Question about Jeep Grand Cherokee

Open Question

The rear wiper motor stopped working on 2011 jeep grand cherokee and the fuse is good

The rear wiper motor on my 2011 jeep grand cherokee limited has stopped working and the fuse appears to be good

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2005 jeep grand cherokee radio

It's in the engine compartment IOD#2. It's a black module with two fuses in it. Take that module off and replace the 20 AMP one.

Posted on Nov 21, 2008

Ad
ZJLimited
  • 17970 Answers

SOURCE: The Rear wiper stopped working on my 96 jeep cherokee sport

You can read this Factory Service Manual for ZJ-Secc-8K-Windshield-Wiper-and-Washer-Systems (page 7 and next), there you can begin to the fix.

Good luck!!!

Posted on Feb 25, 2009

  • 6982 Answers

SOURCE: My 2005 Jeep Grand Cherokee's windshield washer is not working.

Check power at the pump motors. You may not see a fuse because some run off a circuit breaker. If all else fails, a bit "backyard" but you likely could break out the washer pumps from the system and make a simple push button on the dash to operate them.

Posted on Jul 08, 2009

  • 6982 Answers

SOURCE: 2001 Jeep grand cherokee motor knock 4.7 motor

First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem in the valvetrain, most often a bad lifter or worn rocker arm. If the noise is low, deep inside, the noise is from a bearing. This is generally accompanied by lower than normal oil pressure. Regardless of the underlying cause, correcting the cause will not stop the knock. To do that correctly, the engine needs to be removed and all crankshaft bearings and the crankshaft itself need to be replaced (crank can sometimes be "undercut" and thicker bearing shells can be used depending upon the amount of wear.) If caught very early, sometimes only one bearing can be replaced in-car, but in 99% of all cases I have ever seen, most will fail again, sometimes more severely if done this way.

Posted on Dec 10, 2009

Testimonial: "Thanks"

  • 5 Answers

SOURCE: How do I remove and replace the rear wiper motor

remove the rear wiper arm take off the panel from the rear liftgate the wiper motor is accessible from there

Posted on Mar 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 jeep grand cherokee rear wiper doesn't work


you have a worn gear inside your wiper motor and it needs replacing

Nov 25, 2013 | 2004 Jeep Grand Cherokee

1 Answer

1999 jeep grand cherokee rear wiper not working.replaced motor and fuse is good


join a grand cherokee forum by googleing it and post this and all future questions there

Feb 04, 2013 | 1999 Jeep Grand Cherokee

1 Answer

How do you troubleshoot wiper blades on a 1995 Jeep Grand cherokee?


First check the wiper fuse then check the relay by turning wipers to on position and listen for the relay to click if it clicks its good.If they are good then turn the ignition and wiper switches on and check for 12 volts at the wiper motor.If you 12 volts then the wiper motor is faulty.Replace motor.

Jan 15, 2012 | 1995 Jeep Grand Cherokee

1 Answer

Rear wiper is on delay all the time on my 1993 grand cherokee


need to replace wiper motor. There is a contactor/timer on motor

Jan 07, 2012 | 1993 Jeep Grand Cherokee

1 Answer

My windshield wipers suddenly stopped working on my '96 Jeep Cherokee. I replaced a fuse that was bad, but they still don't work. Help!


if the fuse failed then that means one of few things...

1.) motor has failed causing excessive current draw
2.) circuit has direct short to ground
3.) short to ground that caused fuse failure is now an open

you need to check for power and ground at the wiper motor

keep us posted

Apr 06, 2010 | 1996 Jeep Grand Cherokee

1 Answer

04 jeep grand cherokee limited, my four windows dont work but my moon roof window works, rear windshield wiper doesnt work, interior lights go on and dont turn off, any reason why or any solutions?


with the windows it obviously is something common to all four and the first item I would check is the fuse. Interior lights are controlled by the headlight switch and a worn switch can be the problem. If these are not the problem than I would want to check the wiring, specifically the ground. Ditto for the rear wiper. Fuse first. Switch second. Wiring third.

Mar 09, 2010 | 2004 Jeep Grand Cherokee

2 Answers

The Rear wiper stopped working on my 96 jeep cherokee sport


Motor is right behind where arm connects to it. You need to remove inner panel.

Feb 23, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

239 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...