Question about 2000 Nissan Maxima

1 Answer

I have a 2000 nissian maxiams coil not firing

One of my coil pack not getting fire

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 100 Answers

Replace the coil

Posted on Nov 19, 2013

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ZJLimited
  • 17970 Answers

SOURCE: code p1320 code p303 code

P1320, Ignition Signal, Primary
If the code was set after the new starter was installed, I'd check the wiring and connections from the starter/solenoid. They may have gotten damaged or the contacts were not cleaned during the install.

Specifically, 2000-2001 Maxima's have had this problem. It seams as though everybody agrees that the error is caused by the ignition coils.

P0732, Improper Ratio for Second Gear
See someone who's familair with those tranny's gear ratio error in one gear might mean it's slipping! Could be a sensor problem though!

P0303, Cylinder 3 Three Misfire Detected
A code P0303 may mean that one or more of the following has happened:

  • Faulty spark plug or wire
  • Faulty coil (pack)
  • Faulty oxygen sensor(s)
  • Faulty fuel injector
  • Burned exhaust valve
  • Faulty catalytic converter(s)
  • Running out of fuel
  • Poor compression
  • Defective computer

Possible Solutions: If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.

Hope helps (remember to rate this).

Posted on Nov 03, 2010

  • 58 Answers

SOURCE: can't git engine to fire know fire from coil.

Rechk plugs firing order. chk soliniod and coil r ok, rechk fuel is getting into engine- choking usually determines that, u can smell the over choked engine. I f engine turning & choked hold throtel to floor while cranking and leave there until it fires. if no firing happends it must be electrical. rechk electrical connections. Cheers

Posted on Sep 06, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Coil pack is firing on two cylinders


Check for cracked or grounded out spark plug wires.If one of the wires of the other two cyylinders is grounded out it will not let the coil build a charge for ignition.

Apr 10, 2014 | 2000 Daewoo Leganza

2 Answers

Back fire 2000 chevy blazer 4.3 4wd


Sorry no idea without a plug in of as diagnostic reader ,i would suspect a cam sensor but??? how long is a piece of string??

Feb 07, 2014 | 2000 Chevrolet Blazer

1 Answer

Coil packs not firing on 2000 s type 3.0 jaguar


The coils have battery voltage running through the primary windings, and grounded in the ignition control module. The engine computer signals the ignition module when to cut the primary current, thereby inducing high voltage in the coil's secondary windings and spark at the spark plug.
The computer processes all sensor information, but primarily from the crank position sensor, to determine spark timing.

Nov 17, 2013 | Jaguar Cars & Trucks

1 Answer

2000 pontaic montana wont spark


likely a bad crank sensor or bad ignition module, coil packs can go bad
to but not normally all three at the same time.if the coil packs look ok
then i would look at what tell it to fire witch is the crank sensor, the cam sensor should tell the injectors when to fire, but thats not to say they couldn't be linked in some vehicles needing singal from both for fuel
and fire to work. hope this helps

Feb 16, 2013 | 2000 Pontiac Montana

2 Answers

Just changed 3 coil packs but car still misfiires


bad ignition control module its under the coil packs

Jan 28, 2011 | 2000 Lincoln LS

2 Answers

Changed coil pack that wasnt firing started fine


check the fire to the coil pack if it's present then check the pulse to the crank sensor

Jan 14, 2010 | 1999 Pontiac Firebird

2 Answers

2001 ford 4.6 liter idles rough sometimes dies


may need 1 0r more coil packs replaced,or it could be what happened to my 2000 4.6---1 lifter expanded out and wouldnt collapse,causing the rocker arm to fall out of place and the valve could never open...try unplugging 1 coil pack at a time while running and listen for a change in the way it runs,if there isnt a change then its probably a bad coil pack,find a cylinder that runs and swap the coil packs,if no difference then its probably the valve staying shut.

Nov 21, 2009 | 2001 Ford F150 Styleside SuperCrew

1 Answer

One of the coil packs is not working on a 3800 V 6


have you tried changing the coil pack? they are simply a coil of wires inside. they easily go bad. just to be sure switch one of the coil packs to make sure its not a problem with the wiring, if the problem switches cylinders replace the coil pack

Aug 28, 2009 | 2000 Chevrolet Camaro

2 Answers

Daewoo lanos 2000 car is misfiring and wont run properly firing on cylinders 1 and 4 misfiring


have you changed the ignition wires? perhaps firing order crossed? if not coil pack or ignition wires faulty how do you know it is not "FIREING" on 1 & 4 have you tested it with a spark tester tool???

Dec 23, 2008 | 2000 Daewoo Lanos

Not finding what you are looking for?
2000 Nissan Maxima Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...