First check the fuse(s). Make sure you look carefully in the owner's manual, as some of those random items have multiple fuses and share fuses w/ other components... so make sure you check all applicable fuses.
If the fuses are all good, then you'll probably have to replace either the switch(es) or the motor... the major problem being that you usually cannot return electrical parts that are not actually defective, so trying one and then the other could be more expensive than just taking it to a shop and saying "doesn't work, fix it". Ditto for if it turns out to be an electrical wiring problem/short.
SOURCE: 1996 Volvo 960, Driver's motorized seat stuck
maybe you got pennies money stuck in the track if not you got 1 motor for that the motor goes in a assembly in there you have 2 cable a left and a right lock under the seat you probably got the right cale disconnect sometime there stuff that push under the seat and push that cable off if its that just push the cable back in let me know and please if you can take the time to rate this thank you pierre
p.s when you try to put the cable back in dont force to mush
PIERRE
SOURCE: Ford drivers side heated seat doesn't work any ideas?
Most likely one of the heater elements in either the seat cushion or seat back is open.It leaves the module and goes to the seat back on the YE/LB wire thru the seat back and leaves there on the GY/LB wire and goes to the seat cushion and leaves there on the VT/LB. An open in either one of these will cause it not to work.Usally its the seat cushion one that goes bad.
You can test them with an ohm meter and you can get the heated element seperate. Just have to remove the cover to replace it.
SOURCE: Replacement of driver side window motor
How do I replace driver side window on VW passat 2006 model
SOURCE: third row seat in ford explorer stuck in down
my third seat is stuck in the down position . press switch to raise i hear the motor but nothing happens. 2006 ford explorer
SOURCE: how do i remove the back seat to my 2000 ford
On the seat bottom left and right of center there's a release clip. (see photo) Carefully push the release with a flat screw driver and pull up doing one side at a time.
Once the seat bottom is removed there's 2 bolts holding the seat back in place, remove the bolts and lift the seat back straiting up.
65 views
Usually answered in minutes!
×