Question about Land Rover Cars & Trucks

Open Question

Remove climate control unit 2001 range rover

Need to have the screen repaired. How do I take it out without damaging trim, etc?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: How to remove trim from rear hatch door on 2001 Sienna

You need to remove the big plastic or vinyl rear hatch trim to get the side trims off. Remove the 10 mm bolt that holds the pull handle (if you have a pull handle), and then, using a flat tool, (like a stiff putty knife), insert the tool between the vinyl trim and the tailgate to loosen the plastic clips (there is like 18 of them); one the hatch panel is off, you will see that you can now remove the side trims.

Posted on Oct 27, 2008

  • 1 Answer

SOURCE: climate control not working

I had the same problem on my 2004 GMC Yukon XL.
Still under warranty the shop was able to reprogram the climate control system and tell what was wrong rather quickly with a OBD computer.
That’s when they found both of the climate control (driver and passenger) side actuators were bad and the control unit that tells the actuators where they should be was also bad.
The truck was in the shop with most all the dash, seats, consol, and steering wheel out for a week. The cost was over $1200.00.
That has seamed to fix the problem. Good Luck.

Posted on Jan 14, 2009

j_del
  • 1586 Answers

SOURCE: 1999 Audi A4 Climate Control Removal/Installation

You have to remove the trim panel around the stereo/climate control to expose the screws that hold it in place. Once you do that, and the screws are removed, it pulls straight out and unplugs. No need to disconnect the battery and no tricks to it once it slides out.

Posted on Feb 10, 2009

  • 184 Answers

SOURCE: Remove Rover 45 driver door trim to replce wing mirror.

what you need to do here is pull out door trim from bottom & then give it a good bang at bottom it should slide out of top guide but you need to give it a good bang asthey are quite tight in there.

Posted on Mar 12, 2009

  • 3 Answers

SOURCE: 2001 Jetta Interior Climate Control Bulb

There is one bulb (for all three knobs) behind the center knob. Turn the knob to the straight up and down 12 o'clock position and pull the knob straight out. Wrap a soft cloth around the jaws of a pliers, that works the best. Pull the bulb out with a needle nose wrapped with a rubber band. The bulb is a sylvania 2721, available at most auto parts stores. You can also use a small piece of vacuum tubing to pull the bulb out. (pull straight out, don't twist it)

Posted on Mar 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 range rover p38 under seat fuse box diagram


Need help locating fuse #8 on 1997 Range Rover hse for the car lighter, climate control, & radio. Please help? Thank you

May 27, 2013 | Cars & Trucks

1 Answer

3G Mitsubishi Eclipse Climate Control Light Bulb Replacement


The control panel for the heater and A/C must be removed. Suggest you get Chilton's manual from the library. It will take you through step by step with pictures. To summarize: 1) Remove trim panel covering radio and heater controls. 2) Remove radio. 3) Disconnect the two heater control cables from the control panel. The trick to removing the cables is to compress the "claw" spring holding the cable by pressing a screwdriver from the underside of the control panel to release each cable.4) Remove control panel. Take to a workbench. From the backside of the control panel at the top, notice two large holes through which you can access the V2 Toshiba bulb holders. Turn them a quarter turn to remove them and the bulbs. The bulb is a common #74 bulb.

Apr 22, 2012 | 2001 Mitsubishi Eclipse

1 Answer

Need to replace a front heat blower resistor on 2002 mdx, where is located???


moz-screenshot.pngHere's an excerpt from the 2002 Acura MDX 4WD 6cyl Repair guide for replacing what the reference manual calls the "control assembly" - its located under the console rear trim and may (or may not)
contain the blower resistor - my manual doesn't say - but this is the closest thing I could find for you. Every other blower resistor I've had to find was located close to the heater controls - and this
car seems to be no exception -- its heater controls are located in the console between the seats, rather than in the dash (as in Acura 2003-06 MDX models).

You may want to call your friendly Acura dealership ad speak to the parts department, to make sure where the blower resistor is located - or a visit to a dealership parts counter often (or
Advance Auto Parts is helpful too) ofen clarifies questions I have from Haynes manuals (the cheapest car repair guides).

