Question about Cars & Trucks

Open Question

How to adjust 2013 nissan altima headlights - Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

TwinTurboZ
  • 78 Answers

SOURCE: Headlight Aiming/Adjustment

On the sides of the Radiator cross member. Look straight down. Should be a silver colored phillips head screw

Posted on May 15, 2009

mrgreenz
  • 962 Answers

SOURCE: head light 2005 altima

you have to remove the bulbs from inside of the hood in the engine compartment. in some cars you have to remove some "pins' and remove the entire headlight assembly.. You then remove the holder where the lightbulb is located and replace the bulb.

Posted on Nov 18, 2008

motor1258
  • 6674 Answers

SOURCE: dirty headlight lens

Probably vents on backside are plugged up.Little plastic plug like thing, with tiny screen in it. Pulls out and needs cleaning.

Posted on Feb 24, 2009

shadtremonky
  • 353 Answers

SOURCE: When I turn the headlights on my Nissan Altima,

turn it the other way or replace it

Posted on Jun 20, 2009

  • 1986 Answers

SOURCE: adjusting 2001 nissan frontier headlights

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

If you have one adjustment screw, it will control your vertical aim. If you have two adjustment screws, one will control your vertical aim and the other will control your horizontal aim

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Posted on Sep 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Headlight adjustment


Used to adjust headlight beams up or down and left or right, it's located above and to the side of light behind the headlight retainer.

Apr 07, 2010 | 2007 Nissan Altima 3.5 Sedan

1 Answer

Where are my headlight adjustment screws on my 2007 nissan altima?


The entire headlight buckets are easily removed from the top of the engine compartment. Nylon clips and or screws hold them in place. Don't mess with the headlight adjusting screws.The whole assembly comes out and the bulbs turn out by twisting them an eighth of a turn. Be careful not to touch the new bulbs with your hands. Dab on a little silicone ignition grease on the contact points before forcing the new bulbs back in the sockets. Use a paper towel to insert them in the sockets. Grease and or oil from your hands will cause the new bulbs to over heat and break.

Apr 07, 2010 | 2007 Nissan Altima 3.5 Sedan

2 Answers

I would like to change a headlight bulb on a 2003 nissan Altima passenger side how do i do it?


i found answer on Yahoo Answers and Nissan forum. Thanks anyway but don't answer.

Jan 26, 2010 | 2003 Nissan Altima

1 Answer

Headlight Aiming/Adjustment


On the sides of the Radiator cross member. Look straight down. Should be a silver colored phillips head screw

May 10, 2009 | 2004 Nissan Altima

1 Answer

Head lights


Open the hood and get a bright flashlight handy (even in daylight) it will make them easier to spot. Look on top of the headlight assembly 1 st for the left/right screw(s) and then straight into the assembly from the front for the left/right scew(s). The adjustments are not always clearly marked but you will usually see a flathead, phillips. or sometimes a torx head adjustment screw. The front adjustments tune the headlights up/down - the top adjust left/right. Good Luck!!! P.S. the best way to adjust them once you have found the screws is to park about 5 feet away from a garage door at night. Begin adjustments against the beams on the door. They should be directed center left/right and slightly downward up/down.

Sep 25, 2008 | 2002 Nissan Altima

1 Answer

Headlight adjustment


The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Jun 15, 2008 | 2004 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

560 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...