Question about 2008 Chrysler Sebring
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Trouble Code p1004
This from an owner with the same code, indeed it is the intake maniflod that causes the issue.
P1004 is a intakemanifold short runner valve performance. they replaced the intake manifold plenum. cost $1200, but they repaired under warranty in the interest of customer satisfaction. my base warranty is out by milage, yet they repaired it for free. now that is a great dealership. I would talk to the dealer, this is a manufactirer defect, also it may be covered under federal emission warr. 7/70,000
Posted on Nov 27, 2008
SOURCE: engine code P1004
This code P1004 -Short Runner Valve Performance.
Requires PCM reprogram done under service bulletin 18-003-07REV. A, go to the dealer and have this preformed and your code should go away, should be covered as warranty.
Posted on May 20, 2009
FIRST YOU TURN IGNITION SWITCH ON WITH ENGINE OFF.LOOK AT MIL LIGHT IT SHOULD COME ON 3 SECONDS THEN GO OFF IT NOT THEN YOU GOT BURN OUT BULB OR A CIRCUIT PROBLEM.IF ALL IS WELL. ATTEMPT TO START ENGINE.TURN OFF IGNITION. WITH OUT STARTING ENGINE.TURN IGNITION ON OFF ON OFF AND WITHIN 5 SECONDS RECORD 2 DIGIT DIAGNOSTIC TROUBLE CODES.DISPLAYED BY FLASHING MIL LIGHT.YOUR MIL FLASHES WILL BE YOUR CODE LIKE THE MIL LIGHT FLASHES 5 TIMES THEN PAUSE FLASHES 3 TIMES THAT CODE 53 THAT YOUR CODE.IT LIKE MORSE CODE.WHEN DONE TURN OFF IGNITION SWITCH.GO TO AUTO ZONE OR ADVANCE AUTO GET HAYNES COMPUTER CODE BOOK. TO GET CODE MEANING OR WHAT SENSOR GONE BAD.HOPE THIS CAN BE SOME HELP.
Posted on Jul 27, 2009
Code 1495 = Leak Detection Pump Solenoid Circuit
Remove the connector from the solenoid (should be on the back wall, just to the drivers side of the air-hat). You will have the solenoid to check and the harness. What you want to measure is the voltage coming from the harness and the resistance of the solenoid.
Turn the key to the "ON" position but do not start the motor; the voltage at the connector should be at least 10V or more,.now, check the resistance of the solenoid (should be around 35 ohms).
Posted on Jun 03, 2010
Tips for a great answer:
Feb 08, 2017 | 2007 Chrysler 300
Sep 30, 2016 | 2008 Chrysler Sebring
Jan 13, 2014 | 2008 Chrysler Sebring
Mar 04, 2013 | 1998 Chrysler Sebring
Aug 25, 2011 | 2007 Chrysler 300 AWD Sedan
Feb 06, 2010 | 2006 Chrysler 300M
Sep 16, 2009 | 2007 Chrysler 300 AWD Sedan
166 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: