Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The haynes book is not recommended since there are numerous mistakes and they still will not update. One of the biggest is the firing order.
The factory service manual is the only way to go.
Head bolts - 46 - 50.5 lbs (there is an order sequence for the bolts)
Intake & exhuast manifolds- 13.5 - 20 lbs
Flywheel - 41.5 - 47 lbs
Clutch cover - 13.5 - 20 lbs
Posted on Mar 17, 2009
11marzo2010- Necesito que me Hagan favor de enviar el diagrama para poner un motor de un tiempo de 4,0 Ford Explorer
Posted on Mar 12, 2010
Remove the shifter from inside, two connectors to the sensorson the trans at the firewall, remove 4 bolts holding front driveshaft to the front diff, slide rear section of front driveshaft out of the splines, remove 4 bolts holding rear driveshaft to transfer case and slide the driveshaft out of the transmission tailshaft, remove the two starter bolts ( hardest part of the job), leave the starter in the engine bay with the wires still attached, remove the clutch ARM from the transmission, remove the rear transmission mount (4 12mm bolts) support the transmission on a jack, put another jack in from of the engine to pitch the engine so the rear is sagging down slightly (this is so you have enough clearance to remove the transmission), remove the four 14 mm bellhousing bolts (remember the longer one goes onto the passenger side top) tip the tailshaft up to the floor of the Sammy and slide it to the rear as far as possible, let the front come down slowly ( it will barley rub the pressure plate but not enough to hurt anything) presto its out, replace the clutch assembly and grease throwout and transmission splines the reverse these steps. I have done 3 of these and accomplished my last one in 4 hours total. No need to remove the exhaust, transfer case or engine as others have stated on numerous write ups. You will need two 12mm combo wrenches, one 14mm combo wrench, one 3/8 drive ratchet with 12mm shortwell socket, a couple extensions for said ratchet, one small pair of pliers (to hold the clutch cable while adjusting) and a hammer to gently tap the clutch arm onto the splines.
Posted on Sep 27, 2011
Tips for a great answer:
Jun 26, 2014 | Suzuki Esteem Cars & Trucks
Jun 18, 2014 | 2007 Suzuki Grand Vitara 4WD
Aug 14, 2013 | Cars & Trucks
May 07, 2013 | Cars & Trucks
Sep 24, 2012 | Nissan Nissan Cars & Trucks
May 28, 2012 | 1999 Isuzu Rodeo
Apr 13, 2012 | 2004 Suzuki Aerio
Mar 30, 2010 | 1997 Buick LeSabre
62 people viewed this question
Usually answered in minutes!