Question about 2007 Pontiac G6

Open Question

Need to locate fuse for traction control and cruise control

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Pontiac aztek cruise control stopped working along with the ABS


Cruise control fuse # 31 10amp located in the under hood fuse / relay box an HZDFL fuse # 40 15amp located in the center console fuse box . If you pull the plastic side panel off of the right side of the console there is a fuse box inside . If the fuse are good the control module could be bad . Could also be turned off because the ABS has a problem .
DTC P1554 - do you know what a diagnostic trouble code is ?

The powertrain control module (PCM) has the ability to inhibit cruise control operation if conditions exist that would make cruise operation undesirable. The following conditions may inhibit cruise control operation:
• The engine speed is too high or too low.
• The vehicle speed is too high or too low.
• The traction control has been active for longer than 1 second.
• The vehicle acceleration or deceleration rate is too high

If the ABS light is on ,there are DTC'S stored in the system . Your best bet , take it to a GM dealer or someother qualified repair shop.

Mar 03, 2017 | 2001 Pontiac Aztek

2 Answers

2007 Jeep Liberty traction control light starts flashing on highway and then can't use cruise control anybody know what it could be Ty


that is normal for cruise, ( its goes dead, when there are other dangerous conditions, or jeep gets lawsuit like TOY did)
did you scan it yet.
??????
that be first. (after checking fuses)
look for ABS failures. or Traction control)

or get car serviced?????? like oper guide stated, for this error?

Jul 25, 2015 | Jeep Cars & Trucks

2 Answers

Check engine light on traction control light on cruise light blinking whats wrong?


When you have a check engine light come on, the traction control light and the cruise lights both come on as well. You need to have the codes checked with a scanner. There most likely isn't a problem with the traction control or cruise systems, the lights turn on because those systems work together with the engine management system or PCM. When there is an engine problem that sets a code that turns on the check engine light, it automatically disables the cruise control and traction control for safety reasons. Because the last thing you want is to have an issue with traction control and/or cruise control if your engine is having an issue, which is why they are disabled. The most common problem that turns on the check engine light is a loose, cross-threaded, or snug but not tight enough fuel filler cap. Subaru recommends three clicks of the cap to be considered tight. Also, any parts store can and will check and/or clear codes for free. I hope this info helps!

Sep 08, 2014 | 2011 Subaru Impreza

1 Answer

My cruise control lights and everything work, but it wont set speed and hold that speed, or anything. all fuses are good


Suggest 2 basic checks:
1. check engine light on? Some severe codes may also disable cruise control (and traction control, etc.).
2. make sure your break lights aren't on. The switch on the break pedal controls the break lights, AND cancels cruise.

Oct 09, 2013 | 2006 Dodge Ram 1500

1 Answer

Need to find the fuse for the cruise control in a 2000 gmc seirra


Hello and welcome.Please refer to owners manual for fuse block and fuse location.Look in back of book and look up FUSES (fuses and Circuit breakers).Now locate CRUISE.This is the fuse for cruise control steering column control. I hope this answered your question.

Jun 15, 2011 | 2000 GMC Sierra

1 Answer

Cruise control does not engage


Is the speedo working, TC ABS light on? You need the EBCTM...electronic brake control traction module replaced.

If not, check the fuses for the cruise cct.

Oct 17, 2009 | 2000 Cadillac Catera

1 Answer

When I click it to come it wont.. then the light for it comes on and is the cruise control still wont work. Is it a fuse maybe? 1997 Nissan Altima


Hello there.

I would deffinetly check all of your fuses first, as cruise controll will work with a different part of the car.

i know that abs ( anti lock brake system) works with traction controll.

so i would deffinetly go for fuses buddy, there located under the steering wheel on the right if a right hand drive car.

if left hand drive, then left hand side on a pull down flap, you will see with have a little clip on it.

Thanks alot.

Ps. there are also fuses in the engine bay located in a little black box, with normally white numbers and lines on :) the in car fuse layout is found on the reverse of the plastic, cover that will either come off or flip down.

Apr 10, 2009 | 1997 Nissan.5 Altima

2 Answers

1999 oldsmobile alero the traction and cruise not working


use a scanner to check the abs system . most of the time the abs brakes and traction control system work together. your cruise control . unit has a servo motor .in front right fender well. check the fuse and relay also the cruise control brake release switch. and the brake light switch.if all is good you have a cruise control module problems. dealer ship job.

Mar 31, 2009 | 1999 Oldsmobile Alero

Not finding what you are looking for?
2007 Pontiac G6 Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...