Question about 1995 Hyundai Sonata

Open Question

Coil pack not firing not sure if wire are correct please where can i find a diagram for free

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 550 Answers

SOURCE: only onecoil pack is firing on 2001 santa fe

chech wiring if you changed over it must be supply cables from .ignition ,

Posted on Mar 22, 2012

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can I find the spark plug wiring diagram for 1994 Camaro, v6 3.4 liter?


Engine Coil Pack
5 6 / #4 / / #3 / / #5 /
3 4 / #1 / / #6 / / #2 /
1 2
Front Ignition Wires on Coils
#1 #4 #6 #3 #2 #5
' ' ' ' ' '
O O O O O O

Firing Order: 1-2-3-4-5-6

Feb 24, 2015 | 1994 Chevrolet Camaro

2 Answers

I am having trouble fiquiring out which wire goes to which plug. The wires are different lengths and the correct wire length has to go specifically with the correct plug. I have the firing order dia


The firing order is 1-2-3-4-5-6
Cyl #1 is front left when looking at engine front to back
left coil pack connects to cyls. 5-2
center coil pack connects to cyls. 3-6
right coil pack connects to cyls. 4-1
It doesn't matter which connector on the coil you use just that the cylinder is connected to the proper coil pack (the coil fires both plugs at the same time, twice per each full 4 stroke cycle)
1998 Chevrolet Lumina
3.1 liter V-6 VIN "M" 94760154.gif

7aedc9b8-0448-4420-b824-420afd929143.gif

Dec 20, 2013 | 1998 Chevrolet Lumina

1 Answer

Check an ignition coil pack for aura 3.2 TL






ironfist109_390.jpg




  • For coil wires.

  1. Remove the intake cover.
  2. Remove the right side engine cover - A -
  3. Remove the left engine cover - B -
  4. Remove Right rear engine cover - C -
  5. To remove the #6 coil you will also need to remoce the heat shiel off th reserve tank and the reserve tank as well.


  • For coil pack.

  1. Remove negative battery cable
  2. Remove engine covers show in diagram.
  3. Remove the coils (listed above).
  4. Now just remove the mounting bolts to the coil packs.

  • Please Note - Don't loose the firing order of your car will not run.

  • Here is a spare one in case you get mixed up.
  • Firing order is
  • 1-4-2-5-3-6



ironfist109_391.jpg



  • If you have any comments please feel free to leave them here.
  • Hope this helps and thank you for using FixYa.


Regards, Tony

Oct 13, 2011 | 2002 Acura 3.2TL

2 Answers

Need the firing order for the spark plug wires to the coil pack for a 97 ford f150 4.6 wiring diagram


Here's a picture for you although i see you said coil pack but I see two coils packs. Anyway here's your picture and i hope it helps and good luck.


clifford224_168.jpg

Mar 28, 2011 | Ford F-150 Cars & Trucks

2 Answers

Squirel ate through wire harness connector on coil pack. I have found new connector with generic black 4 wire harness, but need to know the correct order to connect to old (multi-colored) wires leading...


Check the right wiring diagram connections... 2002 Mercury Cougar 2.0 liter DOHC L4 VIN "3"

zjlimited_204.gif

Also, I find few diagrams about Igniotn System...

zjlimited_730.jpg

Fig. Engine Ignition, Page 01 (2002, System overview)



zjlimited_731.jpg


Fig. Engine Ignition, Page 02 (2002, Duratec-VE)



zjlimited_732.jpg


Fig. Engine Ignition, Page 03 (2002, ZETEC-VCT)





Hope helps.

Feb 22, 2011 | 2002 Mercury Cougar

1 Answer

While cranking loud backfire than i restart engine again than it cranks than starts up,this happend about 6 times during 3 months. Car did same thing yesterday, but it just cranks won't start 98 olds...


Not sure if you have a 1996 Cadillac Seville or a 1998 Olds Aurora but I would check the Ignition Coil Packs. One or more of them may need to be replaced. Also if you were working on the car and got the wires plugged onto the wrong coils then the firing order sequence would not be correct and this can cause a misfire or backfire conditon.