All this assumes that you've correctly diagnosed your blower control problem -- as in "replace the blower resistor when the blower works only on the MAX/Highest setting."

-- begin excerpt from 2001-2 Acura 4wd 6cyl MDX Repair manual --
Control Assembly Removal & Installation

2001-02 Models
  1. Remove the console rear trim. Refer to the accompanying illustration.

    0996b43f80205cf3.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Exploded view of the console rear trim

  2. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B).

To install:
  1. Install the control unit in the reverse order of removal. After installation, operate the control unit controls to see whether it works properly.
  2. Run the self-diagnosis function to confirm that there are no problems in the system.

    0996b43f80205cf2.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Remove the self-tapping screws and the rear heater-A/C control unit (A) from the console rear trim (B)



  3. --- end excerpt from 2001-2 Acura 4WD MDX 6cyl Repair Manual ---

Jan 02, 2011 | 2002 Acura MDX

1 Answer

Book symbol on climate control


Book Symbol refer to you muts to check the Owners Manual for the procedure to check climate control.

Aug 26, 2010 | 2002 Land Rover Range Rover

1 Answer

2006 Suzuki forenza with no climate control. How to remove knob without damage and/or change temp from engine compartment?


The knob cover easily pulls off. To remove the entire control, pry trim panel off, then remove screws that hold on controls and remove it.

Nov 20, 2009 | 2003 Suzuki Aerio

1 Answer

Illumination lights are out on climate control unit for 02 highlander


This solution has two basic assumptions. (1) Your fuse is fine and (2) the problem is a blown bulb and not a wiring issue.
That having been said, you're going to have to CAREFULLY remove the audio/climate control trim panel. Use a trim stick (if you can find one) or a taped or cloth-covered thin flathead screwdriver and GENTLY but firmly, pry the trim to release the clips. There are six clips holding the trim panel. Two on the bottom, two on the sides just under the vents, and two at the top corners.
Next you're going to have to remove the control assembly. There are 6 bolts holding it in place. Remove the bolts then pull out the assembly slightly so that you can disconnect the electrical connectors on the back of the unit. Do NOT pull the wires directly or you can cause serious damage. Only pull on the plastic connectors holding the wires. After all the connectors are unplugged, paying attention to where they come from so that you plug them back in correctly, the unit can be removed.
Next you're going to have to remove the back cover of the unit. To do that, first remove the two side bolts from the mounting brackets on each side attached to the climate control assembly. Then remove the back cover by unscrewing the six screws along the sides of the back cover and the two recessed screws at the top. Once the back cover is removed, you should see a light blue plastic piece with a screwdriver slot in the middle of it. That's your bulb. Take out the old bulb, put in your new one and reverse everything you just did to put it all back together again.
If you've done everything right, your unit should be illuminated once again.
Good luck.

Jul 11, 2009 | 2006 Toyota Highlander

1 Answer

Hello I have a 2001 Range Rover it stops after you drive it for about 10 minutes then will not restart until it cools down.I had an issue with the air flow sensor but have replaced this.


Hi it is common on range rovers that the flywheel flex plate cracks or brakes up, this in turn damages the crank sensor causing the engine to stop. I have had more than one car with this same fault.
Remove and inspect crank sensor for damage10 mins job just above the sump on left side of car from underneath.
Thanks rob

Jul 03, 2009 | 2001 Land Rover Range Rover

1 Answer

I have to replace the air/heat control unit 1996 land rover ?


I need an email address to send you the instructions as they will not fit here on the forum.

Book time on the removal and replacement is about 13 hours.

Feb 12, 2009 | 2001 Land Rover Range Rover

1 Answer

1999 Audi A4 Climate Control Removal/Installation


You have to remove the trim panel around the stereo/climate control to expose the screws that hold it in place. Once you do that, and the screws are removed, it pulls straight out and unplugs. No need to disconnect the battery and no tricks to it once it slides out.

Jan 18, 2009 | 1999 Audi A4

3 Answers

Intermitant Starting Fault P38A Range Rover


hello andy,

i think you already solved the problem..... whack the fusebox..

you need to chage the fusebox, because overtime the base of the fuebox which is made of plastic cracks and is causing short circuit.

Jul 09, 2008 | 1996 Land Rover Range Rover

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7699 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...