Question about 2010 Chevrolet Captiva 2.4

Open Question

There is a sound at the car right side when i push the fuel

When i push the fuel with my legs even the car not moving i hear there is a sound like a somthing need to be tight and this sound little increase when iam on the drive way so how i can know from where this sound is realy little noisy

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 60 Answers

SOURCE: 2008 malibu drive noise

Check the CV (constant velocity) joints and boots.

Posted on Apr 24, 2010

Ad
  • 3 Answers

SOURCE: Wobbly sound in the drive train: Replaced left

having the same type of noise in mine. I dont think you had to change the axles because though it may sound like it they were probably ok. I have been trying to fing the part for mine that it sounds like you need. It's the transmission, there is a aftermarket part that doesn't cure the problem but allows you to get more use out of the car. It is a sleeve that goes in the tranny were the axle seal is and keeps the axle strait so it doesn't bang around in the tranny but unfortunatly I have not been able to find anywhere that has it anymore. still looking. this problem was common to that year car and I talked to a transmission shop and thats where I found out about this problem after I did everthing you did with the axles and the bearing and he told me these cars all had this problem, sorry I cant help you find the part but at least you have an idea of the problem

Posted on Sep 25, 2010

  • 2006 Answers

SOURCE: There is a squeaking sound

It sounds like your brake is hanging up to me. I would pull the wheel off the suspected side and check your brakes.

Posted on Aug 28, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How do I open stuck fuel door on 1998 lincoln mrk 8


There is another release in the right rear passenger side of the trunk. A little WD-40 on the latch will help.

Mar 01, 2015 | 1998 Lincoln Mark VIII

1 Answer

Why won't the drivers side window in 2000 Taurus won't go up. Can hear the click, window won't move.


Not sure about an easy fix other than putting plastic over the window. It sounds like the motor that pushes the window up may be seized up.

Jul 18, 2014 | 2000 Ford Taurus

2 Answers

How do i change the fuel filter


hello...follow these steps to replace fuel filter on your Grand Marquis:

1) Apply the parking brake. Unscrew the gas filler cap from the fuel tank on the driver's side. Open the hood and disconnect the negative cable from the battery

2) Go underneath the car from the driver's side. Look for the fuel filter mounted to the vehicle chassis just below the driver's seating area. You should be able to identify the fuel filter as a metal cylinder attached to a black hose. This hose is your fuel line and it should run from the fuel tank at the rear of the vehicle to the engine
3) Notice that the area between the fuel filter and the fuel line is covered by a set of push-connect fittings. Remove these fittings using a flat-head screwdriver. Simply slide the screwdriver between the legs of the clips and push outwards until the legs of the clips open up. Remove the push-connect fittings and set them aside. The fuel line should disconnect from the fuel filter when you remove the push-connect fittings. If the fuel line does not disconnect, pull on the fuel line until it detaches from the fuel filter.

3) Loosen the fuel filter retaining clamp that secures the filter to the chassis of the vehicle---
Slide the fuel filter out of the retaining clamp and discard it.

4) Slide a new fuel filter into the retaining clamp. Tighten the retaining clamp over the fuel filter to secure it to the chassis. Align the fuel line with the inlet and outlet lips of the fuel filter. Push the fuel line onto the fuel filter until you hear an audible click. Attach the push-connect fittings over the area where the fuel line and the fuel filter meet.

5) Reconnect the negative cable to the battery. Tighten the gas filler cap to the fuel tank. Turn on the ignition and allow the car to idle for a few minutes to pressurize the fueling system.

Visual check for leaks...that's it, you are done.
Good luck & i hope this helps FixYa!

Aug 28, 2011 | 1994 Mercury Grand Marquis

1 Answer

How to change a fuel filter on a 1994 mercury sable


this is for a 3.8 GS the fuel filter is located near the right rear tire


RELIEVING FUEL SYSTEM PRESSURE

  1. open the trunk. on the driver side pull back the carpet and you find the fuel cut switch. take your open hand and slap the side of the switch. it should pop up. now get in the car ans start it and run it till it stops. when it dies try to start once more.


REMOVAL & INSTALLATION

  1. Disconnect the negative battery cable.
  2. Remove the push connect fittings at both ends of the fuel filter. This is accomplished by removing the hairpin clips from the fittings. Remove the hairpin clips by first bending, and then breaking the shipping tabs on the clips. Spread the 2 clip legs approximately 1 / 8 in. (3mm) to disengage the body and push the legs into the fitting. Gently pull on the triangular end of the clip and work it clear of the fitting.
  3. Remove the filter from the mounting bracket by loosening the worm gear mounting clamp enough to allow the filter to pass through
  4. detach lines from fuel filter. move small bucket or whatever to catch what left in lines ( filter will still have gas in it)
  5. Install the new filter in the mounting bracket, ensuring that the flow direction arrow is pointing forward. Locate the fuel filter against the tab at the lower end of the bracket.
  6. Insert a new hairpin clip into any 2 adjacent openings on each push connect fitting, with the triangular portion of the clip pointing away from the fitting opening. Install the clip to fully engage the body of the fitting. This is indicated by the legs of the hairpin clip being locked on the outside of the fitting body. Apply a light coat of engine oil to the ends of the fuel filter, then push the fittings onto the ends of the filter. When the fittings are engaged, a definite click will be heard. Pull on the fittings to ensure that they are fully engaged.
  7. Tighten the worm gear mounting clamp to 15-25 inch lbs. (1.7-2.8 Nm)
  8. open the trunk again and push the button on the fuel switch down and reconnect the battery and start the engine and check for leaks


tar171.jpg

Dec 17, 2010 | 1994 Mercury Sable

1 Answer

Power seats will not go back far enough for my long legs!


you have to push the seat back while you push the button in the back motion! your motor for the power seating is dying same thing while mine it will work though just for you to drive with your long legs! but when u shut the car off and put it in park it moves far back enough for you to get out right???

Dec 29, 2009 | 1999 Jeep Grand Cherokee

1 Answer

There is a humming sound coming from the front end of my 1999 oldmobile alero. Only happens when the car is moving. I dont hear itat idle or even when pushing the gas at idle. could it be my transmission...


Hello! If the humming noise is speed related(gets louder as vehicle speed increases)check front wheel bearings. If the noise goes away when turning one way or the other then it will most likely be in the front wheel bearing. If you turn the wheel(while moving)to the right and the noise goes away it is on the right side. If you turn the wheel to the left and the noise goes away its on the left side. Hope this information helps!

Sep 13, 2009 | 1999 Oldsmobile Alero

1 Answer

Need to find fuel cutoff inertia switch in a 1996 ford ranger - will this cause fuel pum to not even hum? Can I hear fuel pump since it is inside gas tank? Can bad relay cause fuel pump to not work?


it is locate under dash board. a little to the right of center it is about 3/4 inch by 1inch is proably red or orange with a push button on one side. push the button

Aug 06, 2009 | Ford Ranger Cars & Trucks

3 Answers

Car randomly stalls when i stop or even while i drive


It sounds like your fuel filter is clogged or your fuel pump is going bad. When this happens see if you can hear if your fuel pump is running. Turn the key forward to the run position and listen near the gas tank. you should hear a vibrating sound. If you don't hear it at all the pump of pump relay is bad. If you hear it continually your fuel filter, pressure regulater, or fuel line have problems.

Jul 25, 2009 | 1999 Honda Accord

Not finding what you are looking for?
2010 Chevrolet Captiva 2.4 Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...