Question about Volkswagen Cars & Trucks
ABS light came on yesterday and as i drove the lights dimmed when i rolled down the windows and today it wont start
If the red charge light didnt come on then I would first check fuses and if they are ok then I would change batery.
Posted on Nov 19, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Car wont start.
I work at a car lot and have experienced alot of numerous electrical problems with this group of Chrysler's.(Intepid, 300m, LHS, Concorde) I hate to say but usually a BCM has fixed my problems. Regarding the alarm i would look into the switch on the back side of the lock cylinder it was a very common problem in the mid 90's era Chryslers, but all in all sounds almost like a BCM. (Body Contol Module) New they are salty but call the dealer and give them the last eight of the vin and tell them you need the ID number for the bcm they should give it to you then browse your local junk yards. GOOD LUCK!
Posted on Jun 17, 2008
SOURCE: 2002 Monte Carlo wont start
sounds like your passlock sensor on the ignition barrel is faulty. you will have to go to the dealer to have it replaced because of the programming after replacement.
Posted on Nov 07, 2008
either your alternator has gone or your fan belt is not there which helps the alternator to charge the battery get a volt meter on your alternator to see if it is kicking out what it should be
Posted on Dec 06, 2008
The problem may be in the wiring which if you pull up the carpet on the front passenger side by
removing the door floor trim and lifting the carpet you will see the
wiring underneath. Probably laying in water or has been. Look for splices in the
wiring which will have corroded. Repair the wiring then check the fuse.
Another problem may be in the motor found inside the door. The brushes may have worn out. If so you need to replace the motor. Ususally the drivers side will fail first since it is the most used.
Posted on Dec 21, 2008
SOURCE: abs light stays on/strong smell
Check the E-Brake, make sure that the ebrake is not engaged and that it is fully disengaging. If that is not the problem, then there is something with the brake calipers or rotors that are not allowing your brakes to fully disengage
Posted on Apr 30, 2009
Tips for a great answer:
Jun 13, 2013 | 1995 Lincoln Continental
Mar 24, 2013 | 2005 Nissan Frontier
Dec 03, 2012 | 2004 Chevrolet TrailBlazer
Jan 18, 2011 | 1993 Buick LeSabre
Jul 09, 2009 | 2005 Ford Crown Victoria
Nov 13, 2008 | 1995 Volkswagen GTI
Jun 14, 2008 | 1998 Chrysler Concorde
71 people viewed this question
Usually answered in minutes!