of wires. It is attached to the bottom a white part. (Maybe the fusebox.} You have to push hard towards the rear of the car and it will slide off.. I disconnected it from the socket first, it is held on by a clip.
'94 Concorde, same thing only different.
Posted on May 17, 2009
SOURCE: Does any body know how to reset the ML350 alarm??....The remote control doesn't work after i replaced a new battery to the remote control. I couldn't even use the remote to lock/unlock the car. I was
SOME OF THE REMOTES REQUIRE THAT THE KEY BE IN THE IGNITION, IN THE ON POSITION. TAKE THE BATTERY OUT AND WAIT 10 MINUTES. THEN PUT THE KEY IN THE IGNITION AND INSTALL THE BATTERY WHILE THE KEY IS TURNED TO THE ON POSITION. HOPE THIS HELPS YOU. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK
Posted on May 18, 2009
Tips for a great answer:
Aug 08, 2015 | 2000 Mitsubishi Galant
May 26, 2011 | 2003 Mitsubishi Galant
Jun 20, 2010 | 2003 Mitsubishi Galant
May 11, 2010 | 2006 Mitsubishi Galant
Nov 19, 2009 | 2003 Toyota Corolla
Sep 20, 2009 | 2002 Mitsubishi Galant
Aug 06, 2009 | 1999 Mitsubishi Galant
Apr 06, 2017 | 1999 Mitsubishi Galant
Dec 11, 2017 | Cars & Trucks
30 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: