Question about 1999 Ford Super Duty F 450

Open Question

Need location of brake light switch on a 1995 Ford F800 with air brakes

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ford 2002 explorer brake lights

Replace the bubs and/or check the wiring connections with a electrical tester for power.

Posted on Nov 10, 2008

  • 659 Answers


check the connector at the brake switch located on the brake pedal lever arm if it is ok it is most likely a faulty switch

Posted on Dec 02, 2008

  • 508 Answers

SOURCE: Rear turn signals and brake lights won't work

Probably the turn signal switch assembly. This is a common problem with the older Fords. The switch is a self contained unit at a cost of about $100.00.

Posted on Feb 09, 2009

  • 1 Answer

SOURCE: 1969 ford mustang mach 1 brake / stop light switch challenge

I installed a new turn signal switch in the steering column, and it fixed my brake light problem. Evidentally the turn signal and brake light wires use the same plug wires. It cost about $70. I would suggest doing this.

Posted on Mar 31, 2009

  • 15 Answers

SOURCE: No turn signals, hazards or brake lights

replace the turn signal switch in the steering column

Posted on May 16, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

1995 class a motor home ford chassis brake light switch

The switch is located on the brake peddle where the master cylinder attaches to the peddle remove clip slide master cylinder rod to one side remove switch.

Oct 08, 2013 | Cars & Trucks

1 Answer

Bleeding the brakes in my ford f800.

start by the wheel furthest from you brake master cylinder have some want pump the brakes 3times and hold their foot on the pedal while you open the nipples, ones nipple is closed repeat till all the air bubbles are out and move on to the next wheel check fluid in reservoir regularly

Sep 13, 2013 | Cars & Trucks

1 Answer

1998 ford f800

Have you checked the switch on the lever ?

Aug 30, 2013 | Cars & Trucks

1 Answer

1995 Ford f250 brake lights don't work ad neither do the hazard flashers. I replaced the flasher node and the turn signals began to work but still no brake lights.

You may have a bad signal switch..Your brake lights run through the signal switch..Try hitting the brakes and move the switch around and see if your brake lights come on intermittently..

Sep 22, 2011 | 1995 Ford F250

1 Answer

Brake lights dont work need to know where in fuse box brake light fuse is located

the fuse block should be located on the around the end of the dash board or on the fire wall on driver side down by the brake pedal and should be marked brk. Lts after checking the fuse if fuse is good should check the brake switch that would be located on the break pedal this switch sometimes go bad and needs replacing these are a easy replacement it should have a clip with a pin running threw the brake pedal and will have an electric plug that will need to be removed to get the switch out hope this helps you out.

May 29, 2010 | 1995 Ford Contour

1 Answer

1995 ford taurus, brake lights not working also

Sounds like the brake switch is bad.

May 19, 2010 | 1995 Ford Taurus

1 Answer

Stop light switch wire harness

The brakes lights work off a brake light switch mounted very close to the brake pedal. If you have cruise control it will be a duplex switch with two harnesses attached to that switch on the bracket between the steering column and the brake pedal bracket

Apr 03, 2010 | 1995 Ford Taurus

2 Answers

There is no brake lights and its very hard to shift to drive

brake switch located under dash just in front of the brake pedal arm.... I just replaced mine

Oct 12, 2009 | 1995 Ford Aerostar

1 Answer

Air brake buzzer stuck on

may have a small air leak or faulty pressure sensor

Jul 21, 2009 | Ford F Cars & Trucks

1 Answer

Ford econoline e 250 1995

Change the brake light switch, located above the brake pedal.

Jul 02, 2008 | 2007 Ford Econoline

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5677 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides