Question about 2002 Ford SVT Focus

Open Question

Remove back seat of 2002 ford focus se - 2002 Ford SVT Focus

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 21 Answers

SOURCE: Focus timing belt replacement.

This is a very very easy timing belt setup. first off you have to remove the valve cover. Then you have to remove the serp belt. Then remove anything thats in your way of the front cover. after you remove the crank pulley re-install the crank bolt. DO NOT LOSEN THE BOLT FOR THE TENSIONER!!!! now spin the crankshaft until the sproket aligns with the timing mark. now at this point the two camshafts should be aligned. now there is a special tool from ford that holds the cam shafts in place. all it is is a 1/4" peice of metal that goes on the left side of the cam shafts to hold them into place. if you mark the cams you wont need the tool. or if you can find something to fit in the left side of the cams that will work too. anyways after that its just the same steps in reverse. very easy to do.

Posted on Aug 31, 2009

Ad
johnjohn2
  • 5763 Answers

SOURCE: were to find a2001 ford focus se water pump and pully diagram

i hope this is what your looking for.heres a diagram of the waterpump and pulleys, waterpump is driven by the timing belt, hope this helps.24ad9c3.gif

Posted on Jan 28, 2010

jasmoy89
  • 91 Answers

SOURCE: looking for firing order diagram for 2002 ford

2.0L SOHC 92725092.gif
2.0L DOHC

92714651.gif

Posted on Jul 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

CAR FLOODED, REPLACED MAS, SPARK PLUGS, FUEL FILTER, FLUIDS, AND FUEL PUMP DRIVEER MODULE...CAR NOW STARTS BUT VERY ROUGH IDLE AND DIES OUT IF YOU DONT KEEP FOOT ON THE GAS


remove and clean the idle sensor valve. pull out and clean the PCV valve (on top of the valve cover).blow out (from the inside) the air filter. do not apply gas until after your vehicle starts.

Apr 06, 2017 | 2002 Ford Focus

1 Answer

Locating the engine speed sensor on my 2002 ford focus se 2.0 SPI engine


Where is the speed sensor located on a 2003 ford focus 2.0L s.o.h.c. Se model?

Dec 30, 2012 | Cars & Trucks

1 Answer

2002 Ford Focus SE. Low beams won't go on sometimes. Hi beams work no problem. Turn back to low, they stay on for a few seconds then turn off. Should I be looking at the headlight switch on the da


I would start at the headlight switch check your ground wires and connections at the light themselves also check the bright dim switch

Aug 27, 2012 | 2002 Ford Focus

1 Answer

Reset radio code for '02 ford focus


Hi,

You can get this code from the dealer but they will charge you between £20 to £35 for doing this.

I can confidently recommend this site that does these codes for £3.50. They specialise in Ford radios only. Cheap, quick and always reliable. I've used it myself on several occassions without a problem. Click Here.

Hope this helps. Thanks for using FixYa

Jan 27, 2010 | 2002 Ford SVT Focus

1 Answer

I have a ford focus se 2002


No it sounds like your water pump bearing has worn causing the leak.Change the water pump.

Jul 03, 2009 | 2002 Ford SVT Focus

1 Answer

I guess it has something to do with my charging system


sounds like defective alternator. ck output voltage on back of alt. should be 13.25 or more

Apr 14, 2009 | 2002 Ford SVT Focus

1 Answer

Back truck latch wont release


Metal holding metal keeps your seat in the upright position, Please don't start chopping away at your seats, I may want to go to the dealer and see what they can do -new key or new fob. You will hate your self if you ruin your back seat. Sometimes tow truck guys know secrets on how to unlock cars.

Mar 29, 2009 | 2000 Ford Focus

1 Answer

Cd player removal


At the auto parts store, you can find a radio removal tool. It consists of two U-shaped metal bars. The intent is to insert the metal bars into the four holes on the front of the radio. When you pry the bars out, they release the clips that hold the radio in. I have heard of this proceedure being done with a coat hanger, but I have not tried it myself.

Jul 31, 2008 | 2002 Ford SVT Focus

Not finding what you are looking for?
2002 Ford SVT Focus Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...