Question about 1999 Chevrolet Silverado 1500

1 Answer

Cant find blower motor resistor 1999 dodge durango

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Under plastic cowl by windshield wipers up under metal outside, not inside by blower motor

Posted on Nov 20, 2013

  • Willie Cuellar Nov 20, 2013

    under plastic cowl by windshield wipers up under metal outside, not inside by blower motor

×

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: 2002 Chevy Impala Blower resistor location

It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike

Posted on Apr 20, 2009

  • 118 Answers

SOURCE: How do i change the Blower motor resistor on a 2005 chevy impala?

The blower motor resistor is located behind the glovebox mounted in the fan housing box under the dash.

Posted on Jul 20, 2009

  • 3640 Answers

SOURCE: replace blower motor resistor unit on 99 Malibu ?

the blower motor resistor is below glove box. remove panal under box. slide the pcm out of the way, resistor is beside blower motor. unplug wiring, take out screws holding it in then pull straight out to remove.

Posted on Jan 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 dodge durango heater switch hasnt worke on high for a while today stopped working all togethor


It's probably the blower motor resistor. It can overheat and burn out, often melting the connector so the connector cannot be separated. See the linked YouTube video for information on replacing the resistor, and connector if necessary.
Dodge Dakota Durango Blower Motor Resistor Replacement

Feb 04, 2017 | Dodge Cars & Trucks

2 Answers

Where is the heater resistor on a 2005 dodge dakota? Behind glove box?


should be just above the blower motor. You will need to remove the glove box door to gain access.

Dec 12, 2015 | 2005 Dodge Dakota Club

1 Answer

1999 dodge durango front blower on Ac not working rear is working fine


I think the front resistor is right at the base of the windsheild under the cowl ...take off wipers, cowl. and underneath you should see an access

Jul 04, 2014 | 1999 Dodge Durango

1 Answer

Locate the blower motor resistor on a 1999 dodge durango


most resistor blocks bolt to the fan housing, be causes its air cooled
and must be near fan actual so it always is cooled. see?
i just looked,its there. dead center blower case.(fsm book)
alldata.com
log in and read the HVAC pages.
if fan fails on high too, its not the resistor, because on high
it bypassed.
ah but not if the thermofuse in the resistor block is blown



604cabb9-976f-4de8-a869-e5716c072135.jpg

Jul 04, 2014 | 2004 Isuzu Rodeo

1 Answer

How to replace the motor blower resistor on a 1999 dodge durango


Follow wires back from blower motor , they should be plugged in to resistor. Usually mounted on duct work below on passenger side.

May 03, 2014 | 1999 Dodge Durango

1 Answer

Where is the blower resistor on the 1999 durango


it is located under the dash on the drivers side next to the blower motor.

Oct 29, 2009 | 1999 Dodge Durango

1 Answer

1999 Dodge Ram 1500 Fan Motor Resistor Location


I've never seen a vehicle w/o a blower resistor. You don't need to remove the blower. The resistor is about 2 inches x 3 inches and is installed in a hole in the plenum (duct) near the blower motor. It will have a wiring harness connected to it. It could be under the passenger dash or under the hood, depending on where the blower motor is.

May 06, 2009 | 1999 Dodge Durango

6 Answers

Replace durango blower motor resistor instructions


2003 Dodge durango, the blower motor stoppped came back on and stopped again and never came back on. I replaced the blower motor and still no air. Can anyone help?

Aug 01, 2008 | 2001 Dodge Durango

1 Answer

Resistors


They are typically located in the blower housing...accordianman

Jul 12, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...