Question about 2002 Toyota Camry

Open Question

How to replace broken hood release cable on a 2002 toyota camry

Hood release cable broken

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 203 Answers

SOURCE: how do i replace a broken hood latch cable 2002 toyota camry

its more fiddly than hard before you start look st the cable where it joins the latch and start following it back toward the lever you may have to lift some floor mats etc and the cable should be secured with clips along the way if you think you can get it out take it with you when you go to buy the new 1 and make sure they are the same. if this helps please rate joe

Posted on Dec 06, 2008

  • 166 Answers

SOURCE: 1993 toyota hood release wont open hood

try getting a pair of pliers and gripping the cable on the back off the release and popping the bonnet,
if this is no good you may have to go to the dealer to get them to open the bonnet and replace the macanism

Posted on Dec 25, 2008

autotherapis
  • 501 Answers

SOURCE: the release cable is broken and need to get under

Take the cable that is broken and hold it with pliers. use another pair of pliers to pull the inner cable. If you can't get to the inner one go back on the main cable a little ways and cut into the out part and strip away like you would a wire.

If that does not work, you will have to remove the grill and try to get up in there. It is not fun.

Hope this helps

Posted on Nov 21, 2009

jimmybrown67
  • 835 Answers

SOURCE: How do I replace a hood release cable for my 2000

unhook from latche ***. couple clamps down driver fender holding cable -rubber gorment thru fire wall -cable handle bolts under dash - put back in reverse order

Posted on Nov 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to I open my car hood when inside latch is broken?


Under the car with a pry bar. Look where the cable goes. You will have to remove under car cowlings.

May 25, 2015 | 1996 Toyota Camry

1 Answer

How can I open the fuel door if the release lever is broken on a 2002 Toyota Camry?


you should be able to get to the cable from inside the trunk

Jul 30, 2014 | 2002 Toyota Camry

1 Answer

Toyota Camry 2002 - Hood lift wire broken - Cannot open the hood. What to do ???


You can access the hood latch from the grill. With a pair of needle nose, and a screw driver you can manipulate the mechanism and open the hood. Good luck

Nov 09, 2013 | 2002 Toyota Camry

1 Answer

How to replace 2002 camry drivebelt


to replace the serp belt you'll need to release the tensioner in the system remove the old and install the new the issue always is the proper routing for the belt follow the diagram under the hood watch the routing as you remove the old belt if a diagram isn't available under your hood request one upon the purchase of your new belt sometimes the parts store will loan or rent you the tools you need for belt replacement

Sep 18, 2012 | 2002 Toyota Camry

1 Answer

How do I replace a hood release cable for my 2000 Toyota Camry?


unhook from latche ***. couple clamps down driver fender holding cable -rubber gorment thru fire wall -cable handle bolts under dash - put back in reverse order

Nov 05, 2010 | 2000 Toyota Camry

1 Answer

How to install headlights on 2002 toyota camry


I assume you mean just the bulbs:
  1. 1 Shut off the Camry's engine and set the parking brake for added safety. Also, make sure its headlights are switched off.
  2. 2 Open the hood using the primary and auxiliary hood release latches.
  3. 3 Locate the back of the headlight assembly and determine whether the low- or high-beam bulb needs to be replaced.
  4. 4 Turn the headlight bulb socket counterclockwise to remove it from the assembly.
  5. 5 Unplug the electrical connector from the back of the bulb. Carefully dispose of the bulb to prevent it from shattering or cracking.
  6. 6 Attach the electrical connector to the new bulb and insert it into the headlight assembly. Twist it clockwise to secure its position.
  7. 7 Test the new headlight to make sure it works before closing the hood.
Thank you,
Lee

Aug 25, 2010 | 2002 Toyota Camry

1 Answer

Need to know how to unlatch hood from under car as the hood cable busted


Get strong flashlight & extended reach (long) screwdriver. Looking through grill in center of hood but towards driver side,locate hood release cable. You will see the exposed wire end coming out of the casing. Follow to hood release. With screwdriver pry it towards driver side should release first latch so you can open hood.

Jun 14, 2010 | 1998 Toyota Camry

3 Answers

I can't open my hood, the pull latch is broken, how do I open the hood?


see if you can remove the release cable fron the behind the latch. Once removed, you can hold the cable tube with one hand and pull on the cable with another hand releasing the hood. Hopefully this helps!!

Mar 24, 2010 | 2002 Toyota Camry

1 Answer

My hood release is broken and I can't get the hood up. What can I do?


Hi Doug,

The hood release cable on my cherokee slipped out of its mount on the latch a while ago. Here's how I got the hood open to fix it.

You're going to need a set of long needlenose pliers and a flashlight.

Get in front of the car and shine the light through the grill. You're looking for the release cable where it attaches to the hood latch.

There will be an anchor point for the outer sleeve where the cable itself is exposed. Grab the cable with the needlenose and pull out and to the right. You'll be surprised at how easily it clicks open.

Best regards,
Mike

Sep 25, 2009 | 1998 Toyota Camry

1 Answer

How do i replace a broken hood latch cable 2002 toyota camry


its more fiddly than hard before you start look st the cable where it joins the latch and start following it back toward the lever you may have to lift some floor mats etc and the cable should be secured with clips along the way if you think you can get it out take it with you when you go to buy the new 1 and make sure they are the same. if this helps please rate joe

Dec 06, 2008 | 2002 Toyota Camry

Not finding what you are looking for?
2002 Toyota Camry Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...