Question about Cars & Trucks

Open Question

Replace headlight switch in audi tt mk1 - Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
j_del
  • 1586 Answers

SOURCE: 2002 Audi TT

Nothing special at all - just remove the back cover on the headlamp and you'll see inside that the bulbs are pinned in place with hinged metal wire clips. Release the clips and the bulbs should come right out.

Posted on Sep 15, 2008

Ad
  • 51 Answers

SOURCE: Do I need to remove the inner door panel to remove

Unfortunately, you have to take the whole door panel off to replace it,
the door panel instructions are really simple as long as you have two people the only issue which is diificult is getting the door release cable back in - just a little tricky. Good luck!

Posted on Oct 13, 2009

  • 1986 Answers

SOURCE: Can't adjust the height of the headlights

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 04, 2009

JettaRed
  • 7 Answers

SOURCE: Audi TT HID bulb needs replacing

You can change the bulb easily yourself in about five minutes, especially on the passenger side. You may want to disconnect the battery, though I don't know if that is necessary. You may also want to handle the bulbs wearing latex or nitrile gloves so as to not get your skin oil on the glass.

1. Remove the decorative cover that conceals the Coolant reservior. There is a single philips screw near the firewall that holds the cover down.

2. Find the back of the headlight and pull the metal wire clip that holds the back of the headlight cover toward the engine. Remove the cover.

3. Look inside and find the back of the HID bulb--it will be toward the outside fender. Twist the connector until it separates.

4. There is a retainer ring that holds the bulb in. Again, twist that until it comes loose. The bulb should come right out.

5, Put the new bulb in, noticing the notch is on top. Also, attach the retainer ring. It is marked "Top" to help orient it. Reattach the connector with a twist.

6. Make sure everything is firmly in place. Reconnect your battery and test the lights. Finish putting anything else back on.

Good luck.

Posted on Nov 21, 2009

JettaRed
  • 7 Answers

SOURCE: Audi TT Intermittent headlight

I'm having the same problem with my 2004 TT. I've narrowed the problem down to being the bulb. I swapped bulbs with the driver side and the problem followed the bulb. Your solution is to replace the bulb. You need a D2S 4300 K bulb. It's best to replace in pairs. Try here: http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=290310078483

You can change the bulb easily yourself in about five minutes, especially on the passenger side. You may want to disconnect the battery, though I don't know if that is necessary. You may also want to handle the bulbs wearing latex or nitrile gloves so as to not get your skin oil on the glass.

1. Remove the decorative cover that conceals the Coolant reservior. There is a single philips screw near the firewall that holds the cover down.

2. Find the back of the headlight and pull the metal wire clip that holds the back of the headlight cover toward the engine. Remove the cover.

3. Look inside and find the back of the HID bulb--it will be toward the outside fender. Twist the connector until it separates.

4. There is a retainer ring that holds the bulb in. Again, twist that until it comes loose. The bulb should come right out.

5, Put the new bulb in, noticing the notch is on top. Also, attach the retainer ring. It is marked "Top" to help orient it. Reattach the connector with a twist.

6. Make sure everything is firmly in place. Reconnect your battery and test the lights. Finish putting anything else back on.



Posted on Nov 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where i can find Audi TT 2002 starter relay? what name it is and where it is located? thx, Henri


hi starter relay of Audi TT 2002 its located under the carpet where the passenger beside driver all the relay is there

Apr 15, 2017 | Audi Cars & Trucks

Tip

Positioning tailpipes


twisting the centre section on the Milltek exhaust system for the Mk1 Audi TT 1.8T quattro effects the positioning of the tailpipes.

on May 19, 2008 | 2005 Audi TT

1 Answer

Manuals audi tt


The pumps are likely for the headlight washer nozzles which protrude when in use and retract when not.

Aug 31, 2014 | 2003 Audi TT

1 Answer

Mk1 Roof goes down but not up


I would try a new relay anyway sometimes they will route the circuit through different points of the relay. I also would check the up/down switch itself to make sure it is working on both sides I had the same problem on a window switch for a car I was working on. Just because one side of the switch works doesn't mean the other side does. If the relay and switch are both good then I would switch the wires on the up/down switch to see if it functions then you are basically checking the continuity of the switch again but this time you will be able to tell if the switch is able to handle the amperage also required to operate the motor. You can read 12 volts

Mar 27, 2014 | 2003 Audi TT

1 Answer

The xenon headlights on my 2002 Audi TT quattro are aiming down. Can only see about 10 feet in front at night. Recently had the headlight sensor replaced & was told that the headlights would adjust...


go back to were you had the sensor replaced and have them repair the problem this should have been working properly before it left the shop.it could even be a bad sensor.

Sep 10, 2011 | 2002 Audi TT

1 Answer

Audi TT Mk1 will not start.


Hi, did you sort the problem with your tt? I have exactly the same issue, apx engine, will not start, ecu not readable by vagcom or snapon scantool? Any advice gratefully recieved. Craig.

Jan 10, 2010 | 2000 Audi TT

3 Answers

2005 Audi TT Master Fuse location


Had a similar problem audi come into my shop.  No headlights, blower motor would not work, wipers would not work.  After dinking around found ignition switch wires had burn't up.  Remove top steering column by taking out two very small philips screws from under column.  Look at top LH side of column w/ top cover removed.  Probably will find wires burnt up.  

Mar 04, 2009 | 2001 Audi TT

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...