Question about 2006 Nissan Quest

1 Answer

The TCS and Slip lights came on while driving on dry roads. The vehicle aslo stalled once and took a few tries to start

My wife was driving and said the van did jerk a little right before the lights came on. She had the cruise control on.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 15,739 Answers

Check for error codes with an OBD reader, you can have this done for free at any autoparts store.

Posted on Nov 18, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 321 Answers

SOURCE: TCS/SLIP & Check Engine Light Warning

TCS is Traction Control System,and all TCS's are controlled though the Anti Lock Braking (ABS) system.Here's how it works:Each wheel,or in some cases,only the drive wheels have a speed sensor mounted near the hub or axle,and sends a speed signal to the PCM (Powertrain Control Module).The PCM monitors wheel speed continuously,and if it sees a speed out of the ordinary,say for example the right rear tire is spinning and traveling at a much higher speed than the left rear,the PCM will pulse the brakes through the ABS system on the right rear to slow down the right rear so that the left and right wheel speeds match up,this is how the traction control works.So,if you have a TCS problem,the PCM will see this and set a Dignostic Trouble Code (DTC).You need to pull the DTC's out of the system with a scan tool,diagnose and repair the DTC's.It could likely be something as simple as a malfunctioning wheel speed sensor,but you won't know until the codes are pulled out,as this will point in the general direction.Good luck.

Posted on Aug 09, 2008

pal03246
  • 726 Answers

SOURCE: TCS, SLIP and ABS lights on

Check your brake fluid first. If that is low, top it off and recheck. If its ok, than you will need one of the rear ABS sensors. You will need to plug it in and find out which side it is. That's really the only ABS issue that car has. One of the rear ABS sensors fails.

Posted on May 09, 2009

  • 14036 Answers

SOURCE: well all the Lights of ABS TCS SLIP started to

CANT FIX AT HOME,DEALERSHIP HAS TO FIX.ABS AND TCS SYSTEM HAS TO BE CHECKED WITH SPECIAL DIAGNOSTIC EQUIPMENT.

Posted on Sep 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

06 monta carlo LS traction control light comes on but there is no ABS light on.I also noticed that when iam cruising down the highway the car's tac is jumping a little and the car is jerking


Engine misfire ! If you have a diagnostic scan tool hooked up ,a professional grade . Can see misfire counter , which would show which cylinder is misfiring . A misfire would cause your jumping and jerking problem . And this would cause traction control light to come on disabling the traction control .

Dec 25, 2016 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Battery light comes on while driving. Immediately after water pump/timing belt replacement. Replaced battery and alternator tests good. Intermittent battery light remains?


It sounds as though the belt may be slipping or is not tight enough?

If it's a toothed belt it won't slip - it may not be tensioned enough where it goes around the alternator pulley. They are adjustable.

A smooth non-toothed belt can slip.

Also, check the tightness of the battery leads where they connect to the battery and to the earth - on the bodywork/engine block

Jan 19, 2016 | 1999 Lexus Gs 300

2 Answers

What does trac light mean?


destroying the transmission.possibly

Aug 09, 2015 | 2004 Buick Century

1 Answer

I have a 2003 pt cruiser, while driving it will do a little jerk. The cruise control light comes on, the oil light dings then go back off sometimes it kill sometimes it start back running right what could...


Loose connection at the ignition switch causing an off on cycle If this is the case all lights that come on before the engine starts may flash. Also on the drivers side forward of the engine there is a fuse box with the relays (fuel and others) Check each for security and condition. they pull out like a fuse.

Feb 23, 2015 | 2003 Chrysler PT Cruiser

1 Answer

I just purchased a 2005 hyundai xg350L. The tcs light is on and won't shut off. That is the only one illuminated. Could this be a fuse or something much worse.


Hi Christine,

The TCS (traction control system) will stay lit only if there was a malfunction of that system. TCS helps your tires maintain traction on slippery wet or icy roads. The malfunction is usually due to damaged or malfunctioning wheel speed sensors due to corrosion or damage of the sensor wire harness during suspension repairs or brake pad replacement. You can still drive the car, but the traction control system will not help you if your vehicle's tire slips or spins faster than the other.

Jan 09, 2015 | Hyundai Cars & Trucks

1 Answer

TCS OFF Slip


probably a wheel speed sensor has kicked the bucket, which is why the tcs light came on , have to check your ABS system to see if its functional.

Sep 11, 2012 | 2003 Nissan Altima

1 Answer

How do you reset tcs/slip light on a 1999 infinit q45


Hi there:

Pull the codes to get started. Normla process is when the slip light will flash on and then go off. TCS is your Traction Control System. It is normal for it to go off If the rear wheels are slipping. You may have worn tires or you are driving on ice or snow. Are you on a slippery surface when this happens? You can always shut the system down by pressing the TCS off button in the center console.


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Aug 17, 2012 | Infiniti Q45 Cars & Trucks

2 Answers

How do you use the traction control system. should the dashboard light be on or off


how the tcs works is when active light on dash will be on you will only feel it working tcs uses wheel speed sensors that when your tire slips and spins faster than other wheel like spinnig out on on ice snow gravel the tcs unit will use a controlled misfire that will **** or jolt giving traction and will stay engaged until spinnig stops or you let off gas basicaly it uses the engine to **** not allowing wheels to spin out to get a feel turn on tcs find a gravel or snowy road accelerate trying to make the car slip you will feel car start to **** it works well try it so you get a feel incase you trigger tcs and catches you off guard

hope this helped
plz vote comment if any more questions reply

Jan 18, 2011 | Saturn Aura Cars & Trucks

Not finding what you are looking for?
2006 Nissan Quest Logo

249 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...