Question about Cars & Trucks

Open Question

How to replace a crankshaft sensor on a 1991 BMW 325i

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

j_del
  • 1586 Answers

SOURCE: burned out headlight/bulb bmw 1991 325i 2dr

It's a bulb replacement. If it's anything similar to my Audi, there is a cover on the back of the headlight housing that you pop off. Then you can reach in, pull the wire connector off the bulb, and unclip a metal retainer over the bulb, and pull the bulb out. Installation of the new one is the reverse. Just be SURE not to touch the glass part of the bulb. Skin oils can cause a halogen bulb to burn very hot and burn out very quickly. If you do touch the glass, wipe it gently but thoroughly on a cotton cloth to clean it off before you install it.

Posted on Oct 31, 2008

  • 219 Answers

SOURCE: BMW 325I Radio knob on/off not operating. Still

if the problem is with the knob being lose inside the radio, it can be repaired. I have been able to successfully repair every one that came into my dealership. most dealers will not attempt a repair. another alternative is to call a reputable audio installer/retailer and see if they will repair it.

Posted on Mar 23, 2009

  • 12 Answers

SOURCE: how to replace rear shocks on 2003 bmw 325i

You have to take the trunk liners off of both sides. There will be 3 13mm nuts on each side for the shocks, and under the car is a 16 or 17mm bolt that has to be removed. I hope this helps.

Posted on Apr 29, 2009

youredone82
  • 426 Answers

SOURCE: how do I RESET BRAKE LIGHT ON 2006 BMW 325I.Brake

that has to be done by a dealership with a BMW specifiic scan tool

Posted on Oct 30, 2009

  • 880 Answers

SOURCE: i nee d to replace thermostat on 2003 bmw 325i how

The thermostat is inside a black plastic housing, It is inside the housing assembly where both radiator hoses meet up by the engine. You can't replace just the thermostat, the whole housing has to be replaced,

Posted on Jan 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

325i 2006 no spark or start


Sounds like a bad crankshaft sensor. GOOD LUCK FRIEND.

Nov 15, 2014 | 2006 BMW 325i

1 Answer

Check engine light bmw 325i code 340


Code PO340 "Camshaft Position Sensor Circuit Malfunction". Now that does not mean that if you simply replace the sensor your problem will be solved. It can be simply loose, cut, or corroded wiring. It can also be something entirely different. This is where diagnostic skills come in.

May 01, 2010 | 2004 BMW 3 Series

2 Answers

How do I RESET BRAKE LIGHT ON 2006 BMW 325I.Brake pads and sensor already replaced


that has to be done by a dealership with a BMW specifiic scan tool

Oct 30, 2009 | BMW 325 Cars & Trucks

1 Answer

Where is the wheel brace on a 1991 325i bmw


Hi, I had an E30 325i and the jack and wheel brace were behind the boot panel opposite the battery.

Oct 13, 2009 | 2001 BMW 3 Series

4 Answers

2001 BMW 325i problem: Car runs very rough, but no warning lights


Sounds like a fuel problem , have you changed the fuel filter in a while ? could be the knock sensor or the knock sensor module needs to be replaced.

Jul 28, 2009 | 2001 BMW 325

1 Answer

Starter replacement


Removed top of motor, disconnected the hoses got to the starter, removed it without difficulty

Jan 15, 2009 | 1991 BMW 3 Series

1 Answer

1994 BMW 325i will not start when cold


Need a CRANK SENSOR its located on the side of the crankshaft. This provides spark reference for this vehicle obviously you are getting gad and NO spark beci=ause the car floods. Good Luck contact if you need more help. for parks check Bavarian auto or BMW or a Bosch retailer all good parts. Good Luckcontact if you need more help, thanks or using FIX YA

Jan 13, 2009 | 1994 BMW 3 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...