Ignition wires cannot rest near the primary wire harness of the ignition module, which can cause electrical interference and a no start condition or a misfire condition

On my friends 1997 Cadillac Seville it was easy to replace all 4 coil packs took less than 30 minutes and made the car run much better. Just make sure to get the firing order right. If necessary find a diagram of the correct firing order for you vehicle.

A good place for mail order auto parts is rockauto.com

I have pasted a picture below of what an ignition coil pack looks like




octech4hire_0.jpg

Jan 02, 2011 | 1996 Cadillac Seville CA Value

3 Answers

1999 ford escort I changed the plugs, but broke a plug cap. Bought a generic replacement spark plug wire that had to be modified to fit into the head. I cannot get the firing order correct. The car...


Remove the plugs from the head. Insert into the coil wires. Make sure they are properly earthed on the engine. Crank the motor and check for spark at each of the plugs.
Refer to the diagram. Cylinders are connected as shown on the diagram in blue. 1 goes to cylinder 1(sparkplug furthest from coil pack), 2 to 2, 3 to 3 and 4 to 4(closets to coil pack).
To test the coil pack use a digital volt meter. Measure resistance between coil towers for coil 1(marked 1 in red on diagram) Value should be between 12000 and 14500 ohm. Do the same for coil towers 2.
Measure resistance between I and C1. If the measurement is more than 5 ohm the coil is defective. Do the same for I to C2.
Measuring voltage at I(Ignition start/run) to ground should be 10V.
I is connected to the 15A engine fuse. The radio interference capacitor is connected between this line and earth at the coil. Disconnect it to see if it cures the problem.
C1 and C2 connect to the powertrain control module.
Bear in mind that aftermarket coil wires may cause problems with misfiring, so see if you cant find an OEM coil wire to replace the broken one before replacing anything else.

suzman_16.jpg

Nov 15, 2010 | 1989 Ford Escort

2 Answers

What is the wireing order for spark plugs in a 2000 ford windstar se. The front of vehicle has a short, medium, long wire. Where does each wire go in relation to the coil pack in rear of engine. Thank you!


The correct firing order diagram for that vehicle is not an easy task to come up with, but try this diagram and it should be the right firing order diagram for that vehicle. Let me know if this does not work out.


338329d.jpg

Jul 27, 2010 | 2000 Ford Windstar

1 Answer

2004 KIA OPTIMA WON'T START AFTER SPARK PLUGS WERE CHANGES


HI. There are several areas of concern here. I will list them below. Check all areas stated in the list for faults.

Possible cuases:

1. Incorrect firing order set. On the 2.0, 2.4 and 2.7 engines. These engines are equipped with a distributor-less ignition system. This system incorporates a coil pack assembly, along with wire sets. In order for the assembly to fire correctly, the order of the wires must be set to the proper sequence. if not, the engine will not turn over, or start correctly. Make sure your firing order is correct, and make sure you have not placed a particular wire set into the wrong cylinder. I will post a picture of the correct firing order for your engine, below this list, shortly.


2. Incorrect spark plug gapping procedure. If the new spark plugs were gapped incorrectly, this will not allow for proper spark, thus, preventing optimal combustion, due to lack of fire. Check the spark plug gap using a wire gap gauge, and adjust if necessary. The gap should be 0.039-0.043 in. (1.0-1.1mm)

3. Failed coil pack assembly. This will be the worst case scenario. The coil pack supplies the necessary current that fuels each plug. The current is transferred, via wire sets.This will be the culprit if all the above areas are proven to be operational, and in good shape.

4. Failed wire sets. Replace the wire sets if faults are found at the connector at the ignition coil pack, or at the plug boot.



NOTE*
In order to provide the correct firing order for your engine, i will need the engine size and liter information, if possible. Please post this information, asap. Thanks..

Mar 24, 2010 | 2004 Kia Optima

1 Answer

Need a diagram of the firing order of spark plug wires from coil packs to spark plugs


FROM LEFT TO RIGHT, 5/2 3/6 4/1. ASSUMING YOU HAVE THE 3.1L ENGINE.

May 31, 2009 | 1998 Chevrolet Lumina

Not finding what you are looking for?
1995 Hyundai Sonata Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...