Question about 2003 Toyota RAV4

1 Answer

My vehicle cuts out and stalls when stopping and cornering sometimes, it alsoseems to want to cut out when driving occasionally . i have changed the oxygen and air fuel sensors as i did have a engine

When car running properly it is really smooth and crisp

Posted by on

  • Saleem Shams
    Saleem Shams Apr 02, 2014

    Hi, its very simpel i solve this problum for my costomer, change the computer, or if some one fix the computer tell to fix it,

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 113 Answers

If check engine lights is off since replacing air fuel ratio sensors then try cleaning throttle body. If light is on, check for DLCs If same codes , change mass air flow sensor and clear codes and retest

Posted on Nov 18, 2013

Testimonial: "thanks tim,cleaned the throttle body as the problem was getting worse the car started jerking and wanting to cut out when driving ,problems still there so im going to change mass air flow meter,anyway thanks again"

  • john stanton
    john stanton Dec 17, 2013

    changed the mass air flow sensor/meter still problems and now i have changed the idle control valve and still the problem exists wondering any more suggestions

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 108 Answers

SOURCE: 96 tacoma 4x4 2.7 engine cuts out randomly, like

dont look for air when the car cuts out its most likley spark or fuel when it cuts out ranomly its usually a sensor or relay that is faulty check fuel pump relay and camshaft or crankshaft sensors but first narrow it down to spark or fuel if possible also if check engine lite is on check codes

Posted on Mar 26, 2009

  • 40 Answers

SOURCE: engine light is on ,code P0171, hesitates when start driving

you will need a code reader to turn light off

Posted on Jun 02, 2009

  • 1986 Answers

SOURCE: toyota mr2 roadster 2001 engine light on code po141 oxygen sens

bank 1 will be whichever side cylinder 1 of your engine is and bank 2 will be the opposite side. It's named bank 1 and bank 2 so that no matter how the engine is laid out, bank 1 is always on the same side as cylinder 1. I cannot say whether the right hand or the left hand one will be bank 1 as I do not know where your cylinder 1 is. The garage should know

Posted on Sep 08, 2009

  • 318 Answers

SOURCE: i have a toyota rav4 2003 management light came on

The upper sensors are air fuel sensors and the lower ones are o2 sensors. you cant mix these up. Assuming you did everything right and still coding then either the new sensor b1s2 is bad or the wirng(power and ground need to be checked. A scan tool can be used to look at the performance of the sensors too. Sometimes the codes just point to the area of the problem and changing the part isn't the answer.

Posted on Nov 15, 2009

  • 714 Answers

SOURCE: 1986 toyota truck 22r fuel injected. runs to rich

check for a vacumn leak, my buddy has a 96 dually that did that,found out it was his temp sensor to the computor,was showing a negative # when i tested it,he replaced it and it fixed everything! He couldn't believe it LOL

Posted on Jan 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 kia sportage 4x4 its starts idles runs and then sometimes it stalls while driving cuts out and dies fuel pump has been replaced relays have been replaced fuses and fuel filters help!


Does your vehicle "hop" forward a bit when you are driving or coming to a stop. I had a similar complaint about my 2001 Pontiac Grand Prix and for me it was a mass air flow sensor replacement needed. The other thing it could certainly be is a clogged catylitic (sp?) converter. That will cause the symptoms your vehicle is having too. Good Luck. Hope this was helpful to you. Have a great day!

Aug 30, 2015 | Kia Cars & Trucks

1 Answer

1999 Chevy Venture stalls while stopped and sometimes while driving


Well it could be several differant things .It depends on how it stalls .If it just cuts off in an instant meaning its running good one second and the next it stops running completly then its likely an electrical problem . But if it starts sputtering and looseing power then stalls its more likely a fuel related problem witch is more likely .My best guess would be a colged fuel filter or a bad fuel pump .If you arn't getting engine lights comeing on or even if you are and then they go out by it self the fuel filter is the first thing to look at and its the easyest and cheapest thing to do .The filter on your vehicle will be located under the drivers door and mounted to the inside of the frame rail .On a 99 if its never been changed its time it should be changed every 4 to 5 years . I can't say for sure but it sounds like the most likely problem and it can't hurt it costs about 10 dollars .See if it helps good luck

Apr 03, 2012 | 1999 Chevrolet Venture

1 Answer

Kia Rio cutting off


im assuming that changed the oil unit you mean sending unit ? if so could be electric short in the pick tail or worse wiring harness. second there is also possoble vacum leak .third while unit was being replaced something didnt get put back or got knocked loose. created a new problem. most times as thing are going bad they dont register until it is a prolonged problem as it took 2 days for the check engine to go out that also might have been normal. you might also notice while sitting at park when you turn the wheel you will notice ia differance in the idle, if its almost stalling then its probley your idle,needs re set, or your idle controle valve is going bad ,did it get checked or cleaned when they serviced the throttle body. and also could be your mass air flow sensor going bad or need cleaned

Jul 08, 2010 | 2003 Kia Rio

1 Answer

4 wheel drive lock up


hey charlie, 1st problem is 4 wheel drive being engaged on dry pavement. You should only have it in 4x4 in snow, or off road on sand, dirt,etc. Newer all wheel drive vehicles compensate for the tires rotating at different speeds, like going around a sharp corner. The wheels on the outside of the turn have a longer distance to travel than the wheels on the inside of the turn. This results in the vehicle feeling like it's jumping, hopping or jerking as you cut a tight turn. You can damage your 4x4 system, as the wheels are fighting each other, trying to turn the same # of rotations, and something can and will give (like blowing the transfer case). If your light is staying on after changing to 2 wd, it is possibly stuck in 4x4. To shift from 4wheel to 2 or 2wheel to 4, you should be traveling in a straight line, let off the gas, change in or out of 4x4, resume driving. 4x4 low range requires a complete stop to engage.

Oct 15, 2009 | 1992 Dodge Dakota

1 Answer

Vehicle Stall - Ford Focus X Reg


I will suggest some cheap areas to try first.
1.Wiring connections to your computer under the dash.
2.Check wiring to fuel pump.
3.Check black boxes under hood. They have relays and terminals may corrode.
4.Ignition switch, sometimes with heavy keychains the contacts can loosen.

Take it to Autozone or Oreillys for a free scan. When you say car cuts out, does anything work like lights, horn, radio? Please post symptoms and if anything has helped you.

Sep 21, 2009 | 2000 Ford Focus

1 Answer

My hyundia tucson keep cuting off when i drive the jeep and i have to stop it cut off any time i stop it cut off and when my foot on the brake it move when myfoot is on brake


If the vehicle is stalling when coming to a stop or slowing, look at your throttle position sensor on the throttle body. it is small, almost a box with 2 phillips head screws(not the sensor with hex head bolts, right behind it). If it is grey in color, change it.

Aug 06, 2009 | 2005 Hyundai Tucson

1 Answer

Random stalling


try a crankshaft position sensor

Jun 06, 2009 | 1991 Jeep Cherokee Briarwood

2 Answers

Engine cutting out at stops occasionally


could be fuel filter clogging up... fuel pump, or bad alternator going out...

Mar 12, 2009 | 2002 Mazda MPV

2 Answers

Corsica stalls at stop signs


sounds like the EGR valve is sticky, take a small screw driver and tap the valve when the engine is at idle and you will notice a change in the way the engine runs, if the vehicle smooths out disconnect the valve and drive the vehicle and it should not cut off please let me know and dont forget to rate me!!

Dec 02, 2008 | 1988 Chevrolet Corsica

Not finding what you are looking for?
2003 Toyota RAV4 Logo

177 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...