Question about 2001 Nissan Altima

Open Question

Where's fuse for low beam lights on 2006 nissan altima

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jschoon77
  • 55 Answers

SOURCE: lighting systems

The headlamp bulbs in these vehicles have 2 filaments- one for high beam and one for low beam.

Remove the bulb- being careful not to touch the glass part (oils from your skin can get on the glass and can actually cause hot spots and shorten the life of the bulb). You can see there are 3 wires in the connector. One will be ground. Using a test light, hook the clip to the poistive battery terminal and touch the pointed end to the metal contacts for each wire in the connector. One should complete the circuit and light the test light- ground is ok then. Now put the clip of your test light on the negative battery terminal. Turn the headlight switch on- high beam. Touch the point of test light to the terminals again and one should light- that's ok. Now make sure that the last wire completes a circuit when the headlamps are on low beam. If this checks out, look at the bulb and see if one of the filaments is broken. If your electrical checks aren't ok, check fuses- these are most likely ok, leading to a headlamp switch.

I was a tech in a Nissan dealership for 10 years and am an ASE certified Master Tech with L1 and X1 certs. and am a certified Nissan Scope Tech. I've seen this problem a few times.

Posted on Oct 29, 2008

johnny5846
  • 379 Answers

SOURCE: replacing low beam head light on nissan altima

your welcome , glad to have assisted you

J5

Posted on Jan 21, 2009

  • 14 Answers

SOURCE: 2004 Nissan Altima passenger side low beam

I would look at the fuses also. these newer cars have seperate fuses for driver an passenger headlights.

Posted on Oct 13, 2009

bsylvi321
  • 46 Answers

SOURCE: 2006 nissan altima low beams and high beams arent

If your headlight relay is ok, its most likely the switch itself.

Posted on May 06, 2010

  • 8 Answers

SOURCE: no low beam head lights

If you just want to replace the bulb yourself, this is a good website.
http://www.paulstravelpictures.com/Nissan-Altima-Headlight-Bulb/Nissan-Altima-Passenger-Side-Headlight.htm
If the website does't get your headlight fixed... You might have a blown fuse. It could be in the IPDM E/R location under the hood. This is next to the coolant bottle. Remove the coolant bottle with two screws and lift the cover to the IPDM E/R. Just set the coolant bottle aside for now. The low beam fuses are 49 and 50. They are 15A fuses. To be more precise, they are located on row 2, columns 2 and 3 (column 1 being closest to the fender of the car). Hope this helps.

Posted on Jul 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the passenger side low beam fuse located on a 2006 Nissan Altima


Low Beam Operation With the lighting switch in 2ND position, the BCM receives input requesting the headlamps to illuminate. This input is communicated to the IPDM E/R across the CAN communication lines. The CPU of the IPDM E/R controls the headlamp low relay coil. When energized, this relay directs power ? through 15A fuse (No. 36, located in the IPDM E/R) ? through IPDM E/R terminal 20 ? to headlamp RH terminal 1, and ? through 15A fuse (No. 45, located in the IPDM E/R) ? through IPDM E/R terminal 30 ? to headlamp LH terminal 1. Ground is supplied ? to headlamp RH terminal 2 ? to headlamp LH terminal 2 ? through grounds E15 and E24. With power and ground supplied, low beam headlamps illuminate.

IPDM E/R - fuse box E/R -- engine room , under hood fuse box .

System Description EKS008LH Control of the headlamp system operation is dependent upon the position of the combination switch (lighting switch). When the lighting switch is placed in the 2ND position, the BCM (body control module) receives input requesting the headlamps (and tail lamps) to illuminate. This input is communicated to the IPDM E/R (intelligent power distribution module engine room) across the CAN communication lines. The CPU (central processing unit) of the IPDM E/R controls the headlamp high and headlamp low relay coils. When energized, these relays direct power to the respective headlamps, which then illuminate. OUTLINE Power is supplied at all times ? to headlamp high relay, located in the IPDM E/R, and ? to headlamp low relay, located in the IPDM E/R, and ? through 50A fusible link (letter f , located in the fuse and fusible link box) ? to BCM terminal 70. With the ignition switch in the ON or START position, power is supplied ? through 10A fuse [No. 1, located in the fuse block (J/B)] ? to BCM terminal 38. With the ignition switch in the ACC or ON position, power is supplied ? through 10A fuse [No. 6, located in the fuse block (J/B)] ? to BCM terminal 11. Ground is supplied

https://carmanuals2.com/brand/nissan/altima-2006-4924

May 05, 2017 | Nissan Cars & Trucks

2 Answers

Where is my driver side headlight fuse located for my 2006 altima


There is a fuse for the high beam and a separate fuse for the low beam. Nissan came out with what I call kind of a hidden fuse panel which is located on the right (passenger) side of the vehicle. Nissan calls it an IPDM (intelligent power distribution module). It is located under the coolant resivour (can't spell). In any case below are some pictures and instructions on how to get to and remove it. Also is a picture of the fuse layout that is in there. The fuse for the high beam is the one marked with a red arrow and the fuse for the low is marked with a yellow arrow. If you need a larger picture(s), feel free to email me at csautomotivecars@att.net with all your information and I will be happy to send it to you. If both high and low beams are out you may be looking at a wiring issue. Hope this helps.....


9_2_2012_5_09_30_pm.jpg
9_2_2012_5_09_56_pm.jpg9_2_2012_5_10_12_pm.jpg9_2_2012_5_10_28_pm.jpg

Sep 02, 2012 | 2006 Nissan Altima

1 Answer

Where is the fuse located for a 2002 nissan altima drivers side low beam? THANKYOU


There is no fuse for a low beam. If the high beams are working and the low beams aren't then it blew the low beam filament.

Mar 08, 2011 | 2002 Nissan Altima

1 Answer

I have a 2006 altima and the low beam on the drivers side won't work i changed the bulb but noticed i had no power


these are fused individually right and left side and high and low beam for a total of four fuses controlling head lamps.fuses are located in black box near coolant reservoir and wiper washer fill.remove cover to access.location of fuses is marked on side of cover .i think you will find a blown ten amp fuse .i hope this helps.please let me know how you make out.

Feb 14, 2011 | Nissan Altima Cars & Trucks

1 Answer

'05 Nissan Altima Low Beam not working


Need to disconnect ground to battery before replacing light bulb or fuse will blow. Fuse is located in engine compartment next to windshield washer fluid.

Jan 06, 2010 | 2005 Nissan Altima

1 Answer

LOW BEAM HEAD LIGHT DOES NOT WORK I ALREADY REPLACED BULB HELP??? 2004 NISSAN ALT.


a lot of newer cars have seperate fuses for both left and right head lights both high and low beam. you should check your owners manual to see fuse locations and designations for your head lights.

Aug 18, 2009 | 2004 Nissan Altima

1 Answer

Replacing low beam head light on nissan altima


your welcome , glad to have assisted you

J5

Jan 20, 2009 | 2005 Nissan Altima

3 Answers

No low beam head lights


If you just want to replace the bulb yourself, this is a good website.
http://www.paulstravelpictures.com/Nissan-Altima-Headlight-Bulb/Nissan-Altima-Passenger-Side-Headlight.htm
If the website does't get your headlight fixed... You might have a blown fuse. It could be in the IPDM E/R location under the hood. This is next to the coolant bottle. Remove the coolant bottle with two screws and lift the cover to the IPDM E/R. Just set the coolant bottle aside for now. The low beam fuses are 49 and 50. They are 15A fuses. To be more precise, they are located on row 2, columns 2 and 3 (column 1 being closest to the fender of the car). Hope this helps.

Jan 04, 2009 | 2003 Nissan Altima

Not finding what you are looking for?
2001 Nissan Altima Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...