Question about Mercedes-Benz CLK

1 Answer

How much is it to replace the flapper? - CLK Mercedes-Benz Cars & Trucks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Mercedes-Benz Master
  • 1,013 Answers

If its the throttle body flapper from 85 dollers from ebay

Posted on Nov 20, 2013

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

98 Stratus - Access to vent temperature cable and vent door/flapper ?

Sorry but the system doesn't use cables, it is all motorized and this is a common issue on all older cars. You will need to remove the dash assembly and check the temperature control door (also known as the "blend door). In all cases the door must be checked for freedom of movement, the blend door binding destroys the tiny DC stepper motor that moves the door and in may cases the shaft snaps off. See picture of blend door motor below. dc2433d7-cbf5-43b9-b143-769d332ec8b0.jpg

Mar 20, 2014 | 1998 Dodge Stratus

1 Answer

My check engine light went on and my repair guy told me that I have a broken flapper that cannot be fixed. How much should that cost?

what is a flapper never heard of one of these had a look on ebay if its for the throttle body fuel flap there on ebay for 85 to 120 dollers

Nov 19, 2013 | Mercedes-Benz Cars & Trucks

1 Answer

Fuel tank flapper valve broke

THe flapper valve will be part of the filler housing and it will require the replacing of that end of the filler tube. Possible get a 2nd hand one fromk the wreckers THe flapper will be on the bottom of the tank and I cannot see any connection to the engine light which would have come on immediately if there was a connection. Run fault codes to determine which sensor./ servo put the light on

Oct 24, 2013 | 2008 Hyundai Tucson 2.0

1 Answer

Saab 9000 cs 1996. after replacing the thermostat an flushing the radiator the ACC still wont give heat.

You didn't say if it's blowing any air at all.First check that the thermostat is of the correct temp. and is installed correctly.If you are getting cold air and not losing any coolant the your flapper valve is either stuck or broken.You'll need to simply remove the aquarium cover and look to the left rear of the blower motor.You will see the plastic flapper arm which is connected to a wirewound hook.If the hook is off the flapper just reattach it.If the tip of the arm is broken you can push the arm towards the rear of the car and wedge it in place with anything that will hold it.Doing this will give you heat until you replace the flapper valve arm.The arm can be fixed without removing the blower motor.Don't be ripped off by letting some mechanics tell you that they have to remove the blower to fix the arm.They will charge several hundred dollars and take hours to do so.

Jan 17, 2010 | 1996 Saab 9000

1 Answer

How hard is it to change the flaper that lets the heat come in the vents. the shop said the flapper is stuck. the blower blows but it will not heat. heater coil is good. how hard is it to take dash out.

Check the flapper actuating mechanism is working ok. The flapper vane may be seized up due to water/corrosion etc.
If it is lever / cable actuated, the mechanism may be seized up due dirt/rust/corrosion.
Application of WD40 (or similar) may free up the jambed lever/cable mechanism or flapper vane.

If vacuum activated, check vacuum servo and connections for air leaks etc.
Hopefully the above checks/lubrication can be performed without removing major dash components.

Jan 16, 2010 | 1999 Jeep Grand Cherokee

1 Answer

2003 ford explorer hvac flapper is stuck on the cold side. Is this a broken flapper or a vacuum problem? Is there a way to tell?

it has an electric motor to move it, sometimes with key turned forward so that dash lights come on you unplug it and it resets itself, but if not motor might be bad i have replace some that snapped the flapper because they failed to stop when at the end of cycle remove motor and inspect flapper shaft.

Jan 15, 2010 | 2003 Ford Explorer

1 Answer

Toilet keeps running. Replaced the flapper, improved the condition, but toilet keeps running slightly. Is there somewhere I can make an adjustment to the stack deal?

It's possible there's too much tension on the chain which won't allow the flapper to completely seal and let the tank fill. If this is not the case, the float may be stuck. If the float is sticking you're better off replacting it. If the tank is filling and water is overflowing into the tube, then it's the float.

Dec 13, 2009 | Cars & Trucks

1 Answer

2000 pontiac montana air conditioner driver side vent blow warm air yet passenger side and rear vents blow cold air. sometimes the driver side vent blow cold air. is flapper valve stuck sometimes?

That is correct, the air blend door actuator. "flapper valve" may need to be replaced or cleaned and free from binding up. Good luck and hope this helps. If there is an Auto Zone in your area, they can order the part you need and give you the step by step instructions to removing the old actuator and replacing it if it's damaged. Good luck and keep me posted, be glad to help. 

Aug 22, 2009 | 2000 Pontiac Montana

1 Answer

Can't get flapper to open and close inside fan heater

check that you have not trapped the vacum hose when you were fitting the new motor.

May 12, 2009 | 1995 Dodge Dakota

1 Answer

A/c not blowing

Its called a Blend door
its under the dash passenger side needs to be replaced

Aug 07, 2008 | 1995 Lincoln Town Car

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

75817 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides