Question about 2001 Saturn L-Series

1 Answer

When you put it in gear motor jumps when your driving and it shifts it jumps and trans knocks when put in park

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Saturn Master
  • 1,615 Answers

Motor or transmission mounts. Inspect and replace.

Posted on Nov 19, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
jgwhomeequip
  • 1902 Answers

SOURCE: slipping trans leaking fluid slams into reverse

Your tranny is shot. I had the same problem with a customers car came down to having to replace the tranny

Posted on Feb 06, 2009

  • 274 Answers

SOURCE: Neutral is drive.

Sounds like the gear linkage cable needs adjusting Simple job really

Posted on Jul 10, 2009

  • 811 Answers

SOURCE: My 1992 Saturn SL1 has a fast idle (1500 rpm) but

run scanner for codes

Posted on Sep 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i put in to drive. From park it hesitate. And i have to give it gas to get it to go in gear and when it does. It jumps. In to gear


1. Check trany fluid eng hot and running add if necessary and check shift.

2. Check side of trans make sure vacuum shift modulator and lines to it are not leaking and it is getting good vacuum,

3. If so then replace modulator.

4. If no fix take it to trany shop or replace.
Hope this helps Mike

Jan 25, 2016 | Cars & Trucks

1 Answer

Location of 4 wheel drive relay on 98 ford ranger


All the relays are under the hood on these rangers, but you problem may be with the control box behind the jump seat on the drivers side. You may have to remove the jump seat to get to it. Once there, the box will have a white,grey or black button on it. Usually on the end where the red light is, Turn the key on and press this button and hold for 5 seconds. This puts the 4 wheel drive shift motor back in sequence. Now without starting the engine and the trans in park if auto and neutral if standard park break set, try the to shift in to 4 high, if you can hear the shift motor run and shift the gears in the transfer case, try 4 low, you should hear the same motion in the transfer case, if so you have solved your problem. If not you may have to move on to the connector on the transfer case, you may have to unplug the connector and look at the pins and socket, if they look corroded, clean and apply some dielectric grease to the pins and the socket and plug back in. Try the 4 High and 4 low again. If it works, great, if not you may have a bad shift motor.
Good luck.


Feb 25, 2014 | 1998 Ford Ranger

1 Answer

Liter engine automatic


you probably have a bad motor mount. Look under the hood, passenger side of engine compartment cast iron mount with rubber insert. Is the rubber insert worn visually inspecting. If you cannot tell, have a friend start the car, emergency brake on, foot on brake, shift from park to drive, does the motor jump in the mount? shift from drive to reverse, does it jump again. If so bad mount, local auto repair store should carry. you will have to jack up the engine carefully not much and not directly on oil pan, you just have to relieve the weight on the mount to replace. several m10 bolts, 15mm socket to remove. retighten fasteners to 58+/- 9Nm of torque. good luck.

Nov 19, 2013 | 2001 Saturn L-Series

2 Answers

How do you adjust the shift cable on a 1995 gmc jimmy, wont go into reverse or park.


On the 1995 Jimmy, the shift cable can come loose on the mount on the side of the transmission where the cable meets the trans. When it slips, the alignment goes off and causes the driver to not be able to put the trans into park. If you take a long stick you can push the shift arm on the trans to the park position and your trans will go into park.....what you (and I) really need to know is how to take the shift cable mount apart and reset it.

Aug 05, 2012 | GMC Jimmy Cars & Trucks

2 Answers

98 buick park ave. shakes n shifts hard and noises, is this a transmission sensor?


sounds like a trans mount when they go bad it causes all kinds of shakes , have someone put in gear ,open hood,, watch motor. tell them to hold brake and give it a little gas .Don;t stand in front of car .....see if motor raises up if so replace all mounts motor included. this is a common fix on theses cars.

Mar 18, 2011 | 1998 Buick Park Avenue

1 Answer

Issues when changing gears in a automatic 2001 Volkswagen passat. Car kind of jumps or shakes when changing gears from Park to reverse or to drive. But works fine when changing gears into 4, 3, or 2.


it is bcause the trans shifts opposite diection when going from reverse to drive but i would check mounts where they bolt to trans have seen them with broken bolts

Aug 23, 2009 | Volkswagen Passat Cars & Trucks

1 Answer

Once in Drive, Jeep does not easily shift back to Park


Try to check the trans mission gears of your 1995 jeep grand cherokee.The shift fork and the clutch sleeve of the trans mission is locking to the other gears .And then also check the starter motor and its solenoid.if the starter motor solenoid is destroyed or worn out replace .

Jul 28, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Why does my 1991 chevrolet cavalier slams in the diff section when shifting the gear lever from park to drive and or reverse?


check your engine and trans mounts sounds like you have a bad mount allowing motor to shift up pop hood and look at engine while someone puts in gear see if engine comes up or kicks back it should only move slightly

Jan 26, 2009 | 1991 Chevrolet Cavalier

1 Answer

Jumps into manual 2nd gear


When was last fluid & filter change?

Nov 22, 2008 | 2000 Dodge Stratus

Not finding what you are looking for?
2001 Saturn L-Series Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...