Question about 2010 Toyota Corolla

Open Question

Remote starter on car cranks engine but car won't start

Starts perfect with keys

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
gordanddar
  • 477 Answers

SOURCE: engine cranks car won't start

Sorry..... 1 notch off is just not good enough. It has to be exact , then if it doesn't run start looking at other posibilities.

Remember that the camshaft turns twice eash time the crank turns once. The distributor rotor works off a gear on the cam.
Your rotor could be off a bit , or it could look exactly perfect the way it was when tou took it out , and still be 180 degrees off.
You have to get your engine to "top dead center" and make sure everything is the way it should be.

A timing chain ( or belt ) can cause permanent and fatal damage to the valve train and pistons in motors that are "interference engines" Find out weather yours is. In a non-interference engine , the clearance between the valves and the pistons is large enough to alow them to move out of time without crashing into each other. An interference engine is not so forgiving.

The fact that your engine cranks makes me hopefull that it is a non interference engine , and that damage has not been done.

Try to find a haynes manual for you vehicle , it will walk you through the steps for most repairs.

Posted on May 10, 2009

Ad
  • 95 Answers

SOURCE: 1989 Toyota Camry, the starter cranks, but with a

Check the backlash of the starter it may require a shimm if it has a high pitch wind when starting....make sure the flywheel isnt damnage or missing teeth...

Posted on May 19, 2009

fixyathing
  • 341 Answers

SOURCE: How do I change the starter in a 2000 Toyota Camry LE

i'm sure it's not the starter itself that is the problem, have the stater's solenoid checked...it might be stucked. It's quite a lot of work removing the starter but you can do it if you are willing enough to learn. You just need the right idea and tools to do it. Hope this will help save you bucks!

Posted on Aug 10, 2009

  • 1 Answer

SOURCE: I have a 2000 toyota avalon ignition problems

Hello I have simular problem the ignition on is stuck in that position with the key turned off and out of the ignition switch.It feels like the key switch is spinning freely in the ignition. Do I need an ignition switch?

Posted on Aug 05, 2010

flbergeron68
  • 541 Answers

SOURCE: Starter occasionally makes grinding noise and does

broken teeth on flywheel or starter pinion. take starter out and bench test it. if starter seems good and no teeth are missing/worn, inspect flywheel through starter whole

Posted on Jan 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 1995 chevy s 10 won' start. I like to try hot wire.crank but will not start.help me??


Won't start how ? no crank - no start , which means when you turn the key to the start position nothing happens , starter doesn't engage. Or the starter turns the engine an it doesn't start an run. a crank - no start ?

Nov 20, 2015 | Chevrolet S 10 Cars & Trucks

1 Answer

1993 Honda Accord will not start with the Key but will push start.


hi make sure there is no starter kill circuit aftermarket alarm ,or remote starter if so i need the brand of the system by jumping the starter under the hood with remote start u need the ignition key to be in the run position before u crank the engine over then if it is the starter relay in the fuse box under the hood the engine will run just relace relay or check wires under the fuse box for corrosion hope it helps danny

Apr 30, 2014 | 1993 Honda Accord

1 Answer

Remote starter won't start engine, now check engine light is on


Need more information. Does the car start normally with a key? Is there a switch for a mechanic to disable the remote start while working on it (some units have a toggle switch)

Apr 06, 2013 | 2008 Chevrolet Silverado 1500 2WD

1 Answer

2003 lexus es300 won't start... radio lights and windows work. Tried a jump start, still doesnt work...


Are you saying the engine cranks but won't start, or the engine won't crank ?
If the engine does not crank, you would check for voltage at the starter, the neutral safety switch, and the key switch as well as the ground connections.

Sep 18, 2012 | 2003 Lexus ES 300

2 Answers

It won't turn over


Try this procedure:
Check the battery like this:
Turn on the headlights, then try to start the car.
If the headlights do not dim or go out, then the battery is likely ok.
Check that the battery cable plus post, goes to the starter, Minus post to a good ground, like the engine.
If wiring is ok, then look at the starter solenoid for a good connection, and proper voltage at the starter.
Problem is most likely the Solenoid's bendix gear or starting relay, Have someone bang on the starter while you try to start the car. This usually works by dislodging the bendix gear..
Hope this helps.

Jul 27, 2012 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Mini van wont start battary charged new altanator and starter all wires are grounded


Do you mean it won't start, or won't crank.
You should have a neutral safety switch between the key switch and the starter to prevent you from cranking the engine in drive or reverse.
A defective switch would keep the engine from cranking.
A mechanic would check for voltage at the starter on the wire from the key switch and go from there.

Jul 25, 2012 | 1997 Dodge Caravan

1 Answer

My 2002 Yukon Denali XL shut down while my wife was driving it on the highway.When I reached her the truck's battery was completely dead. I purchased a new battery and now there's power but the...


Define - It attempts to turn over but won't catch and run ???? When you turn the key to start does the starter engage an spin the engine ? This would be a crank no start condition . If the starter doesn't engage an spin the engine this would be a no crank no start condition . Sorry to ask but i have only been an auto tech for thirty years an have heard a lot of different discriptions for these simple actions . crank no start or no crank no start . Very different diagnostic procedures . So when you turn the key to start , does the starter engage an spin the engine ,but won't start an run ?

Jan 27, 2018 | 2005 GMC Yukon Xl Denali

3 Answers

Security on. car wont crank. can trun key wont


verify that you have a fully charge battery and that you have the same amount of voltage at the battery as at the starter when the key is turned to the start position. If not repair fault at positive cable either at battery or at starter. If voltage checks good. Use a remote starter and turn key to the on position and try to crank over engine with remote starter. if engine cranks over. You have a defective starter solenoid and starter must be replaced.

Mar 26, 2010 | 1997 Infiniti.5 Q45

Not finding what you are looking for?
2010 Toyota Corolla Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...