Question about Cars & Trucks

Open Question

Pt cruiser rear hatch closer adjustment - Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: PT Cruiser Brake Light

The bulb in the rear light has burned out and to replace it follow these instructions: 1) go to your owner's manual to find out the part number. You can find and purchase the replacement bulb at Target, any auto parts store and even at Walmart for under $4.00; 2) pop open the trunk door; 3) get a phillips screw driver and unscrew the 2 screws holding the rear brake light fixture to your car body; 4) as soon as you turn over the fixture you'll see where to pull out the burned out bulb and replace it with the new one(s). Good luck!

Posted on Oct 15, 2008

Ad
LiquidPT
  • 9 Answers

SOURCE: headlight adjustment

If you look at the front of the headlight, there are actually a couple of screws around the edge. These are your adjustment screws.

Posted on Jun 14, 2009

  • 4341 Answers

SOURCE: 2006 pt cruiser on drivers side rear turn signal

The turn signals flash depends on each and every bulb working correctly. When one bulb fails, you will notice a change in the flash frequency, as you describe.

Replace or repair the bulb that is not working, and you should be good to go.

Doc

Posted on Sep 14, 2009

  • 5 Answers

SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...

GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP

Posted on May 26, 2010

caroldon
  • 17130 Answers

SOURCE: The hatch door latch on my 2005 PT Cruiser works

Please remove the paddings and see if the cable is stuck into it. If so when the lock is actuated the lock could be caught into it and not allowing to disengage.
open the latch and check this link , clean and set. It will work as you can test it before closing. Hope you try. Good day.

Posted on Aug 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is my emergency release for my trunk on my 2010 pt cruiser


There is a emergency release on the left rear seat latch that allows you when pulled to push the seat open to gain access that way, not through the trunk hatch

Feb 24, 2017 | 2010 Chrysler PT Cruiser

1 Answer

Pt cruiser centre brake light bulbs replaced . still doesn't work l and r brake lights work????


Check the harness in between the rear hatch door and the body of the car. That area flexes a lot when the rear hatch is opened and closed which can cause the wires to break.

Apr 25, 2011 | Chrysler PT Cruiser Cars & Trucks

1 Answer

I HAVE A 2006 PT CRUISER THE REAR WIPER JUST STOPPED WORKING


The wiper motor may have gave out its located in the rear hatch interior panel. Although your problem could simple be that the fuse has blown and do need to replace it. Generaly the fuse panel is located directly under the dash panel and some times in the glove box. The only other promlem whould have to reside id a bad wiring conection simply use a voltage meter to check continuity.

Dec 06, 2010 | 2006 Chrysler PT Cruiser

1 Answer

Door ajarand interior light always on, what can do?


Faulty door jam switch or door out of adjustment! Not closeing tight enough! Check all 4 doors and hatch if equiped.

Sep 11, 2010 | 2004 Chrysler PT Cruiser

1 Answer

Replaced motor for the rear wiper, and it still does not work.


HAVE YOU CHECKED FUSES?ALSO CHECK WIRING AT REAR HATCH WHERE IT PIVOTS ON HINGES..MAY HAVE BROKEN WIRE HERE

Aug 22, 2010 | 2006 Chrysler PT Cruiser

1 Answer

P.T. cruiser hatch all of a sudden wont stay up 20min.latter.


its usually a sign that the rear hatch supports are getting weak and need to be replaced,some times the cold weather will affect them also

Sep 05, 2009 | 2002 Chevrolet Trailblazer Ext

1 Answer

2001Chrysler PT Cruiser rear door stuck


Hey I happen to have the same car with the same problem. I ended up taking the inner cover off the hatch and replacing the latch itself. Did this by pulling the cover off far enough I could see the linkage and then pushed the arm on the latch itself to make it open, put a new one on and called it good. b Hope this helps.

Jun 06, 2008 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...