Question about Cars & Trucks

1 Answer

My 1993 Nissan 240 sx convertable top motor is broken. where can i get a replacement motor. or can it be fixed

Also the transmission or gear slips when im driving, stalling the ability to get power. if i pull over and stop the car and then restart it ,it is ok. any ideas?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Since it is an older vehicle I would suggest starting at your local junk yard. Call them up and tell them what part you need, they should be able to tell you whether they have one on hand or not. Otherwise...I hate to say it, Ebay, I was able to find one with a quick search. (http://www.ebay.com/itm/NISSAN-240-SX-CONVERTIBLE-MOTOR-AND-PUMP-OEM-/161131942310).

Posted on Nov 19, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

cresguy
  • 75 Answers

SOURCE: nissan almera 2005, automatic transmission

gear shifter has got damaged so replace it with a new one.....

Posted on Aug 09, 2008

  • 28 Answers

SOURCE: 1988 s10 transmission

if you drive it to much you will cause it to burn up, but to check the fluid level drive some to warm up( engine temp should be about half way (and you should reach 50mph) the park with it running(has to be running) and pull the tranny dipstick to check fluid level
if the trans and engine are cold it wont read the correct level

it will slip if the fluid is low

Posted on Jan 05, 2009

  • 3 Answers

SOURCE: Mercedes after shifting to reverse to drive the 1st gear slips

mercedes did nothing wrong your transmission is probably blown up. no way they could put in the wrong parts they wouldn't fit. how many miles are on your trans now? did you ever do a transmission service on the transmission that mercedes says is lifetime fluid? dont do back to the dealer find an independant shop that specializes in mercedes, like the one i work for. the dealer doesnt care about its clients. Us independants honestly do care

Posted on May 11, 2009

  • 850 Answers

SOURCE: transmission slips when hot

its either low on fluid or the clutches & bands are worn or need adjusting!
DONT REV IT!
get itserviced QUICK SMART! & check for leaks!

Posted on Jul 20, 2009

ftw1952
  • 10319 Answers

SOURCE: 1993 oldsmobile cutlass ciera. Engine stalls when you stop

Checkk the EGR system for the EGR valve should open when the engine gets to operating temperature. If not the engine will stall out

Posted on Jun 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What causes damage flywheel on bmw is it common fault


-you mean broken teeth...? If so possibly crank the engine while it's still running.


Good Luck


Mai

Jan 07, 2016 | BMW X3 Series Cars & Trucks

2 Answers

Torque converter clutch


It should be attached to transmission block, I will see if I find a diagram.

May 29, 2008 | 2001 Nissan Altima

3 Answers

Ihave code p0731 stuck in 1st ratio .. what mean that code?


obviously refers to auto trans , could just need the trans fluid level topping up or even changing , if this does'nt resolve the problem then a more in depth diagnosis would be required at a repair shop as could be the ECU for example but do the fluid checks and go from ther ,keep me posted

May 09, 2014 | 2009 Hyundai Azera

2 Answers

Code p0734 I just replaced eng. and trans. now have this code.


Engine Light ON (or Service Engine Soon Warning Light)
- Incorrect transmission shifting Possible causes - Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit Tech notes Start by inspecting the transmission fluid level and condition, and change fluid if necessary. When is the code detected? P0734 is detected when A/T cannot be shifted to the 4th gear position even if electrical circuit is good. P0734 NISSAN Description This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B

A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (4th) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

Aug 09, 2011 | 1995 Nissan Altima

1 Answer

My transmission in my 2006 nissan altima slipped twice in two days. is there a problem?


Probably the begining of a torque converter failure.
Stator inside of converter letting go too soon therefore can't build enough torque for the gear its slipping in.
I suggest you bring it in asap before you get a lite and all you have is reverse and third gear.

May 24, 2010 | Nissan Altima Cars & Trucks

1 Answer

1996 Nissan 240 Sx. The speed gauge fluctuates and


long story short, you need to replace the speedometer unit. its the motor and gear assembly inside.

Jan 20, 2010 | 1996 Nissan 240SX

1 Answer

Convertible top


First of all, what you have is a California Conversion. Nissan had the coup imported then sent to be converted. The company that converted these limited 240's did a wonderful job, they not only installed the top, but strengthened the body to compensate for the roof structure that was eliminated. The parts availablity is sparse, but out there. You may find the parts you need thru Coparts.com or another insurance salvage company by purchasing the entire wreck. Another possible avenue might be to have the links machined...relatively simple. These are inexpensive "do it yourself" solutions. You could take your car to Texas Auto Trim (713-661-5777) or Convert-Able systems (972-291-9769). In addition to replacing the fabric, they could repair the broken pieces.

May 20, 2009 | 1993 Nissan 240SX

1 Answer

4l60e no forward or reverse gears operating


It sounds like your torque converter or the pump is broken.

Jan 12, 2009 | 1993 GMC Sierra K1500

1 Answer

240 sx


Junk Yard, Salvage Yard, Used Auto Parts...

Auto Glass Company

E-Bay, Craig's List....

Nissan Dealer

Sep 17, 2008 | 1993 Nissan 240SX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

90 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...