Question about Cars & Trucks

1 Answer

07 tahioe z71 has engine code p0976

Cleared code once and it lasted for about 400 miles then came back on. I changed the oil/filter again to see if there was a loose connection, didn't find one. have the same problem

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 34 Answers

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 225 Answers

SOURCE: oil light on 99' Jetta TDI

Hi,
The "oil light" is actually a "low oil pressure" light, and not a "low oil level" light. I would get it checked out at a garage asap.
Did they change the filter at the same time? D

Posted on Aug 15, 2008

  • 66 Answers

SOURCE: O2 sensor problem

I have a 97 gmc sierra .This truck is the same as the chevy ok.Its a 350 5.7 liter 4x4 Z71.I took it to auto zone which was my first mistake.They put it the scanner and said bad O2 sensor.Ok so which one is it i said.They dont know.Well there four (4) O2 sensors in this truck i hope you know that.I had to replace all four of them before i had to take it to a real shop.It seems the fuel pump i replaced a week earlier with an auto zone fuel pump was bad.Ive changed my feul pump 4 times now and have 235000 miles on still running.You need to get your fuel pressure checked.It should be 65 psi to start it and 55 psi to run it.If the pressures are good it could be a different O2 sensor or maybe the mass air flow senor.My last option would be the fuel pressure regulator because it seems to be a waste of time and money.I would get that fuel pressue checked first.Good luck.

Posted on Nov 25, 2008

  • 1 Answer

SOURCE: I have an '02 jeep wrangler. Straight 6, 4.0 L

I have a 94 YJ gave me the same issues and I did all you did and more.
Finely I was told that penzoil has a parfin base which lends it self to the cause. I don't know if it is true or not I'm just a shade tree mech. I switched over to full synthetic and WA-LA It took a couple of changes after a good cleaning but I've been TICK free for a over a year now. since I do my own change it helps hold the cost down. I was also told I needed lifters and a rebuild & all that jazz so I figured that if she was gona die I'd deal with that when it happens so far so good.

Posted on Oct 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ck engine light on again..


Have your dealer look up this service bulletin.
NUMBER: 18-037-11
GROUP: Vehicle Performance
DATE: August 02, 2011
It states your PCM needs reprogrammed with the error code you are receiving P06DE. Was a pretty common problem back then.

Mar 24, 2015 | 2011 Dodge Avenger Heat

4 Answers

My 07 tahoe has no oil pressure ive drove it 10 mile to get homeit still runs good but still not showing any oil pressure


Hello, if your engine did not have oil pressure , I doubt you could drive it ten miles. I think you should check your oil pressure with an auxiliary pressure gauge. More than likely you might only need a new oil sending unit.

Mar 15, 2015 | 2007 Chevrolet Tahoe

2 Answers

I just had the oil changed in my '07 g6. The display said it still had 48% oil life left, but it was close to 6 months since the last oil change. The shop said I should have my 'fluids changed', and he...


You need to educate yourself, as to a vehicles preventative maintainance needs

Listen to what your being told,ask questions, then do some research, on what you have been told

We will give you some advice,once you get onboard with what your vehicle requires

Nov 12, 2010 | 2007 Pontiac G6 GT Convertible

1 Answer

Just recently got a 2000 Cadillac Seville SLS with 58,000 miles. It was my late aunts. It pretty much sat in her driveway for a couple of years. Very limited use. I started to drive it and it ran great....


Findout the code. You Said It's Realated To The Transmission I Just Pick Mine Up For What I Belive Is The Samething The Tcc & The Code Is P1860 Thats The Tourque Converter Circuit! You Should Getit Changed Because It'll Save You Gas Pluse Less Tress On The Transmission & Engine & Could Cause Gear **** Stall !
4_4_2012_4_32_20_am.jpg

Oct 15, 2010 | 2000 Cadillac Seville

2 Answers

How often should I change the Transmission fluid, normal driving ? Thank you Gary


It's listed in your owner's manual. Schedule A is normal driving conditions.
SCHEDULE "A"
7,500 miles (12 000km) or at 6 months
- Change engine oil.
- Replace engine oil filter.

15,000 miles (24 000km) or at 12 months
- Change engine oil.
- Replace engine oil filter.

22,500 miles (36 000km) or at 18 months
- Change engine oil.
- Replace engine oil filter.
- Inspect front wheel bearings.
- Inspect brake linings.

30,000 miles (48 000km) or at 24 months
- Change engine oil.
- Replace engine oil filter.
- Replace engine air cleaner filter.
- Replace spark plugs.
- Drain and refill automatic transmission fluid and filter (4.7L).

37,500 miles (60 000km) or at 30 months
- Change engine oil.
- Replace engine oil filter.
- Drain and refill automatic transmission fluid and filter (5.2L/5.9L).
- Drain and refill transfer case fluid.

