Question about Cars & Trucks

2 Answers

2003 ford focus lost only ign key had dealer cut new key and program and car will not start

Pats immobilizer is stopping engine start

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 2 Answers

I lose code radio CITROEN XANTIA tov885 fd0800079078463 phacffy9078463 PHF 9078463 22kc200/35

Posted on Nov 18, 2013

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,005 Answers

The key is not programed correctly return it to the dealer and, have them fix it then test it at the dealer before you leave

Posted on Nov 18, 2013

    OSCAR Nov 18, 2013

    i lose code radio CITROEN XANTIA tov885 fd0800079078463 phacffy9078463 PHF 9078463 22kc200/35



6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 225 Answers

SOURCE: Ignition key code problem

"...or is there a receiver in the ignition that could be faulty?"

Hi, I think you will find that there is a little coil in the steering column near where the key goes in which "reads" the key. Whether that is faulty or not is another matter. The best way forward is to get a list of fault codes from the onboard diagnostic system and take it from there. You could either go to a VW dealer, or if you are technically minded you could buy a £15 interface cable, download some free "VAG diagnostic software" and run it on a portable computer.

Hope this helps.D

Posted on Jul 20, 2008

  • 1 Answer

SOURCE: Is there a way to program a new key with only one existing key?

Hope this helps

Posted on Oct 20, 2008

  • 235 Answers


no, you will half to get it towed to dealer and have a computer chip key cut from your spare key then thay will program it to the vehicle

Posted on Jan 22, 2009

  • 205 Answers

SOURCE: honda ridgeline key fob program

If it is a factory keyless system than you do need it done by the dealer, but if it is an after market system then reply back with manufacture and model.

Posted on Oct 17, 2009

  • 78 Answers

SOURCE: Factory alarm has cut off the motor

Order and program a new remote.

Posted on Apr 30, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I replaced immobilizer coil . still getting theft light code 11

Reading Ford Immobiliser Codes PATS - YouTube

? 2:00
Mar 31, 2011 - Uploaded by Ask The Mechanic
How to read Ford Immobiliser codes when your car won't start. PATS (PASSIVE ANTI THEFT SYSTEM) ... and milage appeared, but red light still flashing 1:6 Found Fordwiki, and Youtube, ... a scanner with Body Control software you would get a code of B10D7 for code 11.Missing: taurus

Starting difficulty due to defective anti-theft control module ... > Problems > Kia > Sedona
2003 Kia Sedona120,000Visitor ... no knowledge of this easily findable problem with the Vehicle Immobilizer Control Module. ... Upvote (11) .... I have replaced the temp. sensor and I am still getting a PO118 code. ... Check Engine Light Stays on since purchase of 02 kia sedona with 89,000 mileage. ... Ignition Coil May Fail.

KCSS-Transportation-Technology - Ford Passive Anti-theft ...

Jan 21, 2016 | 2003 Ford Taurus

3 Answers

What does it mean when the ford PATS light is not flashing?

Try turning engine over with the head lights on, do the head or dash lights dim? Check earth straps, eg. battery to chassis, engine block to chassis, battery to engine block, (may not have battery to engine block), then check starter solenoid/relay and motor, then Check all power fuses, and fuse relays.

Oct 16, 2014 | 2003 Ford Focus

1 Answer

How to defeat immobilizer (red l.e.d.)

The immobilizer cannot be defeated. The key has a code that's stored in it, which the immobilizer needs in order to give the go ahead to the rest of the car to start.
Tow the car to a dealer and have them cut a new key for it, and reprogram it.

Apr 19, 2014 | 2004 Ford Focus

1 Answer

2003 Ford Focus PATS light not blinking and car won't start

I don't believe there is a problem either.
Under normal conditions the security light should come on then go off if the correct key is being used.
The problem could be the key switch or the neutral safety switch if it is an automatic trans. There are other possible causes.

Apr 03, 2013 | 2003 Ford Focus

1 Answer

I have 1999 isuzu rodeolost my key cut new one engine cranking no spark or injector what can i do

sounds like the lost ket is a PATS key, and the new cut key, while matching tumblers in the ignition is not coded to the PCM to allow starting. recommend check with dealer, have your registration and VIN# ready, dealer can reproduce a PATS key that should start your vehicle.

DW Mylin

Nov 27, 2012 | Cars & Trucks

1 Answer

I need a replacement key and have the vin number my local dealership says 2003. Cant drive my truck what can I do?

If you have a lock smith that can program PATS keys, they might come to your house to cut and program 2 new keys, else you will need to tow it to the dealer.

Without 2 keys or the WDS / NGS tools from Ford ( or the locksmith PATS equipment ) you cannot add a key to drive it, it needs to be programmed.

Dec 30, 2010 | 2001 Ford F150 Styleside SuperCrew

1 Answer

Lost keys to truck got new ignition with keys but still wont start 99 f150

The 1999 F-150 has a PATS ( Passive Anti Theft System ), where te keys need to be programmed to the truck.

For the owner to do this, you need 2 keys ( not 1 key and a clone of the same key ) or you need to have a higher end mechanic / dealer or a PATS programmer locksmith to program the new keys.

The truck basically thinks it is trying to be stolen, and the PATS system is stopping it.

Mar 14, 2010 | 1999 Ford F150 Regular Cab

1 Answer


no, you will half to get it towed to dealer and have a computer chip key cut from your spare key then thay will program it to the vehicle

Jan 21, 2009 | 2004 Ford F150

2 Answers

Is there a way to program a new key with only one existing key?

Hope this helps

Oct 20, 2008 | 2004 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides