Question about 1987 Chevrolet Blazer

1 Answer

Nothing works on my 1987 blazer,2.8 4wd except the battery and the starter.what is wrong?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

Must be the main computer, or the crank sensor.

Posted on Nov 20, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1987 S10 Blazer runs good then won't start


sounds like the starter is being heat soaked . put a heat shield between the starter and the engine block

Mar 13, 2014 | 2004 Pontiac Grand Prix

1 Answer

Fuel pump,lights,everthing stopped working but battery and starter works


Look for a broken fusible link at the starter power power terminal. Not easy to get to sometimes. May be able to apply power to a power link on the firewall. Look for the thick red wires.

Nov 20, 2013 | 1987 Chevrolet Blazer

4 Answers

My 2006 chevy trailblazer 2wd 6cyl wont start. makes clicking noise, then nothing lights/radio etc work but wont start what is it


You got a jump and it ran fine? It's your battery. The lights and radio are much easier for a battery to handle than spinning a car engine. Again, if all you needed was a jump, you have a bad battery.

Jan 20, 2018 | 2006 Chevrolet Trailblazer

1 Answer

1987 dakota, will not crank over, battery,starter fine, whats wrong?


If automatic could possibly be safety engage on shifter; or if automatic could be the safety switch on clutch. On auto try to rock vehicle and reengage shifter. Standard check clutch switch.

Aug 24, 2012 | 1987 Dodge Dakota

1 Answer

Ive replaced the battery and starter but it still wont turn over' has power and it starts to click but nothing. 1996 chevy blazer


Check that the battery has at least 13.6 volts and if it does the the starter solenoid may be bad as this occurs frequently these days with rebuilt starters. You may need to return the starter for a replacement but before doing that make sure both your battery cables are clean and tight at both ends.

Apr 01, 2011 | 1996 Chevrolet Blazer

1 Answer

1987 k5 blazer dies during driving


Make sure your battery is secured by a good battery hold-down system...if the battery shifts in the tray and the positive terminal touches the fender, the dead short will immediately kill the vehicle.
Also, take the alternator to a parts store and have it tested if your battery is held down firmly. The whining noise can be bad alternator bearings. On a vehicle of this vintage, this is a possibility for the noise. It is furthermore possible that the alternator has died electrically, and during a lengthy drive, the vehicle's own electrical consumption will drain the battery and the vehicle will die en route.
When you jump it off, it gets enough charge from the donor vehicle to drive, but if the alternator is dead, it can't keep the vehicle supplied with enough energy to operate.

Feb 14, 2010 | 1987 Chevrolet Blazer

1 Answer

How do i change the starter on a 1987 chev blazer


I am assuming your Blazer is an S10 4 wheel drive with a 6 cyl. engine (if i'm wrong...let me know). As you can see by this web link: (copy & paste) http://www.autozone.com/autozone/catalog/parts/partsShelf.jsp?displayName=Starter&currentPage=1&categoryDisplayName=External+Engine&navValue=15300045&itemId=45-0&parentId=53-0

The diagram shows that it is located under the vehicle and held in place by at least two long hex head bolts. Before removing it's a good practice to take off your positive cable at the battery first. Now remove electrical wires at the starter and then unbolt it, or sometimes its easier to get at the electrical wires if you unbolt it first, but be careful...the starter is quite heavy! Make sure to hold it up while unbolting so it won't just fall to the ground and possibly causing damage to the electrical wires still attached! Always better if you can remove the wires first to avoid that from happening. Now reverse the process to install your new one...and last...to put your cable back on the battery. Hope I helped you!

Nov 10, 2009 | 1987 Chevrolet Blazer

1 Answer

97 blazer starts when it feels like


Could be a bad starter motor or a bad starter switch.

May 08, 2009 | 1997 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...