45,000 miles (72 000km) or at 36 months
- Change engine oil.
- Replace engine oil filter.
- Inspect front wheel bearings.
- Inspect brake linings.
- Flush and replace engine coolant at 36 months, regardless of mileage.

52,500 miles (84 000km) or at 42 months
- Change engine oil.
- Replace engine oil filter.
- Flush and replace engine coolant if not done at 46 months.

60,000 miles (96 000km) or at 48 months
- Change engine oil.
- Replace engine oil filter.
- Replace engine air cleaner filter.
- Replace ignition cables (5.2L/5.9L).
- Inspect PCV valve, replace as necessary.
- Replace spark plugs.
- Inspect auto tension drive belt and replace as necessary (5.2L/5.9L).
- Drain and refill automatic transmission fluid (4.7L).

67,500 miles (108 000km) or at 54 months
- Change engine oil.
- Replace engine oil filter.
- Inspect front wheel bearings.
- Inspect brake linings.

75,000 miles (120 000km) or at 60 months
- Change engine oil.
- Replace engine oil filter.
- Drain and refill automatic transmission fluid and filter (5.2L/5.9L).
- Drain and refill transfer case.
- Flush and replace engine coolant if it has been 30,000miles (48 000km) or 24 months since last change.
- Inspect auto tension drive belt and replace if required.

82,500 miles (132 000km) or at 66 months
- Change engine oil.
- Replace engine oil filter.
- Flush and replace engine coolant if it has been 30,000miles (48 000km) or 24 months since last change.

90,000 miles (144 000km) or at 72 months
- Change engine oil.
- Replace engine oil filter.
- Replace engine air cleaner filter.
- Replace spark plugs.
- Inspect front wheel bearings.
- Inspect brake linings.
- Inspect auto tension drive belt and replace as necessary.
- Drain and refill automatic transmission fluid (4.7L).

97,500 miles (156 000km) or at 78 months
- Change engine oil.
- Replace engine oil filter.

105,000 miles (168 000km) or at 84 months
- Change engine oil.
- Replace engine oil filter.
- Flush and replace engine coolant if it has been 30,000 miles (48 000km) or 24 months since last change.
- Inspect auto tension drive belt and replace if required.

112,500 miles (181 000km) or at 90 months
- Change engine oil.
- Replace engine oil filter.
- Drain and refill automatic transmission fluid and filter (5.2L/5.9L).
- Inspect front wheel bearings.
- Inspect brake linings.
- Flush and replace engine coolant if it has been 30,000 miles (48 000km) or 24 months since last change.

120,000 miles (192 000km) or at 96 months
- Change engine oil.
- Replace engine oil filter.
- Replace engine air cleaner filter.
- Replace ignition cables (5.2L/5.9L).
- Inspect PCV valve, replace as necessary.
- Replace spark plugs.
- Inspect auto tension drive belt and replace as necessary.
- Drain and refill automatic transmission fluid (4.7L).

Thanks for using FixYa -a 4 THUMBS rating is appreciated for answering your FREE question.

Sep 05, 2010 | 2001 Dodge Durango

2 Answers

Oil light goes on...had a dry stick 4 1/2 qts put in. no oil on ground. after oil change light went on at 70 miles.. on 15 secs then off for 5 miles then on again 15 secs--- off 4 miles--off 3 miles- off 2...


if it's not going onto the ground, and it's not being burned, check the positive crankcase ventilation and the exhaust gas recirculation valves for oil seepage...also check your air filter, if its got oil on it replace the pcv valve.

Jun 19, 2009 | 2003 Volkswagen Jetta TDI

1 Answer

Check Engine Light, VSC and Traction Control Off Light, came on after oil and filter change


obviously they did disconnect a sensor while they were working on your vehicle.this will set a code in your vehicle's computer.They call this a soft code since there was not a failure but it just did not sense a signal.After reconnecting it clears the code after so many ignition cycles,meaning turning the key on and off so many times.The code is stored in the computer so it would be a good idea to take it to the dealer to check it out and make sure there are no other problems

May 25, 2009 | 2006 Toyota Sienna

3 Answers

Have a 1990 Z71 4wd that with loud engine knock.


I'd consider some fresh, clean oil & filter change first of all, if it hasn't been done . drive it for a while providing it isn't too bad, & see if it goes away, if not get back to us.

May 18, 2009 | 1990 Chevrolet C1500

1 Answer

Jeep liberty gas mileage


when was the last time you put in fuel injector cleaner? I put in Lucas Oil Injector cleaner every other or every oil change.

There are alot of factors affecting your gas mileage. Tire wear, tire pressure, wheel alignment, air filter, fuel filter, spark plugs, oxygen sensors, just to name a few. So to say what you need is just shooting in the dark without more information. I would probably start with your oxygen sensors, and then perform a tuneup. If your vehicle pulls to one side or the other when driving on the highway you need to stop into the shop for a wheel alignment.

Nov 24, 2008 | 2005 Jeep Liberty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...