Question about Mazda MPV

Open Question

Need to adjust steering rack in mazda MPV 2000

Need to adjust right hand steering rack for Warrant of Fitness

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
txkjun
  • 409 Answers

SOURCE: how do i replace the alternator on mazda mpv 2000?

Remove negative (-) battery terminal from battery. Remove drive belt from alternator pulley. Remove wiring harness (electrical connections) from alternator. Remove attaching bolts for alternator. Pry out alternator. Reverse steps to reinstall. 

Posted on Dec 28, 2008

Ad
  • 1 Answer

SOURCE: 2000 Mazda MPV

I NEED THE DIAGRAM FOR SERPENTINE BETL FOR MAZDA 2000 MPV

Posted on Jan 20, 2009

  • 1 Answer

SOURCE: 2000 Mazda MPV Heating problem

The heater lines that run to the back of the right rear side gets rusty and start to leak anti-freeze. There is a black cover under and above the RR tire that has to be removed so u can see.

Posted on Feb 09, 2009

  • 10 Answers

SOURCE: how do I replace alternator in mazda mpv 2000?

Typically an alternator is an easy fix. It requires removal of the belt from the engine running it, and a few bolts that attach it to the engine.

Because of the engineering with the 2000 mpv, it is a very difficult fix, and one that requires removal of the transaxle and exhaust manifold, as well as removal of the lower engine mounts. It will take a qualified Mazda mechanic 3.5 hours to do the fix - you can (at least) triple that amount of time as a DIY project (assuming you have the right tools).

Posted on Nov 02, 2009

lindsay836
  • 677 Answers

SOURCE: I repair the motor of my mazda mpv 2002 and it doent started

You need timimg marks, There are the internal marks for installing timing chain, you follow the marks on the crank and cam and line them up, for the Ignition timing you follow the marks on the crankshaft harmonic balance, and the marks on the timimg chain cover for top dead center ect..

Posted on Feb 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you adjust hand brake on a 1998 Mazda MPV


You will need to replace the parking brake shoes on the rear wheels. Also check all the cables and hardware going to the parking brakes.

Jan 17, 2017 | 1998 Mazda MPV

1 Answer

What location of power streeing pump mazda mpv 2000


The most common source it the high pressure hose that feeds the rack-n-pinion from the pump, or the pump itself. If you follow the large hose from the reservoir it will lead you to the pump. The small metal line leaving the reservoir going to the rack will be the pressure hose. The rack itself is also a good source for a leak. You basically need to get the van up in the air and dry everything off the best you can and look for a source of your fluid loss.

Aug 23, 2014 | Mazda MPV Cars & Trucks

1 Answer

2000 mazda mpv turn signal repair


check the fuses . the box is under the steering column left side check the one which indicates turn signal

Apr 07, 2014 | 2000 Mazda MPV

1 Answer

Can you adjust thebrack and pinion on a 2000 Sebring?


Hi Jim, What about the rack ends? They also wear out. Chock the wheels and apply the parking brake, jack up the front end and test for play by moving the road wheels left and right by hand. If the play is there remove the rubber boots and check for wear on the rack ends (coming out from the rack) If you see movement from the rack its self the whole unit must be replaced. Regards John

Jul 21, 2012 | 2000 Chrysler Sebring

2 Answers

I have a mazda mpv 2000 and something red colour is leaking from it. is anyone knows what it is and what should be done to fix the problem?


I didn't realize that that red fluid was coming from my 2000 MPV until the transmission burnt out in the middle of a four hour drive. I highly recommend checking the fluid level (top it up if it's low) and getting it to a mechanic. You may save yourself a couple thousand. My leak was at the front of the car, driver's side. Just a tiny little hole in dull silver tube...

Dec 17, 2009 | 2000 Mazda MPV

1 Answer

Where is the power steering resorvoir on a mazda mpv 1999


If this is the same as my 91 (No MPVs Show for 99) the power steering is located on the passenger side behind the alternator and its a pain to get to if you dont know where it is. Make sure you have it outside in the sun and you will see the filler dipstick. That is where the resovoir is located. Its actually right at the power steering pump location if its like my 91.

If its like the 2000 (or so) its an actual seperate resovoir on the passenger side fenderwell. Its in an obvious place so it you cant find it Im guessing your engine is inline and rear wheel drive like my older MPV and youll find it behind that alternator.

Hope this helps and lf it does dont forget to rate the solution.

Mar 22, 2009 | 1999 Mazda MPV

2 Answers

Mazda MPV LX 2000


Yes, that was too much. The neutral safety switch costs around $70 (if I remembered right). I bought it from my Mazda dealer and asked them for a diagram to locate it. In most cases, my Mazda dealer has been helpful in provide diagrams for this minivan. The switch is located underneath the battery (you'll have to remove it) on the transmission. Make sure it is aligned right when you replace the switch; otherwise it won't find neutral, and you'll have to use the bypass switch on top of the steering column to start you engine.

Jan 24, 2009 | 2000 Mazda MPV

2 Answers

2000 Mazda MPV


I NEED THE DIAGRAM FOR SERPENTINE BETL FOR MAZDA 2000 MPV

May 17, 2008 | 2000 Mazda MPV

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...