Question about 1995 Chevrolet C1500

1 Answer

Starter will not engage - not even a click

Replaced starter - does not engage. Connected to another car battery and got it to engage. Reconnected tothe Chevy and nothing - not even a click. Battery was fully charged so we are not sure what to check next.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Contributor
  • 40 Answers

Check hot wire to starter from battery also in line fuse

Posted on Nov 18, 2013

  • robert burns
    robert burns Nov 18, 2013

    try a jump wire from battery to starter if it engages then replace battery feed wire tostarter

×

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 71 Answers

SOURCE: 79 chevy luv, starter wont engage

Replace the cylinoid switch

Posted on Jan 03, 2009

  • 7 Answers

SOURCE: 1997 chevy 4.3 1500 will not start.

If all cables and battery check out....make sure you have a good ground. If that is all good you need to check if you are getting battery voltage down to the solenoid with the key in the start position. If not most likely it's the ignition switch...if voltage is ok check connections at starter and again make sure ground is good. You should see battery voltage at the solenoid when the key is in the start position....at the battery cable and the smaller wire on the solenoid. If all checks out and still no-start...you need a starter.

Posted on Feb 20, 2009

  • 79 Answers

SOURCE: no power to starter 2004 chevy tahoe

Hi
It could be your neutral safety switch. It could be the starter relay which is located in the fuse panel box. It could be the smaller wire going to the starter could be loose or corroded.

Posted on Apr 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Starter clicks but will not turn engine over on 2004 Dodge Durango. New starter and battery.


Hi Mark
Sounds like you are doing all the right things.
We used to Load Test a Starter Motor by putting it in a Large Vice and connecting a known good battery with solid fat jumper leads.
When the solenoid throws the cog forward to engage we would use a 2 by 4 block of wood levered against the cog to try and stop the starter from spinning. The wood burns up under load but it quickly proves the Starter is functioning under load. Without using the engine.
Also you could try removing the spark plugs on the engine to allow the compression to escape. Make sure NO sparks around to ignite any fuel vapor.
The engine should spin over easily like this and you can hear & see if anything is binding up.
Hope this Helps!
Good luck!

Mar 03, 2015 | 2004 Dodge Durango

1 Answer

Starter issues


You have bought a faulty Starter, Replace it

Dec 18, 2013 | Cars & Trucks

2 Answers

2000 c2500 starter cranks without ignition key on


I think that you have a defective starter solenoid, this the part that is mounted to the top of the starter.

Mar 30, 2017 | Chevrolet C2500 Cars & Trucks

1 Answer

Hi, have a toyota avalon, tried starting the car , it won't start, but then the starter engaged and won't turn off evenwithout the key, disconnected the battery and it stopped , when the batte


It sounds like you have a bad actuator. This is attached to the starter and has a solonoid that pushes the starter motor gears into the engine gear. If the solonoid is faulty this may happen. Also check alignment of the same.

Mar 18, 2012 | 1999 Toyota Avalon

1 Answer

2003 dyna starter turns but wont engage, new battery fitted


Hi Anonymous, lift up rubber boot on positive cable to starter, unplug starter relay wire usually green, with a jumper wire connected to positive battery cable starter stud, touch blade connecter on starter where starter relay wire was removed. If starter engages and turns over engine then your starter relay is bad. If starter activates but does not engage then your starter drive/clutch is bad. Good luck

Jan 22, 2012 | Cars & Trucks

1 Answer

I replaced the starter on a 1994 toyota camry. Everything appears to be reconnected correctly, but all I can year when I turn the key is the sound of the starter turning. I assume it isn't engaging...


when the ignition switch is turned to the starting postion the motor should turn over if it dont then the starter is either not installed properly or the starter drive is sticking or bad if the starter is not engaging with the flywheel there could be a good chance that the teeth on the flywheel are broke off. i would pull the starter back off and use a mirror to check the teeth on the flywheel.

Dec 13, 2010 | 1994 Toyota Camry

1 Answer

1997 Ford E150 4.2L Start troubles


The transmission range sensor , park neutral safety switch . Is fuse #23 60 amp in the engine bay fuse block good ?

Mar 10, 2017 | 1984 Ford Econoline

2 Answers

95 F150 wont crank


the starter should be replaced. The solenoid is kikcing the pinion out but there is no contact being made to turn the starter motor. I have the exact same truck and before i changed the starter used the old starter tap trick. Tap the starter casing with a hammer and it should start turning again. hope this was helpful for you. Good luck.

Sep 16, 2008 | 1995 Ford F150 Styleside Regular Cab

1 Answer

Clutch Adjustment the problem?


If the starter is good but does not engage then you may have a bad starter solenoid. This is a seperate component which send the electrical pulse to the starter. This is actually what you will hear click and not the starter itself.

Jul 15, 2008 | 2002 Ford Escape

Not finding what you are looking for?
1995 Chevrolet C1500 Logo

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...